| /* SPDX-License-Identifier: GPL-2.0+ */ |
| /* |
| * (C) Copyright 2002 |
| * Daniel Engström, Omicron Ceti AB, daniel@omicron.se. |
| */ |
| |
| /* i8254.h Intel 8254 PIT registers */ |
| |
| #ifndef _ASMI386_I8254_H_ |
| #define _ASMI386_I8254_H_ |
| |
| #define PIT_T0 0x00 /* PIT channel 0 count/status */ |
| #define PIT_T1 0x01 /* PIT channel 1 count/status */ |
| #define PIT_T2 0x02 /* PIT channel 2 count/status */ |
| #define PIT_COMMAND 0x03 /* PIT mode control, latch and read back */ |
| |
| /* PIT Command Register Bit Definitions */ |
| |
| #define PIT_CMD_CTR0 0x00 /* Select PIT counter 0 */ |
| #define PIT_CMD_CTR1 0x40 /* Select PIT counter 1 */ |
| #define PIT_CMD_CTR2 0x80 /* Select PIT counter 2 */ |
| |
| #define PIT_CMD_LATCH 0x00 /* Counter Latch Command */ |
| #define PIT_CMD_LOW 0x10 /* Access counter bits 7-0 */ |
| #define PIT_CMD_HIGH 0x20 /* Access counter bits 15-8 */ |
| #define PIT_CMD_BOTH 0x30 /* Access counter bits 15-0 in two accesses */ |
| |
| #define PIT_CMD_MODE0 0x00 /* Select mode 0 */ |
| #define PIT_CMD_MODE1 0x02 /* Select mode 1 */ |
| #define PIT_CMD_MODE2 0x04 /* Select mode 2 */ |
| #define PIT_CMD_MODE3 0x06 /* Select mode 3 */ |
| #define PIT_CMD_MODE4 0x08 /* Select mode 4 */ |
| #define PIT_CMD_MODE5 0x0a /* Select mode 5 */ |
| |
| /* The clock frequency of the i8253/i8254 PIT */ |
| #define PIT_TICK_RATE 1193182 |
| |
| /** |
| * i8254_enable_beep() - Start a beep using the PCAT timer |
| * |
| * This starts beeping using the legacy i8254 timer. The beep may be silenced |
| * after a delay with i8254_disable_beep(). |
| * |
| * @frequency_hz: Frequency of beep in Hz |
| * @return 0 if OK, -EINVAL if frequency_hz is 0 |
| */ |
| int i8254_enable_beep(uint frequency_hz); |
| |
| /** |
| * i8254_disable_beep() - Disable the bepper |
| * |
| * This stops any existing beep |
| */ |
| void i8254_disable_beep(void); |
| |
| #endif /* _ASMI386_I8254_H_ */ |