| Bin Meng | 7557405 | 2016-02-05 19:30:11 -0800 | [diff] [blame] | 1 | How to use U-Boot on Freescale MX6UL 14x14 EVK |
| Fabio Estevam | 7391624 | 2015-09-08 14:43:12 -0300 | [diff] [blame] | 2 | ----------------------------------------------- |
| 3 | |
| Bin Meng | 7557405 | 2016-02-05 19:30:11 -0800 | [diff] [blame] | 4 | - Build U-Boot for MX6UL 14x14 EVK: |
| Fabio Estevam | 7391624 | 2015-09-08 14:43:12 -0300 | [diff] [blame] | 5 | |
| 6 | $ make mrproper |
| 7 | $ make mx6ul_14x14_evk_defconfig |
| 8 | $ make |
| 9 | |
| 10 | This will generate the SPL image called SPL and the u-boot.img. |
| 11 | |
| 12 | - Flash the SPL image into the micro SD card: |
| 13 | |
| 14 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync |
| 15 | |
| 16 | - Flash the u-boot.img image into the micro SD card: |
| 17 | |
| 18 | sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync |
| 19 | |
| 20 | - Jumper settings: |
| 21 | |
| 22 | SW601: 0 0 1 0 |
| 23 | Sw602: 1 0 |
| 24 | |
| 25 | where 0 means bottom position and 1 means top position (from the |
| 26 | switch label numbers reference). |
| 27 | |
| 28 | - Connect the USB cable between the EVK and the PC for the console. |
| 29 | (The USB console connector is the one close the push buttons) |
| 30 | |
| Bin Meng | 7557405 | 2016-02-05 19:30:11 -0800 | [diff] [blame] | 31 | - Insert the micro SD card in the board, power it up and U-Boot messages should |
| Fabio Estevam | 7391624 | 2015-09-08 14:43:12 -0300 | [diff] [blame] | 32 | come up. |