Tom Rini | 10e4779 | 2018-05-06 17:58:06 -0400 | [diff] [blame] | 1 | // SPDX-License-Identifier: GPL-2.0+ |
Stefan Roese | f054758 | 2016-02-12 14:24:07 +0100 | [diff] [blame] | 2 | /* |
| 3 | * Copyright (C) 2016 Stefan Roese <sr@denx.de> |
Stefan Roese | f054758 | 2016-02-12 14:24:07 +0100 | [diff] [blame] | 4 | */ |
| 5 | |
| 6 | #include <common.h> |
| 7 | #include <altera.h> |
| 8 | #include <errno.h> |
Simon Glass | 0f2af88 | 2020-05-10 11:40:05 -0600 | [diff] [blame] | 9 | #include <log.h> |
Stefan Roese | f054758 | 2016-02-12 14:24:07 +0100 | [diff] [blame] | 10 | #include <asm/gpio.h> |
| 11 | #include <asm/io.h> |
| 12 | #include <asm/arch/cpu.h> |
| 13 | #include <asm/arch/soc.h> |
| 14 | #include <asm/arch-mvebu/spi.h> |
| 15 | #include "theadorable.h" |
| 16 | |
| 17 | /* |
| 18 | * FPGA programming support |
| 19 | */ |
| 20 | static int fpga_pre_fn(int cookie) |
| 21 | { |
| 22 | int gpio_config = COOKIE2CONFIG(cookie); |
| 23 | int gpio_done = COOKIE2DONE(cookie); |
| 24 | int ret; |
| 25 | |
| 26 | debug("%s (%d): cookie=%08x gpio_config=%d gpio_done=%d\n", |
| 27 | __func__, __LINE__, cookie, gpio_config, gpio_done); |
| 28 | |
| 29 | /* Configure config pin */ |
| 30 | /* Set to output */ |
| 31 | ret = gpio_request(gpio_config, "CONFIG"); |
| 32 | if (ret < 0) |
| 33 | return ret; |
| 34 | gpio_direction_output(gpio_config, 1); |
| 35 | |
| 36 | /* Configure done pin */ |
| 37 | /* Set to input */ |
| 38 | ret = gpio_request(gpio_done, "DONE"); |
| 39 | if (ret < 0) |
| 40 | return ret; |
| 41 | |
| 42 | gpio_direction_input(gpio_done); |
| 43 | |
| 44 | return 0; |
| 45 | } |
| 46 | |
| 47 | static int fpga_config_fn(int assert, int flush, int cookie) |
| 48 | { |
| 49 | int gpio_config = COOKIE2CONFIG(cookie); |
| 50 | |
| 51 | debug("%s (%d): cookie=%08x gpio_config=%d\n", |
| 52 | __func__, __LINE__, cookie, gpio_config); |
| 53 | |
| 54 | if (assert) |
| 55 | gpio_set_value(gpio_config, 1); |
| 56 | else |
| 57 | gpio_set_value(gpio_config, 0); |
| 58 | |
| 59 | return 0; |
| 60 | } |
| 61 | |
| 62 | static int fpga_write_fn(const void *buf, size_t len, int flush, int cookie) |
| 63 | { |
| 64 | int spi_bus = COOKIE2SPI_BUS(cookie); |
| 65 | int spi_dev = COOKIE2SPI_DEV(cookie); |
| 66 | struct kwspi_registers *reg; |
| 67 | u32 control_reg; |
| 68 | u32 config_reg; |
| 69 | void *dst; |
| 70 | |
| 71 | /* |
| 72 | * Write data to FPGA attached to SPI bus via SPI direct write. |
| 73 | * This results in the fastest and easiest way to program the |
| 74 | * bitstream into the FPGA. |
| 75 | */ |
| 76 | debug("%s (%d): cookie=%08x spi_bus=%d spi_dev=%d\n", |
| 77 | __func__, __LINE__, cookie, spi_bus, spi_dev); |
| 78 | |
| 79 | if (spi_bus == 0) { |
| 80 | reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10600); |
| 81 | dst = (void *)SPI_BUS0_DEV1_BASE; |
| 82 | } else { |
| 83 | reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10680); |
| 84 | dst = (void *)SPI_BUS1_DEV2_BASE; |
