| Mario Six | 3e67cb2 | 2019-01-21 09:18:23 +0100 | [diff] [blame^] | 1 | /* KMBEC FPGA (PRIO) */ |
| 2 | #define CONFIG_SYS_KMBEC_FPGA_BASE 0xE8000000 |
| 3 | #define CONFIG_SYS_KMBEC_FPGA_SIZE 64 |
| 4 | |
| 5 | /* |
| 6 | * High Level Configuration Options |
| 7 | */ |
| 8 | #define CONFIG_QE /* Has QE */ |
| 9 | |
| 10 | /* |
| 11 | * QE UEC ethernet configuration |
| 12 | */ |
| 13 | #define CONFIG_UEC_ETH1 /* GETH1 */ |
| 14 | #define UEC_VERBOSE_DEBUG 1 |
| 15 | |
| 16 | #define CONFIG_SYS_UEC1_UCC_NUM 3 /* UCC4 */ |
| 17 | #define CONFIG_SYS_UEC1_RX_CLK QE_CLK_NONE /* not used in RMII Mode */ |
| 18 | #define CONFIG_SYS_UEC1_TX_CLK QE_CLK17 |
| 19 | #define CONFIG_SYS_UEC1_ETH_TYPE FAST_ETH |
| 20 | #define CONFIG_SYS_UEC1_PHY_ADDR 0 |
| 21 | #define CONFIG_SYS_UEC1_INTERFACE_TYPE PHY_INTERFACE_MODE_RMII |
| 22 | #define CONFIG_SYS_UEC1_INTERFACE_SPEED 100 |
| 23 | |
| 24 | /* |
| 25 | * System IO Setup |
| 26 | */ |
| 27 | #define CONFIG_SYS_SICRH (SICRH_UC1EOBI | SICRH_UC2E1OBI) |
| 28 | |
| 29 | /** |
| 30 | * DDR RAM settings |
| 31 | */ |
| 32 | #define CONFIG_SYS_DDR_SDRAM_CFG (\ |
| 33 | SDRAM_CFG_SDRAM_TYPE_DDR2 | \ |
| 34 | SDRAM_CFG_SREN | \ |
| 35 | SDRAM_CFG_HSE) |
| 36 | |
| 37 | #define CONFIG_SYS_DDR_SDRAM_CFG2 0x00401000 |
| 38 | |
| 39 | #define CONFIG_SYS_DDR_CLK_CNTL (\ |
| 40 | DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05) |
| 41 | |
| 42 | #define CONFIG_SYS_DDR_INTERVAL (\ |
| 43 | (0x080 << SDRAM_INTERVAL_BSTOPRE_SHIFT) | \ |
| 44 | (0x203 << SDRAM_INTERVAL_REFINT_SHIFT)) |
| 45 | |
| 46 | #define CONFIG_SYS_DDR_CS0_BNDS 0x0000007f |
| 47 | |
| 48 | #define CONFIG_SYS_DDRCDR (\ |
| 49 | DDRCDR_EN | \ |
| 50 | DDRCDR_Q_DRN) |
| 51 | #define CONFIG_SYS_DDR_MODE 0x47860452 |
| 52 | #define CONFIG_SYS_DDR_MODE2 0x8080c000 |
| 53 | |
| 54 | #define CONFIG_SYS_DDR_TIMING_0 (\ |
| 55 | (2 << TIMING_CFG0_MRS_CYC_SHIFT) | \ |
| 56 | (8 << TIMING_CFG0_ODT_PD_EXIT_SHIFT) | \ |
| 57 | (6 << TIMING_CFG0_PRE_PD_EXIT_SHIFT) | \ |
| 58 | (2 << TIMING_CFG0_ACT_PD_EXIT_SHIFT) | \ |
| 59 | (0 << TIMING_CFG0_WWT_SHIFT) | \ |
| 60 | (0 << TIMING_CFG0_RRT_SHIFT) | \ |
| 61 | (0 << TIMING_CFG0_WRT_SHIFT) | \ |
| 62 | (0 << TIMING_CFG0_RWT_SHIFT)) |
| 63 | |
| 64 | #define CONFIG_SYS_DDR_TIMING_1 ((TIMING_CFG1_CASLAT_50) | \ |
| 65 | (2 << TIMING_CFG1_WRTORD_SHIFT) | \ |
| 66 | (2 << TIMING_CFG1_ACTTOACT_SHIFT) | \ |
| 67 | (3 << TIMING_CFG1_WRREC_SHIFT) | \ |
| 68 | (7 << TIMING_CFG1_REFREC_SHIFT) | \ |
| 69 | (3 << TIMING_CFG1_ACTTORW_SHIFT) | \ |
| 70 | (8 << TIMING_CFG1_ACTTOPRE_SHIFT) | \ |
| 71 | (3 << TIMING_CFG1_PRETOACT_SHIFT)) |
| 72 | |
| 73 | #define CONFIG_SYS_DDR_TIMING_2 (\ |
| 74 | (0xa << TIMING_CFG2_FOUR_ACT_SHIFT) | \ |
| 75 | (3 << TIMING_CFG2_CKE_PLS_SHIFT) | \ |
| 76 | (2 << TIMING_CFG2_WR_DATA_DELAY_SHIFT) | \ |
| 77 | (2 << TIMING_CFG2_RD_TO_PRE_SHIFT) | \ |
| 78 | (4 << TIMING_CFG2_WR_LAT_DELAY_SHIFT) | \ |
| 79 | (5 << TIMING_CFG2_CPO_SHIFT) | \ |
| 80 | (0 << TIMING_CFG2_ADD_LAT_SHIFT)) |
| 81 | |
| 82 | #define CONFIG_SYS_DDR_TIMING_3 0x00000000 |
| 83 | |
| 84 | /* EEprom support */ |
| 85 | #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2 |
| 86 | |
| 87 | /* |
| 88 | * PAXE on the local bus CS3 |
| 89 | */ |
| 90 | #define CONFIG_SYS_PAXE_BASE 0xA0000000 |
| 91 | #define CONFIG_SYS_PAXE_SIZE 256 |