blob: 72d19e430ef8c8818028b71417593641fee647a9 [file] [log] [blame]
Andreas Bießmann1a1d61d2012-09-04 11:33:29 +00001/*
2 * Copyright (C) 2010 Atmel Corporation
3 *
4 * Copyright (C) 2012 Andreas Bießmann <andreas.devel@googlemail.com>
5 *
Wolfgang Denkd79de1d2013-07-08 09:37:19 +02006 * SPDX-License-Identifier: GPL-2.0+
Andreas Bießmann1a1d61d2012-09-04 11:33:29 +00007 */
8#include <common.h>
9
10#include <spi.h>
11#include <netdev.h>
12
13#include <asm/io.h>
14#include <asm/sdram.h>
15#include <asm/arch/clk.h>
16#include <asm/arch/gpio.h>
17#include <asm/arch/hmatrix.h>
18#include <asm/arch/mmu.h>
19#include <asm/arch/portmux.h>
20
21DECLARE_GLOBAL_DATA_PTR;
22
23struct mmu_vm_range mmu_vmr_table[CONFIG_SYS_NR_VM_REGIONS] = {
24 {
25 /* Atmel AT49BV640D 8 MiB x16 NOR flash on NCS0 */
26 .virt_pgno = CONFIG_SYS_FLASH_BASE >> PAGE_SHIFT,
27 .nr_pages = CONFIG_SYS_FLASH_SIZE >> PAGE_SHIFT,
28 .phys = (CONFIG_SYS_FLASH_BASE >> PAGE_SHIFT)
29 | MMU_VMR_CACHE_NONE,
30 }, {
31 /* Micron MT29F2G16AAD 256 MiB x16 NAND flash on NCS3 */
32 .virt_pgno = EBI_SRAM_CS3_BASE >> PAGE_SHIFT,
33 .nr_pages = EBI_SRAM_CS3_SIZE >> PAGE_SHIFT,
34 .phys = (EBI_SRAM_CS3_BASE >> PAGE_SHIFT)
35 | MMU_VMR_CACHE_NONE,
36 }, {
37 /* 2x16-bit ISSI IS42S16320B 64 MiB SDRAM (128 MiB total) */
38 .virt_pgno = CONFIG_SYS_SDRAM_BASE >> PAGE_SHIFT,
39 .nr_pages = EBI_SDRAM_SIZE >> PAGE_SHIFT,
40 .phys = (CONFIG_SYS_SDRAM_BASE >> PAGE_SHIFT)
41 | MMU_VMR_CACHE_WRBACK,
42 },
43};
44
45static const struct sdram_config sdram_config = {
46 .data_bits = SDRAM_DATA_32BIT,
47 .row_bits = 13,
48 .col_bits = 10,
49 .bank_bits = 2,
50 .cas = 3,
51 .twr = 2,
52 .trc = 7,
53 .trp = 2,
54 .trcd = 2,
55 .tras = 5,
56 .txsr = 6,
57 /* 7.81 us */
58 .refresh_period = (781 * (SDRAMC_BUS_HZ / 1000)) / 100000,
59};
60
61int board_early_init_f(void)
62{
63 /* Enable SDRAM in the EBI mux */
64 hmatrix_slave_write(EBI, SFR, HMATRIX_BIT(EBI_SDRAM_ENABLE)
65 | HMATRIX_BIT(EBI_NAND_ENABLE));
66
67 portmux_enable_ebi(32, 23, PORTMUX_EBI_NAND,
68 PORTMUX_DRIVE_HIGH);
69 portmux_select_gpio(PORTMUX_PORT_E, 1 << 23,
70 PORTMUX_DIR_OUTPUT | PORTMUX_INIT_HIGH
71 | PORTMUX_DRIVE_MIN);
72 portmux_enable_usart1(PORTMUX_DRIVE_MIN);
73
74#if defined(CONFIG_MACB)
75 portmux_enable_macb0(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
76 portmux_enable_macb1(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
77#endif
78#if defined(CONFIG_MMC)
79 portmux_enable_mmci(0, PORTMUX_MMCI_4BIT, PORTMUX_DRIVE_LOW);
80#endif
81#if defined(CONFIG_ATMEL_SPI)
82 portmux_enable_spi0(1 << 0, PORTMUX_DRIVE_LOW);
83#endif
84
85 return 0;
86}
87
88phys_size_t initdram(int board_type)
89{
90 unsigned long expected_size;
91 unsigned long actual_size;
92 void *sdram_base;
93
94 sdram_base = uncached(EBI_SDRAM_BASE);
95
96 expected_size = sdram_init(sdram_base, &sdram_config);
97 actual_size = get_ram_size(sdram_base, expected_size);
98
99 if (expected_size != actual_size)
100 printf("Warning: Only %lu of %lu MiB SDRAM is working\n",
101 actual_size >> 20, expected_size >> 20);
102
103 return actual_size;
104}
105
106int board_early_init_r(void)
107{
108 gd->bd->bi_phy_id[0] = 0x01;
109 gd->bd->bi_phy_id[1] = 0x03;
110 return 0;
111}
112
113#ifdef CONFIG_CMD_NET
114int board_eth_init(bd_t *bi)
115{
116 macb_eth_initialize(0, (void *)ATMEL_BASE_MACB0, bi->bi_phy_id[0]);
117 macb_eth_initialize(1, (void *)ATMEL_BASE_MACB1, bi->bi_phy_id[1]);
118 return 0;
119}
120#endif
121
122/* SPI chip select control */
123#ifdef CONFIG_ATMEL_SPI
124#define ATNGW100_DATAFLASH_CS_PIN GPIO_PIN_PA(3)
125
126int spi_cs_is_valid(unsigned int bus, unsigned int cs)
127{
128 return bus == 0 && cs == 0;
129}
130
131void spi_cs_activate(struct spi_slave *slave)
132{
133 gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 0);
134}
135
136void spi_cs_deactivate(struct spi_slave *slave)
137{
138 gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 1);
139}
140#endif /* CONFIG_ATMEL_SPI */