Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 1 | CONFIG_ARM=y |
| 2 | CONFIG_TARGET_LS1028AQDS=y |
| 3 | CONFIG_TFABOOT=y |
| 4 | CONFIG_SYS_MALLOC_F_LEN=0x6000 |
| 5 | CONFIG_ENV_SIZE=0x2000 |
Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 6 | CONFIG_ENV_OFFSET=0x500000 |
Tom Rini | 3eea577 | 2020-05-08 09:08:39 -0400 | [diff] [blame] | 7 | CONFIG_ENV_SECT_SIZE=0x40000 |
Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 8 | CONFIG_DM_GPIO=y |
| 9 | CONFIG_FSPI_AHB_EN_4BYTE=y |
| 10 | CONFIG_NR_DRAM_BANKS=2 |
| 11 | CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y |
| 12 | CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y |
| 13 | CONFIG_AHCI=y |
| 14 | CONFIG_DISTRO_DEFAULTS=y |
| 15 | CONFIG_FIT_VERBOSE=y |
| 16 | CONFIG_OF_BOARD_SETUP=y |
| 17 | CONFIG_OF_STDOUT_VIA_ALIAS=y |
Tom Rini | 3eea577 | 2020-05-08 09:08:39 -0400 | [diff] [blame] | 18 | CONFIG_SYS_EXTRA_OPTIONS="LPUART" |
Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 19 | CONFIG_BOOTDELAY=10 |
| 20 | CONFIG_USE_BOOTARGS=y |
| 21 | CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x2000000 default_hugepagesz=2m hugepagesz=2m hugepages=256 video=1920x1080-32@60 cma=256M" |
Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 22 | CONFIG_MISC_INIT_R=y |
| 23 | CONFIG_CMD_GREPENV=y |
Michal Simek | a9565e9 | 2020-05-04 15:26:20 +0200 | [diff] [blame] | 24 | CONFIG_CMD_MEMTEST=y |
Ashok Reddy Soma | 41e8edf | 2020-05-04 15:26:21 +0200 | [diff] [blame] | 25 | CONFIG_SYS_MEMTEST_START=0x80000000 |
| 26 | CONFIG_SYS_MEMTEST_END=0x9fffffff |
Yuantian Tang | ed9f457 | 2020-04-22 11:34:39 +0800 | [diff] [blame] | 27 | CONFIG_CMD_DM=y |
| 28 | CONFIG_CMD_GPT=y |
| 29 | CONFIG_CMD_I2C=y |
| 30 | CONFIG_CMD_MMC=y |
| 31 | CONFIG_CMD_PCI=y |
| 32 | CONFIG_CMD_USB=y |
| 33 | CONFIG_CMD_WDT=y |
| 34 | # CONFIG_CMD_SETEXPR is not set |
| 35 | CONFIG_CMD_CACHE=y |
| 36 | CONFIG_OF_CONTROL=y |
| 37 | CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1028a-qds-lpuart" |
| 38 | CONFIG_ENV_IS_IN_MMC=y |
| 39 | CONFIG_ENV_IS_IN_SPI_FLASH=y |
| 40 | CONFIG_ENV_ADDR=0x20500000 |
| 41 | CONFIG_NET_RANDOM_ETHADDR=y |
| 42 | CONFIG_NETCONSOLE=y |
| 43 | CONFIG_DM=y |
| 44 | CONFIG_SCSI_AHCI=y |
| 45 | CONFIG_SATA_CEVA=y |
| 46 | CONFIG_FSL_CAAM=y |
| 47 | CONFIG_DM_I2C=y |
| 48 | CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| 49 | CONFIG_I2C_DEFAULT_BUS_NUMBER=0 |
| 50 | CONFIG_I2C_MUX=y |
| 51 | CONFIG_I2C_MUX_PCA954x=y |
| 52 | CONFIG_DM_MMC=y |
| 53 | CONFIG_FSL_ESDHC=y |
| 54 | CONFIG_MTD=y |
| 55 | CONFIG_DM_SPI_FLASH=y |
| 56 | CONFIG_SPI_FLASH_SPANSION=y |
| 57 | CONFIG_SPI_FLASH_STMICRO=y |
| 58 | # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set |
| 59 | CONFIG_PHYLIB=y |
| 60 | CONFIG_PHY_AQUANTIA=y |
| 61 | CONFIG_PHY_ATHEROS=y |
| 62 | CONFIG_PHY_VITESSE=y |
| 63 | CONFIG_DM_ETH=y |
| 64 | CONFIG_DM_MDIO=y |
| 65 | CONFIG_DM_MDIO_MUX=y |
| 66 | CONFIG_E1000=y |
| 67 | CONFIG_FSL_ENETC=y |
| 68 | CONFIG_MDIO_MUX_I2CREG=y |
| 69 | CONFIG_PCI=y |
| 70 | CONFIG_DM_PCI=y |
| 71 | CONFIG_DM_PCI_COMPAT=y |
| 72 | CONFIG_PCIE_ECAM_GENERIC=y |
| 73 | CONFIG_PCIE_LAYERSCAPE=y |
| 74 | CONFIG_DM_RTC=y |
| 75 | CONFIG_RTC_PCF2127=y |
| 76 | CONFIG_SCSI=y |
| 77 | CONFIG_DM_SCSI=y |
| 78 | CONFIG_DM_SERIAL=y |
| 79 | CONFIG_FSL_LPUART=y |
| 80 | CONFIG_SPI=y |
| 81 | CONFIG_DM_SPI=y |
| 82 | CONFIG_FSL_DSPI=y |
| 83 | CONFIG_NXP_FSPI=y |
| 84 | CONFIG_USB=y |
| 85 | CONFIG_DM_USB=y |
| 86 | CONFIG_USB_XHCI_HCD=y |
| 87 | CONFIG_USB_XHCI_DWC3=y |
| 88 | CONFIG_WDT=y |
| 89 | CONFIG_WDT_SP805=y |
| 90 | CONFIG_OF_LIBFDT_OVERLAY=y |
| 91 | CONFIG_EFI_LOADER_BOUNCE_BUFFER=y |