| Tero Kristo | 814c611 | 2019-09-27 19:14:26 +0300 | [diff] [blame] | 1 | Binding for TI CDCE913/925/937/949 programmable I2C clock synthesizers. |
| 2 | |
| 3 | Reference |
| 4 | This binding uses the common clock binding[1]. |
| 5 | |
| 6 | [1] Documentation/devicetree/bindings/clock/clock-bindings.txt |
| 7 | [2] http://www.ti.com/product/cdce913 |
| 8 | [3] http://www.ti.com/product/cdce925 |
| 9 | [4] http://www.ti.com/product/cdce937 |
| 10 | [5] http://www.ti.com/product/cdce949 |
| 11 | |
| 12 | The driver provides clock sources for each output Y1 through Y5. |
| 13 | |
| 14 | Required properties: |
| 15 | - compatible: Shall be one of the following: |
| 16 | - "ti,cdce913": 1-PLL, 3 Outputs |
| 17 | - "ti,cdce925": 2-PLL, 5 Outputs |
| 18 | - "ti,cdce937": 3-PLL, 7 Outputs |
| 19 | - "ti,cdce949": 4-PLL, 9 Outputs |
| 20 | - reg: I2C device address. |
| 21 | - clocks: Points to a fixed parent clock that provides the input frequency. |
| 22 | - #clock-cells: From common clock bindings: Shall be 1. |
| 23 | |
| 24 | Optional properties: |
| 25 | - xtal-load-pf: Crystal load-capacitor value to fine-tune performance on a |
| 26 | board, or to compensate for external influences. |
| 27 | |
| 28 | For all PLL1, PLL2, ... an optional child node can be used to specify spread |
| 29 | spectrum clocking parameters for a board. |
| 30 | - spread-spectrum: SSC mode as defined in the data sheet. |
| 31 | - spread-spectrum-center: Use "centered" mode instead of "max" mode. When |
| 32 | present, the clock runs at the requested frequency on average. Otherwise |
| 33 | the requested frequency is the maximum value of the SCC range. |
| 34 | |
| 35 | |
| 36 | Example: |
| 37 | |
| 38 | clockgen: cdce925pw@64 { |
| 39 | compatible = "cdce925"; |
| 40 | reg = <0x64>; |
| 41 | clocks = <&xtal_27Mhz>; |
| 42 | #clock-cells = <1>; |
| 43 | xtal-load-pf = <5>; |
| 44 | /* PLL options to get SSC 1% centered */ |
| 45 | PLL2 { |
| 46 | spread-spectrum = <4>; |
| 47 | spread-spectrum-center; |
| 48 | }; |
| 49 | }; |