blob: 494db6012d02f29b3e17aec0f91f0ea6b0b65a28 [file] [log] [blame]
Tom Rini53633a82024-02-29 12:33:36 -05001IMG Synchronous Peripheral Flash Interface (SPFI) controller
2
3Required properties:
4- compatible: Must be "img,spfi".
5- reg: Must contain the base address and length of the SPFI registers.
6- interrupts: Must contain the SPFI interrupt.
7- clocks: Must contain an entry for each entry in clock-names.
8 See ../clock/clock-bindings.txt for details.
9- clock-names: Must include the following entries:
10 - spfi: SPI operating clock
11 - sys: SPI system interface clock
12- dmas: Must contain an entry for each entry in dma-names.
13 See ../dma/dma.txt for details.
14- dma-names: Must include the following entries:
15 - rx
16 - tx
17- cs-gpios: Must specify the GPIOs used for chipselect lines.
18- #address-cells: Must be 1.
19- #size-cells: Must be 0.
20
21Optional properties:
22- img,supports-quad-mode: Should be set if the interface supports quad mode
23 SPI transfers.
24- spfi-max-frequency: Maximum speed supported by the spfi block.
25
26Example:
27
28spi@18100f00 {
29 compatible = "img,spfi";
30 reg = <0x18100f00 0x100>;
31 interrupts = <GIC_SHARED 22 IRQ_TYPE_LEVEL_HIGH>;
32 clocks = <&spi_clk>, <&system_clk>;
33 clock-names = "spfi", "sys";
34 dmas = <&mdc 9 0xffffffff 0>, <&mdc 10 0xffffffff 0>;
35 dma-names = "rx", "tx";
36
37 #address-cells = <1>;
38 #size-cells = <0>;
39};