| Tom Rini | 53633a8 | 2024-02-29 12:33:36 -0500 | [diff] [blame^] | 1 | // SPDX-License-Identifier: BSD-3-Clause |
| 2 | /* |
| 3 | * Copyright (c) 2021, Luca Weiss <luca@z3ntu.xyz> |
| 4 | */ |
| 5 | |
| 6 | #include <dt-bindings/input/input.h> |
| 7 | #include <dt-bindings/spmi/spmi.h> |
| 8 | |
| 9 | / { |
| 10 | thermal-zones { |
| 11 | pm6350-thermal { |
| 12 | polling-delay-passive = <100>; |
| 13 | polling-delay = <0>; |
| 14 | |
| 15 | thermal-sensors = <&pm6350_temp>; |
| 16 | |
| 17 | trips { |
| 18 | trip0 { |
| 19 | temperature = <95000>; |
| 20 | hysteresis = <0>; |
| 21 | type = "passive"; |
| 22 | }; |
| 23 | |
| 24 | trip1 { |
| 25 | temperature = <115000>; |
| 26 | hysteresis = <0>; |
| 27 | type = "hot"; |
| 28 | }; |
| 29 | |
| 30 | trip2 { |
| 31 | temperature = <125000>; |
| 32 | hysteresis = <0>; |
| 33 | type = "critical"; |
| 34 | }; |
| 35 | }; |
| 36 | }; |
| 37 | }; |
| 38 | }; |
| 39 | |
| 40 | &spmi_bus { |
| 41 | pmic@0 { |
| 42 | compatible = "qcom,pm6350", "qcom,spmi-pmic"; |
| 43 | reg = <0x0 SPMI_USID>; |
| 44 | #address-cells = <1>; |
| 45 | #size-cells = <0>; |
| 46 | |
| 47 | pm6350_pon: pon@800 { |
| 48 | compatible = "qcom,pm8998-pon"; |
| 49 | reg = <0x800>; |
| 50 | mode-bootloader = <0x2>; |
| 51 | mode-recovery = <0x1>; |
| 52 | |
| 53 | pm6350_pwrkey: pwrkey { |
| 54 | compatible = "qcom,pm8941-pwrkey"; |
| 55 | interrupts = <0x0 0x8 0x0 IRQ_TYPE_EDGE_BOTH>; |
| 56 | debounce = <15625>; |
| 57 | bias-pull-up; |
| 58 | linux,code = <KEY_POWER>; |
| 59 | }; |
| 60 | |
| 61 | pm6350_resin: resin { |
| 62 | compatible = "qcom,pm8941-resin"; |
| 63 | interrupts = <0x0 0x8 0x1 IRQ_TYPE_EDGE_BOTH>; |
| 64 | debounce = <15625>; |
| 65 | bias-pull-up; |
| 66 | status = "disabled"; |
| 67 | }; |
| 68 | }; |
| 69 | |
| 70 | pm6350_temp: temp-alarm@2400 { |
| 71 | compatible = "qcom,spmi-temp-alarm"; |
| 72 | reg = <0x2400>; |
| 73 | interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; |
| 74 | #thermal-sensor-cells = <0>; |
| 75 | }; |
| 76 | |
| 77 | pm6350_gpios: gpio@c000 { |
| 78 | compatible = "qcom,pm6350-gpio", "qcom,spmi-gpio"; |
| 79 | reg = <0xc000>; |
| 80 | gpio-controller; |
| 81 | gpio-ranges = <&pm6350_gpios 0 0 9>; |
| 82 | #gpio-cells = <2>; |
| 83 | interrupt-controller; |
| 84 | #interrupt-cells = <2>; |
| 85 | }; |
| 86 | }; |
| 87 | |
| 88 | pmic@1 { |
| 89 | compatible = "qcom,pm6350", "qcom,spmi-pmic"; |
| 90 | reg = <0x1 SPMI_USID>; |
| 91 | #address-cells = <1>; |
| 92 | #size-cells = <0>; |
| 93 | }; |
| 94 | }; |