Peng Fan | b72606c | 2022-07-26 16:41:10 +0800 | [diff] [blame] | 1 | // SPDX-License-Identifier: GPL-2.0+ |
| 2 | /* |
| 3 | * Copyright 2022 NXP |
| 4 | */ |
| 5 | |
| 6 | #include <common.h> |
| 7 | #include <command.h> |
| 8 | #include <cpu_func.h> |
| 9 | #include <hang.h> |
| 10 | #include <image.h> |
| 11 | #include <init.h> |
| 12 | #include <log.h> |
| 13 | #include <spl.h> |
| 14 | #include <asm/global_data.h> |
| 15 | #include <asm/io.h> |
| 16 | #include <asm/arch/imx93_pins.h> |
| 17 | #include <asm/arch/clock.h> |
| 18 | #include <asm/arch/sys_proto.h> |
| 19 | #include <asm/mach-imx/boot_mode.h> |
| 20 | #include <asm/mach-imx/mxc_i2c.h> |
| 21 | #include <asm/arch-mx7ulp/gpio.h> |
| 22 | #include <asm/mach-imx/syscounter.h> |
| 23 | #include <asm/mach-imx/s400_api.h> |
| 24 | #include <dm/uclass.h> |
| 25 | #include <dm/device.h> |
| 26 | #include <dm/uclass-internal.h> |
| 27 | #include <dm/device-internal.h> |
| 28 | #include <linux/delay.h> |
| 29 | #include <asm/arch/clock.h> |
| 30 | #include <asm/arch/ccm_regs.h> |
| 31 | #include <asm/arch/ddr.h> |
| 32 | #include <power/pmic.h> |
| 33 | #include <power/pca9450.h> |
| 34 | #include <asm/arch/trdc.h> |
| 35 | |
| 36 | DECLARE_GLOBAL_DATA_PTR; |
| 37 | |
| 38 | int spl_board_boot_device(enum boot_device boot_dev_spl) |
| 39 | { |
| 40 | return BOOT_DEVICE_BOOTROM; |
| 41 | } |
| 42 | |
| 43 | void spl_board_init(void) |
| 44 | { |
| 45 | puts("Normal Boot\n"); |
| 46 | } |
| 47 | |
| 48 | void spl_dram_init(void) |
| 49 | { |
| 50 | ddr_init(&dram_timing); |
| 51 | } |
| 52 | |
| 53 | #if CONFIG_IS_ENABLED(DM_PMIC_PCA9450) |
| 54 | int power_init_board(void) |
| 55 | { |
| 56 | struct udevice *dev; |
| 57 | int ret; |
| 58 | |
| 59 | ret = pmic_get("pmic@25", &dev); |
| 60 | if (ret == -ENODEV) { |
| 61 | puts("No pca9450@25\n"); |
| 62 | return 0; |
| 63 | } |
| 64 | if (ret != 0) |
| 65 | return ret; |
| 66 | |
| 67 | /* BUCKxOUT_DVS0/1 control BUCK123 output */ |
| 68 | pmic_reg_write(dev, PCA9450_BUCK123_DVS, 0x29); |
| 69 | |
Peng Fan | 513d508 | 2023-04-28 12:08:35 +0800 | [diff] [blame] | 70 | /* enable DVS control through PMIC_STBY_REQ */ |
| 71 | pmic_reg_write(dev, PCA9450_BUCK1CTRL, 0x59); |
| 72 | |
| 73 | if (IS_ENABLED(CONFIG_IMX9_LOW_DRIVE_MODE)) { |
| 74 | /* 0.75v for Low drive mode |
| 75 | */ |
| 76 | pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS0, 0x0c); |
| 77 | pmic_reg_write(dev, PCA9450_BUCK3OUT_DVS0, 0x0c); |
| 78 | } else { |
| 79 | /* 0.9v for Over drive mode |
| 80 | */ |
| 81 | pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS0, 0x18); |
| 82 | pmic_reg_write(dev, PCA9450_BUCK3OUT_DVS0, 0x18); |
| 83 | } |
| 84 | |
| 85 | /* set standby voltage to 0.65v */ |
| 86 | pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS1, 0x4); |
Peng Fan | b72606c | 2022-07-26 16:41:10 +0800 | [diff] [blame] | 87 | |
| 88 | /* I2C_LT_EN*/ |
| 89 | pmic_reg_write(dev, 0xa, 0x3); |
Peng Fan | b72606c | 2022-07-26 16:41:10 +0800 | [diff] [blame] | 90 | return 0; |
| 91 | } |
| 92 | #endif |
| 93 | |
| 94 | extern int imx9_probe_mu(void *ctx, struct event *event); |
| 95 | void board_init_f(ulong dummy) |
| 96 | { |
| 97 | int ret; |
| 98 | |
| 99 | /* Clear the BSS. */ |
| 100 | memset(__bss_start, 0, __bss_end - __bss_start); |
| 101 | |
| 102 | timer_init(); |
| 103 | |
| 104 | arch_cpu_init(); |
| 105 | |
| 106 | board_early_init_f(); |
| 107 | |
| 108 | spl_early_init(); |
| 109 | |
| 110 | preloader_console_init(); |
| 111 | |
| 112 | ret = imx9_probe_mu(NULL, NULL); |
| 113 | if (ret) { |
| 114 | printf("Fail to init Sentinel API\n"); |
| 115 | } else { |
| 116 | printf("SOC: 0x%x\n", gd->arch.soc_rev); |
| 117 | printf("LC: 0x%x\n", gd->arch.lifecycle); |
| 118 | } |
Peng Fan | 513d508 | 2023-04-28 12:08:35 +0800 | [diff] [blame] | 119 | |
Peng Fan | b72606c | 2022-07-26 16:41:10 +0800 | [diff] [blame] | 120 | power_init_board(); |
| 121 | |
Peng Fan | 513d508 | 2023-04-28 12:08:35 +0800 | [diff] [blame] | 122 | if (!IS_ENABLED(CONFIG_IMX9_LOW_DRIVE_MODE)) |
| 123 | set_arm_clk(get_cpu_speed_grade_hz()); |
Peng Fan | 10fde4e | 2022-07-26 16:41:11 +0800 | [diff] [blame] | 124 | |
Peng Fan | b72606c | 2022-07-26 16:41:10 +0800 | [diff] [blame] | 125 | /* Init power of mix */ |
| 126 | soc_power_init(); |
| 127 | |
| 128 | /* Setup TRDC for DDR access */ |
| 129 | trdc_init(); |
| 130 | |
| 131 | /* DDR initialization */ |
| 132 | spl_dram_init(); |
| 133 | |
| 134 | /* Put M33 into CPUWAIT for following kick */ |
| 135 | ret = m33_prepare(); |
| 136 | if (!ret) |
| 137 | printf("M33 prepare ok\n"); |
| 138 | |
| 139 | board_init_r(NULL, 0); |
| 140 | } |