| Robert Marko | e4b17a7 | 2020-10-08 22:05:09 +0200 | [diff] [blame] | 1 | Qualcomm QUP SPI controller Device Tree Bindings |
| 2 | ------------------------------------------- |
| 3 | |
| 4 | Required properties: |
| 5 | - compatible : Should be "qcom,spi-qup-v1.1.1", "qcom,spi-qup-v2.1.1" |
| 6 | or "qcom,spi-qup-v2.2.1" |
| 7 | - reg : Physical base address and size of SPI registers map. |
| 8 | - clock : Clock phandle (see clock bindings for details). |
| 9 | - #address-cells : Number of cells required to define a chip select |
| 10 | address on the SPI bus. Should be set to 1. |
| 11 | - #size-cells : Should be zero. |
| 12 | - pinctrl-names : Must be "default" |
| 13 | - pinctrl-n : At least one pinctrl phandle |
| 14 | - cs-gpios : Should specify GPIOs used for chipselects. |
| 15 | The gpios will be referred to as reg = <index> in the |
| 16 | SPI child nodes. |
| 17 | |
| 18 | Optional properties: |
| 19 | - num-cs : total number of chipselects |
| 20 | |
| 21 | Example: |
| 22 | |
| 23 | blsp1_spi1: spi@78b5000 { |
| 24 | compatible = "qcom,spi-qup-v2.2.1"; |
| 25 | reg = <0x78b5000 0x600>; |
| 26 | clock = <&gcc 23>; |
| 27 | #address-cells = <1>; |
| 28 | #size-cells = <0>; |
| 29 | pinctrl-names = "spi"; |
| 30 | pinctrl-0 = <&blsp_spi0>; |
| 31 | num-cs = <2>; |
| 32 | cs-gpios = <&soc_gpios 54 GPIO_ACTIVE_HIGH>, <&soc_gpios 4 GPIO_ACTIVE_HIGH>; |
| 33 | }; |