| Tom Rini | 53633a8 | 2024-02-29 12:33:36 -0500 | [diff] [blame] | 1 | NXP LPC32xx SoC NAND MLC controller |
| 2 | |
| 3 | Required properties: |
| 4 | - compatible: "nxp,lpc3220-mlc" |
| 5 | - reg: Address and size of the controller |
| 6 | - interrupts: The NAND interrupt specification |
| 7 | - gpios: GPIO specification for NAND write protect |
| 8 | |
| 9 | The following required properties are very controller specific. See the LPC32xx |
| 10 | User Manual 7.5.14 MLC NAND Timing Register (the values here are specified in |
| 11 | Hz, to make them independent of actual clock speed and to provide for good |
| 12 | accuracy:) |
| 13 | - nxp,tcea_delay: TCEA_DELAY |
| 14 | - nxp,busy_delay: BUSY_DELAY |
| 15 | - nxp,nand_ta: NAND_TA |
| 16 | - nxp,rd_high: RD_HIGH |
| 17 | - nxp,rd_low: RD_LOW |
| 18 | - nxp,wr_high: WR_HIGH |
| 19 | - nxp,wr_low: WR_LOW |
| 20 | |
| 21 | Optional subnodes: |
| 22 | - Partitions, see Documentation/devicetree/bindings/mtd/mtd.yaml |
| 23 | |
| 24 | Example: |
| 25 | |
| 26 | mlc: flash@200a8000 { |
| 27 | compatible = "nxp,lpc3220-mlc"; |
| 28 | reg = <0x200A8000 0x11000>; |
| 29 | interrupts = <11 0>; |
| 30 | #address-cells = <1>; |
| 31 | #size-cells = <1>; |
| 32 | |
| 33 | nxp,tcea-delay = <333333333>; |
| 34 | nxp,busy-delay = <10000000>; |
| 35 | nxp,nand-ta = <18181818>; |
| 36 | nxp,rd-high = <31250000>; |
| 37 | nxp,rd-low = <45454545>; |
| 38 | nxp,wr-high = <40000000>; |
| 39 | nxp,wr-low = <83333333>; |
| 40 | gpios = <&gpio 5 19 1>; /* GPO_P3 19, active low */ |
| 41 | |
| 42 | mtd0@00000000 { |
| 43 | label = "boot"; |
| 44 | reg = <0x00000000 0x00064000>; |
| 45 | read-only; |
| 46 | }; |
| 47 | |
| 48 | ... |
| 49 | |
| 50 | }; |