| Chin Liang See | cca9f45 | 2013-12-30 18:26:14 -0600 | [diff] [blame] | 1 | |
| 2 | -------------------------------------------- |
| 3 | SOCFPGA Documentation for U-Boot and SPL |
| 4 | -------------------------------------------- |
| 5 | |
| 6 | This README is about U-Boot and SPL support for Altera's ARM Cortex-A9MPCore |
| 7 | based SOCFPGA. To know more about the hardware itself, please refer to |
| 8 | www.altera.com. |
| 9 | |
| 10 | |
| 11 | -------------------------------------------- |
| 12 | socfpga_dw_mmc |
| 13 | -------------------------------------------- |
| 14 | Here are macro and detailed configuration required to enable DesignWare SDMMC |
| 15 | controller support within SOCFPGA |
| 16 | |
| 17 | #define CONFIG_MMC |
| 18 | -> To enable the SD MMC framework support |
| 19 | |
| 20 | #define CONFIG_SDMMC_BASE (SOCFPGA_SDMMC_ADDRESS) |
| 21 | -> The base address of CSR register for DesignWare SDMMC controller |
| 22 | |
| 23 | #define CONFIG_GENERIC_MMC |
| 24 | -> Enable the generic MMC driver |
| 25 | |
| 26 | #define CONFIG_SYS_MMC_MAX_BLK_COUNT 256 |
| 27 | -> Using smaller max blk cnt to avoid flooding the limited stack in OCRAM |
| 28 | |
| 29 | #define CONFIG_DWMMC |
| 30 | -> Enable the common DesignWare SDMMC controller framework |
| 31 | |
| 32 | #define CONFIG_SOCFPGA_DWMMC |
| 33 | -> Enable the SOCFPGA specific driver for DesignWare SDMMC controller |
| 34 | |
| 35 | #define CONFIG_SOCFPGA_DWMMC_FIFO_DEPTH 1024 |
| 36 | -> The FIFO depth for SOCFPGA DesignWare SDMMC controller |
| 37 | |
| 38 | #define CONFIG_SOCFPGA_DWMMC_DRVSEL 3 |
| 39 | -> Phase-shifted clock of sdmmc_clk for controller to drive command and data to |
| 40 | the card to meet hold time requirements. SD clock is running at 50MHz and |
| 41 | drvsel is set to shift 135 degrees (3 * 45 degrees). With that, the hold time |
| 42 | is 135 / 360 * 20ns = 7.5ns. |
| 43 | |
| 44 | #define CONFIG_SOCFPGA_DWMMC_SMPSEL 0 |
| 45 | -> Phase-shifted clock of sdmmc_clk used to sample the command and data from |
| 46 | the card |
| 47 | |
| 48 | #define CONFIG_SOCFPGA_DWMMC_BUS_WIDTH 4 |
| 49 | -> Bus width of data line which either 1, 4 or 8 and based on board routing. |
| 50 | |
| 51 | #define CONFIG_SOCFPGA_DWMMC_BUS_HZ 50000000 |
| 52 | -> The clock rate to controller. Do note the controller have a wrapper which |
| 53 | divide the clock from PLL by 4. |