| 85 | } |
| 86 | |
| 87 | /* Configure SPI controller for direct access mode */ |
| 88 | control_reg = readl(®->ctrl); |
| 89 | config_reg = readl(®->cfg); |
| 90 | writel(0x00000214, ®->cfg); /* 27MHz clock */ |
| 91 | writel(0x00000000, ®->dw_cfg); /* don't de-asset CS */ |
| 92 | writel(KWSPI_CSN_ACT, ®->ctrl); /* activate CS */ |
| 93 | |
| 94 | /* Copy data to the SPI direct mapped window */ |
| 95 | memcpy(dst, buf, len); |
| 96 | |
| 97 | /* Restore original register values */ |
| 98 | writel(control_reg, ®->ctrl); |
| 99 | writel(config_reg, ®->cfg); |
| 100 | |
| 101 | return 0; |
| 102 | } |
| 103 | |
| 104 | /* Returns the state of CONF_DONE Pin */ |
| 105 | static int fpga_done_fn(int cookie) |
| 106 | { |
| 107 | int gpio_done = COOKIE2DONE(cookie); |
| 108 | unsigned long ts; |
| 109 | |
| 110 | debug("%s (%d): cookie=%08x gpio_done=%d\n", |
| 111 | __func__, __LINE__, cookie, gpio_done); |
| 112 | |
| 113 | ts = get_timer(0); |
| 114 | do { |
| 115 | if (gpio_get_value(gpio_done)) |
| 116 | return 0; |
| 117 | } while (get_timer(ts) < 1000); |
| 118 | |
| 119 | /* timeout so return error */ |
| 120 | return -ENODEV; |
| 121 | } |
| 122 | |
| 123 | static altera_board_specific_func stratixv_fns = { |
| 124 | .pre = fpga_pre_fn, |
| 125 | .config = fpga_config_fn, |
| 126 | .write = fpga_write_fn, |
| 127 | .done = fpga_done_fn, |
| 128 | }; |
| 129 | |
| 130 | static Altera_desc altera_fpga[] = { |
| 131 | { |
| 132 | /* Family */ |
| 133 | Altera_StratixV, |
| 134 | /* Interface type */ |
| 135 | passive_serial, |
| 136 | /* No limitation as additional data will be ignored */ |
| 137 | -1, |
| 138 | /* Device function table */ |
| 139 | (void *)&stratixv_fns, |
| 140 | /* Base interface address specified in driver */ |
| 141 | NULL, |
| 142 | /* Cookie implementation */ |
| 143 | /* |
| 144 | * In this 32bit word the following information is coded: |
| 145 | * Bit 31 ... Bit 0 |
| 146 | * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin |
| 147 | */ |
| 148 | FPGA_COOKIE(0, 1, 26, 7) |
| 149 | }, |
| 150 | { |
| 151 | /* Family */ |
| 152 | Altera_StratixV, |
| 153 | /* Interface type */ |
| 154 | passive_serial, |
| 155 | /* No limitation as additional data will be ignored */ |
| 156 | -1, |
| 157 | /* Device function table */ |
| 158 | (void *)&stratixv_fns, |
| 159 | /* Base interface address specified in driver */ |
| 160 | NULL, |
| 161 | /* Cookie implementation */ |
| 162 | /* |
| 163 | * In this 32bit word the following information is coded: |
| 164 | * Bit 31 ... Bit 0 |
| 165 | * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin |
| 166 | */ |
| 167 | FPGA_COOKIE(1, 2, 29, 9) |
| 168 | }, |
| 169 | }; |
| 170 | |
| 171 | /* Add device descriptor to FPGA device table */ |
| 172 | void board_fpga_add(void) |
| 173 | { |
| 174 | int i; |
| 175 | |
| 176 | fpga_init(); |
| 177 | for (i = 0; i < ARRAY_SIZE(altera_fpga); i++) |
| 178 | fpga_add(fpga_altera, &altera_fpga[i]); |
| 179 | } |