| Tom Rini | 53633a8 | 2024-02-29 12:33:36 -0500 | [diff] [blame] | 1 | // SPDX-License-Identifier: GPL-2.0-or-later |
| 2 | /* |
| 3 | * DTS file for all SPEAr1340 SoCs |
| 4 | * |
| 5 | * Copyright 2012 Viresh Kumar <vireshk@kernel.org> |
| 6 | */ |
| 7 | |
| 8 | /include/ "spear13xx.dtsi" |
| 9 | |
| 10 | / { |
| 11 | compatible = "st,spear1340"; |
| 12 | |
| 13 | ahb { |
| 14 | |
| 15 | spics: spics@e0700000 { |
| 16 | compatible = "st,spear-spics-gpio"; |
| 17 | reg = <0xe0700000 0x1000>; |
| 18 | st-spics,peripcfg-reg = <0x42c>; |
| 19 | st-spics,sw-enable-bit = <21>; |
| 20 | st-spics,cs-value-bit = <20>; |
| 21 | st-spics,cs-enable-mask = <3>; |
| 22 | st-spics,cs-enable-shift = <18>; |
| 23 | gpio-controller; |
| 24 | #gpio-cells = <2>; |
| 25 | status = "disabled"; |
| 26 | }; |
| 27 | |
| 28 | miphy0: miphy@eb800000 { |
| 29 | compatible = "st,spear1340-miphy"; |
| 30 | reg = <0xeb800000 0x4000>; |
| 31 | misc = <&misc>; |
| 32 | #phy-cells = <1>; |
| 33 | status = "disabled"; |
| 34 | }; |
| 35 | |
| 36 | ahci0: ahci@b1000000 { |
| 37 | compatible = "snps,spear-ahci"; |
| 38 | reg = <0xb1000000 0x10000>; |
| 39 | interrupts = <0 72 0x4>; |
| 40 | phys = <&miphy0 0>; |
| 41 | phy-names = "sata-phy"; |
| 42 | status = "disabled"; |
| 43 | }; |
| 44 | |
| 45 | pcie0: pcie@b1000000 { |
| 46 | compatible = "st,spear1340-pcie", "snps,dw-pcie"; |
| 47 | reg = <0xb1000000 0x4000>, <0x80000000 0x20000>; |
| 48 | reg-names = "dbi", "config"; |
| 49 | interrupts = <0 68 0x4>; |
| 50 | num-lanes = <1>; |
| 51 | phys = <&miphy0 1>; |
| 52 | phy-names = "pcie-phy"; |
| 53 | #address-cells = <3>; |
| 54 | #size-cells = <2>; |
| 55 | device_type = "pci"; |
| 56 | ranges = <0x81000000 0 0 0x80020000 0 0x00010000 /* downstream I/O */ |
| 57 | 0x82000000 0 0x80030000 0xc0030000 0 0x0ffd0000>; /* non-prefetchable memory */ |
| 58 | bus-range = <0x00 0xff>; |
| 59 | status = "disabled"; |
| 60 | }; |
| 61 | |
| 62 | i2s-play@b2400000 { |
| 63 | compatible = "snps,designware-i2s"; |
| 64 | reg = <0xb2400000 0x10000>; |
| 65 | interrupt-names = "play_irq"; |
| 66 | interrupts = <0 98 0x4>, |
| 67 | <0 99 0x4>; |
| 68 | play; |
| 69 | channel = <8>; |
| 70 | status = "disabled"; |
| 71 | }; |
| 72 | |
| 73 | i2s-rec@b2000000 { |
| 74 | compatible = "snps,designware-i2s"; |
| 75 | reg = <0xb2000000 0x10000>; |
| 76 | interrupt-names = "record_irq"; |
| 77 | interrupts = <0 100 0x4>, |
| 78 | <0 101 0x4>; |
| 79 | record; |
| 80 | channel = <8>; |
| 81 | status = "disabled"; |
| 82 | }; |
| 83 | |
| 84 | pinmux: pinmux@e0700000 { |
| 85 | compatible = "st,spear1340-pinmux"; |
| 86 | reg = <0xe0700000 0x1000>; |
| 87 | #gpio-range-cells = <3>; |
| 88 | }; |
| 89 | |
| 90 | pwm: pwm@e0180000 { |
| 91 | compatible = "st,spear13xx-pwm"; |
| 92 | reg = <0xe0180000 0x1000>; |
| 93 | #pwm-cells = <2>; |
| 94 | status = "disabled"; |
| 95 | }; |
| 96 | |
| 97 | spdif-in@d0100000 { |
| 98 | compatible = "st,spdif-in"; |
| 99 | reg = < 0xd0100000 0x20000 |
| 100 | 0xd0110000 0x10000 >; |
| 101 | interrupts = <0 84 0x4>; |
| 102 | status = "disabled"; |
| 103 | }; |
| 104 | |
| 105 | spdif-out@d0000000 { |
| 106 | compatible = "st,spdif-out"; |
| 107 | reg = <0xd0000000 0x20000>; |
| 108 | interrupts = <0 85 0x4>; |
| 109 | status = "disabled"; |
| 110 | }; |
| 111 | |
| 112 | spi1: spi@5d400000 { |
| 113 | compatible = "arm,pl022", "arm,primecell"; |
| 114 | reg = <0x5d400000 0x1000>; |
| 115 | #address-cells = <1>; |
| 116 | #size-cells = <0>; |
| 117 | interrupts = <0 99 0x4>; |
| 118 | status = "disabled"; |
| 119 | }; |
| 120 | |
| 121 | apb { |
| 122 | i2c1: i2c@b4000000 { |
| 123 | #address-cells = <1>; |
| 124 | #size-cells = <0>; |
| 125 | compatible = "snps,designware-i2c"; |
| 126 | reg = <0xb4000000 0x1000>; |
| 127 | interrupts = <0 104 0x4>; |
| 128 | write-16bit; |
| 129 | status = "disabled"; |
| 130 | }; |
| 131 | |
| 132 | serial@b4100000 { |
| 133 | compatible = "arm,pl011", "arm,primecell"; |
| 134 | reg = <0xb4100000 0x1000>; |
| 135 | interrupts = <0 105 0x4>; |
| 136 | status = "disabled"; |
| 137 | dmas = <&dwdma0 13 0 1>, |
| 138 | <&dwdma0 12 1 0>; |
| 139 | dma-names = "rx", "tx"; |
| 140 | }; |
| 141 | |
| 142 | thermal@e07008c4 { |
| 143 | st,thermal-flags = <0x2a00>; |
| 144 | }; |
| 145 | |
| 146 | gpiopinctrl: gpio@e2800000 { |
| 147 | compatible = "st,spear-plgpio"; |
| 148 | reg = <0xe2800000 0x1000>; |
| 149 | interrupts = <0 107 0x4>; |
| 150 | #interrupt-cells = <1>; |
| 151 | interrupt-controller; |
| 152 | gpio-controller; |
| 153 | #gpio-cells = <2>; |
| 154 | gpio-ranges = <&pinmux 0 0 252>; |
| 155 | status = "disabled"; |
| 156 | |
| 157 | st-plgpio,ngpio = <250>; |
| 158 | st-plgpio,wdata-reg = <0x40>; |
| 159 | st-plgpio,dir-reg = <0x00>; |
| 160 | st-plgpio,ie-reg = <0x80>; |
| 161 | st-plgpio,rdata-reg = <0x20>; |
| 162 | st-plgpio,mis-reg = <0xa0>; |
| 163 | st-plgpio,eit-reg = <0x60>; |
| 164 | }; |
| 165 | }; |
| 166 | }; |
| 167 | }; |