doc/README.bitbangMII

This patch rewrites the miiphybb ( Bit-banged MII bus driver ) in order to
support an arbitrary number of mii buses. This feature is useful when your
board uses different mii buses for different phys and all (or a part) of these
buses are implemented via bit-banging mode.

The driver requires that the following macros should be defined into the board
configuration file:

CONFIG_BITBANGMII	- Enable the miiphybb driver
CONFIG_BITBANGMII_MULTI - Enable the multi bus support

If the CONFIG_BITBANGMII_MULTI is not defined, the board's config file needs
to define at least the following macros:

MII_INIT      - Generic code to enable the MII bus (optional)
MDIO_DECLARE  - Declaration needed to access to the MDIO pin (optional)
MDIO_ACTIVE   - Activate the MDIO pin as out pin
MDIO_TRISTATE - Activate the MDIO pin as input/tristate pin
MDIO_READ     - Read the MDIO pin
MDIO(v)       - Write v on the MDIO pin
MDC_DECLARE   - Declaration needed to access to the MDC pin (optional)
MDC(v)	      - Write v on the MDC pin

The previous macros make the driver compatible with the previous version
(that didn't support the multi-bus).

When the CONFIG_BITBANGMII_MULTI is also defined, the board code needs to fill
the bb_miiphy_buses[] array with a record for each required bus and declare
the bb_miiphy_buses_num variable with the number of mii buses.
The record (struct bb_miiphy_bus) has the following fields/callbacks (see
miiphy.h for details):

char name[]	       - The symbolic name that must be equal to the MII bus
			 registered name
int (*init)()	       - Initialization function called at startup time (just
			 before the Ethernet initialization)
int (*mdio_active)()   - Activate the MDIO pin as output
int (*mdio_tristate)() - Activate the MDIO pin as input/tristate pin
int (*set_mdio)()      - Write the MDIO pin
int (*get_mdio)()      - Read the MDIO pin
int (*set_mdc)()       - Write the MDC pin
int (*delay)()	       - Delay function
void *priv	       - Private data used by board specific code

The board code will look like:

struct bb_miiphy_bus bb_miiphy_buses[] = {
 { .name = "miibus#1", .init = b1_init, .mdio_active = b1_mdio_active, ... },
 { .name = "miibus#2", .init = b2_init, .mdio_active = b2_mdio_active, ... },
 ...
};
int bb_miiphy_buses_num = sizeof(bb_miiphy_buses) /
			  sizeof(bb_miiphy_buses[0]);

2009 Industrie Dial Face S.p.A.
     Luigi 'Comio' Mantellini <luigi.mantellini@idf-hit.com>