blob: d6f6d1ac5743744326a557a943c32f411dc87bb7 [file] [log] [blame]
Tom Rini10e47792018-05-06 17:58:06 -04001/* SPDX-License-Identifier: GPL-2.0+ */
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +05302/*
3 * (C) Copyright 2009
4 * Marvell Semiconductor <www.marvell.com>
5 * Written-by: Prafulla Wadaskar <prafulla@marvell.com>
6 *
7 * Derived from drivers/spi/mpc8xxx_spi.c
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +05308 */
9
10#ifndef __KW_SPI_H__
11#define __KW_SPI_H__
12
13/* SPI Registers on kirkwood SOC */
14struct kwspi_registers {
15 u32 ctrl; /* 0x10600 */
16 u32 cfg; /* 0x10604 */
17 u32 dout; /* 0x10608 */
18 u32 din; /* 0x1060c */
19 u32 irq_cause; /* 0x10610 */
20 u32 irq_mask; /* 0x10614 */
Stefan Roese20d1d662016-02-12 13:52:17 +010021 u32 timing1; /* 0x10618 */
22 u32 timing2; /* 0x1061c */
23 u32 dw_cfg; /* 0x10620 - Direct Write Configuration */
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +053024};
25
Valentin Longchampdb22ce72012-06-01 01:31:02 +000026/* They are used to define CONFIG_SYS_KW_SPI_MPP
27 * each of the below #defines selects which mpp is
28 * configured for each SPI signal in spi_claim_bus
29 * bit 0: selects pin for MOSI (MPP1 if 0, MPP6 if 1)
30 * bit 1: selects pin for SCK (MPP2 if 0, MPP10 if 1)
31 * bit 2: selects pin for MISO (MPP3 if 0, MPP11 if 1)
32 */
33#define MOSI_MPP6 (1 << 0)
34#define SCK_MPP10 (1 << 1)
35#define MISO_MPP11 (1 << 2)
36
Stefan Roese90b499a2016-02-11 11:37:38 +010037/* Control Register */
38#define KWSPI_CSN_ACT (1 << 0) /* Activates serial memory interface */
39#define KWSPI_SMEMRDY (1 << 1) /* SerMem Data xfer ready */
40#define KWSPI_CS_SHIFT 2 /* chip select shift */
41#define KWSPI_CS_MASK 0x7 /* chip select mask */
42
43/* Configuration Register */
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +053044#define KWSPI_CLKPRESCL_MASK 0x1f
Valentin Longchampbaddd9f2012-08-15 05:31:49 +000045#define KWSPI_CLKPRESCL_MIN 0x12
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +053046#define KWSPI_XFERLEN_1BYTE 0
47#define KWSPI_XFERLEN_2BYTE (1 << 5)
48#define KWSPI_XFERLEN_MASK (1 << 5)
49#define KWSPI_ADRLEN_1BYTE 0
Stefan Roese4c653e42014-09-02 14:02:50 +020050#define KWSPI_ADRLEN_2BYTE (1 << 8)
51#define KWSPI_ADRLEN_3BYTE (2 << 8)
52#define KWSPI_ADRLEN_4BYTE (3 << 8)
53#define KWSPI_ADRLEN_MASK (3 << 8)
Chris Packham21c3dca2016-10-27 21:16:05 +130054#define KWSPI_CPOL (1 << 11)
55#define KWSPI_CPHA (1 << 12)
56#define KWSPI_TXLSBF (1 << 13)
57#define KWSPI_RXLSBF (1 << 14)
Stefan Roese90b499a2016-02-11 11:37:38 +010058
Chris Packham479588d2018-01-22 22:44:20 +130059/* Timing Parameters 1 Register */
60#define KW_SPI_TMISO_SAMPLE_OFFSET 6
61#define KW_SPI_TMISO_SAMPLE_MASK (0x3 << KW_SPI_TMISO_SAMPLE_OFFSET)
62#define KW_SPI_TMISO_SAMPLE_1 (1 << KW_SPI_TMISO_SAMPLE_OFFSET)
63#define KW_SPI_TMISO_SAMPLE_2 (2 << KW_SPI_TMISO_SAMPLE_OFFSET)
64
Stefan Roese90b499a2016-02-11 11:37:38 +010065#define KWSPI_IRQUNMASK 1 /* unmask SPI interrupt */
66#define KWSPI_IRQMASK 0 /* mask SPI interrupt */
67#define KWSPI_SMEMRDIRQ 1 /* SerMem data xfer ready irq */
68
Prafulla Wadaskar1fd6a9b2009-05-30 01:13:33 +053069#define KWSPI_TIMEOUT 10000
70
71#endif /* __KW_SPI_H__ */