| // SPDX-License-Identifier: GPL-2.0+ |
| |
| #include <asm/arch/clock.h> |
| #include <asm/arch/iomux.h> |
| #include <asm/arch/imx-regs.h> |
| #include <asm/arch/crm_regs.h> |
| #include <asm/arch/mx6ul_pins.h> |
| #include <asm/arch/mx6-pins.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/gpio.h> |
| #include <asm/mach-imx/iomux-v3.h> |
| #include <asm/mach-imx/boot_mode.h> |
| #include <fsl_esdhc_imx.h> |
| #include <linux/libfdt.h> |
| #include <spl.h> |
| |
| #if defined(CONFIG_SPL_BUILD) |
| |
| #ifdef CONFIG_SPL_OS_BOOT |
| int spl_start_uboot(void) |
| { |
| /* Break into full U-Boot on 'c' */ |
| if (serial_tstc() && serial_getc() == 'c') |
| return 1; |
| |
| return 0; |
| } |
| #endif |
| |
| #include <asm/arch/mx6-ddr.h> |
| |
| static struct mx6ul_iomux_grp_regs mx6_grp_ioregs = { |
| .grp_addds = 0x00000030, |
| .grp_ddrmode_ctl = 0x00020000, |
| .grp_b0ds = 0x00000030, |
| .grp_ctlds = 0x00000030, |
| .grp_b1ds = 0x00000030, |
| .grp_ddrpke = 0x00000000, |
| .grp_ddrmode = 0x00020000, |
| .grp_ddr_type = 0x00080000, |
| }; |
| |
| static struct mx6ul_iomux_ddr_regs mx6_ddr_ioregs = { |
| .dram_dqm0 = 0x00000030, |
| .dram_dqm1 = 0x00000030, |
| .dram_ras = 0x00000030, |
| .dram_cas = 0x00000030, |
| .dram_odt0 = 0x00000030, |
| .dram_odt1 = 0x00000030, |
| .dram_sdba2 = 0x00000000, |
| .dram_sdclk_0 = 0x00000030, |
| .dram_sdqs0 = 0x00000030, |
| .dram_sdqs1 = 0x00000030, |
| .dram_reset = 0x00000030, |
| }; |
| |
| static struct mx6_mmdc_calibration mx6_mmcd_calib = { |
| .p0_mpwldectrl0 = 0x00000000, |
| .p0_mpdgctrl0 = 0x01380134, |
| .p0_mprddlctl = 0x40404244, |
| .p0_mpwrdlctl = 0x40405050, |
| }; |
| |
| static struct mx6_ddr_sysinfo ddr_sysinfo = { |
| .dsize = 0, |
| .cs1_mirror = 0, |
| .cs_density = 32, |
| .ncs = 1, |
| .bi_on = 1, |
| .rtt_nom = 1, |
| .rtt_wr = 0, |
| .ralat = 5, |
| .walat = 0, |
| .mif3_mode = 3, |
| .rst_to_cke = 0x23, |
| .sde_to_rst = 0x10, |
| .refsel = 1, |
| .refr = 3, |
| }; |
| |
| static struct mx6_ddr3_cfg mem_ddr = { |
| .mem_speed = 1333, |
| .density = 2, |
| .width = 16, |
| .banks = 8, |
| .coladdr = 10, |
| .pagesz = 2, |
| .trcd = 1350, |
| .trcmin = 4950, |
| .trasmin = 3600, |
| }; |
| |
| static void ccgr_init(void) |
| { |
| struct mxc_ccm_reg *ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR; |
| |
| writel(0xFFFFFFFF, &ccm->CCGR0); |
| writel(0xFFFFFFFF, &ccm->CCGR1); |
| writel(0xFFFFFFFF, &ccm->CCGR2); |
| writel(0xFFFFFFFF, &ccm->CCGR3); |
| writel(0xFFFFFFFF, &ccm->CCGR4); |
| writel(0xFFFFFFFF, &ccm->CCGR5); |
| writel(0xFFFFFFFF, &ccm->CCGR6); |
| } |
| |
| static void imx6ul_spl_dram_cfg_size(u32 ram_size) |
| { |
| if (ram_size == SZ_256M) |
| mem_ddr.rowaddr = 14; |
| else |
| mem_ddr.rowaddr = 15; |
| |
| mx6ul_dram_iocfg(mem_ddr.width, &mx6_ddr_ioregs, &mx6_grp_ioregs); |
| mx6_dram_cfg(&ddr_sysinfo, &mx6_mmcd_calib, &mem_ddr); |
| } |
| |
| static void imx6ul_spl_dram_cfg(void) |
| { |
| ulong ram_size_test, ram_size = 0; |
| |
| for (ram_size = SZ_512M; ram_size >= SZ_256M; ram_size >>= 1) { |
| imx6ul_spl_dram_cfg_size(ram_size); |
| ram_size_test = get_ram_size((long int *)PHYS_SDRAM, ram_size); |
| if (ram_size_test == ram_size) |
| break; |
| } |
| |
| if (ram_size < SZ_256M) { |
| puts("ERROR: DRAM size detection failed\n"); |
| hang(); |
| } |
| } |
| |
| void board_init_f(ulong dummy) |
| { |
| ccgr_init(); |
| arch_cpu_init(); |
| board_early_init_f(); |
| timer_init(); |
| preloader_console_init(); |
| imx6ul_spl_dram_cfg(); |
| memset(__bss_start, 0, __bss_end - __bss_start); |
| board_init_r(NULL, 0); |
| } |
| |
| void reset_cpu(ulong addr) |
| { |
| } |
| |
| #define USDHC_PAD_CTRL (PAD_CTL_PKE | PAD_CTL_PUE | \ |
| PAD_CTL_PUS_22K_UP | PAD_CTL_SPEED_LOW | \ |
| PAD_CTL_DSE_80ohm | PAD_CTL_SRE_FAST | PAD_CTL_HYS) |
| |
| static iomux_v3_cfg_t const usdhc1_pads[] = { |
| MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_SD1_CMD__USDHC1_CMD | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_SD1_DATA0__USDHC1_DATA0 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_SD1_DATA1__USDHC1_DATA1 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_SD1_DATA2__USDHC1_DATA2 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_SD1_DATA3__USDHC1_DATA3 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_NAND_READY_B__USDHC1_DATA4 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_NAND_CE0_B__USDHC1_DATA5 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_NAND_CE1_B__USDHC1_DATA6 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| MX6_PAD_NAND_CLE__USDHC1_DATA7 | MUX_PAD_CTRL(USDHC_PAD_CTRL), |
| }; |
| |
| static struct fsl_esdhc_cfg usdhc_cfg[1] = { |
| {USDHC1_BASE_ADDR}, |
| }; |
| |
| int board_mmc_getcd(struct mmc *mmc) |
| { |
| return 1; |
| } |
| |
| int board_mmc_init(bd_t *bis) |
| { |
| imx_iomux_v3_setup_multiple_pads(usdhc1_pads, ARRAY_SIZE(usdhc1_pads)); |
| usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK); |
| return fsl_esdhc_initialize(bis, &usdhc_cfg[0]); |
| } |
| #endif |