drivers/gpio/intel_ich6_gpio.c

/*
 * Copyright (c) 2012 The Chromium OS Authors.
 * SPDX-License-Identifier:	GPL-2.0+
 */

/*
 * This is a GPIO driver for Intel ICH6 and later. The x86 GPIOs are accessed
 * through the PCI bus. Each PCI device has 256 bytes of configuration space,
 * consisting of a standard header and a device-specific set of registers. PCI
 * bus 0, device 31, function 0 gives us access to the chipset GPIOs (among
 * other things). Within the PCI configuration space, the GPIOBASE register
 * tells us where in the device's I/O region we can find more registers to
 * actually access the GPIOs.
 *
 * PCI bus/device/function 0:1f:0  => PCI config registers
 *   PCI config register "GPIOBASE"
 *     PCI I/O space + [GPIOBASE]  => start of GPIO registers
 *       GPIO registers => gpio pin function, direction, value
 *
 *
 * Danger Will Robinson! Bank 0 (GPIOs 0-31) seems to be fairly stable. Most
 * ICH versions have more, but the decoding the matrix that describes them is
 * absurdly complex and constantly changing. We'll provide Bank 1 and Bank 2,
 * but they will ONLY work for certain unspecified chipsets because the offset
 * from GPIOBASE changes randomly. Even then, many GPIOs are unimplemented or
 * reserved or subject to arcane restrictions.
 */

#include <common.h>
#include <dm.h>
#include <errno.h>
#include <fdtdec.h>
#include <pci.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/pci.h>
#ifdef CONFIG_X86_RESET_VECTOR
#include <asm/arch/pch.h>
#define SUPPORT_GPIO_SETUP
#endif

#define GPIO_PER_BANK	32

/* Where in config space is the register that points to the GPIO registers? */
#define PCI_CFG_GPIOBASE 0x48

struct ich6_bank_priv {
	/* These are I/O addresses */
	uint32_t use_sel;
	uint32_t io_sel;
	uint32_t lvl;
};

#ifdef SUPPORT_GPIO_SETUP
static void setup_pch_gpios(const struct pch_gpio_map *gpio)
{
	u16 gpiobase = pci_read_config16(PCH_LPC_DEV, GPIO_BASE) & 0xfffc;

	/* GPIO Set 1 */
	if (gpio->set1.level)
		outl(*((u32 *)gpio->set1.level), gpiobase + GP_LVL);
	if (gpio->set1.mode)
		outl(*((u32 *)gpio->set1.mode), gpiobase + GPIO_USE_SEL);
	if (gpio->set1.direction)
		outl(*((u32 *)gpio->set1.direction), gpiobase + GP_IO_SEL);
	if (gpio->set1.reset)
		outl(*((u32 *)gpio->set1.reset), gpiobase + GP_RST_SEL1);
	if (gpio->set1.invert)
		outl(*((u32 *)gpio->set1.invert), gpiobase + GPI_INV);
	if (gpio->set1.blink)
		outl(*((u32 *)gpio->set1.blink), gpiobase + GPO_BLINK);

	/* GPIO Set 2 */
	if (gpio->set2.level)
		outl(*((u32 *)gpio->set2.level), gpiobase + GP_LVL2);
	if (gpio->set2.mode)
		outl(*((u32 *)gpio->set2.mode), gpiobase + GPIO_USE_SEL2);
	if (gpio->set2.direction)
		outl(*((u32 *)gpio->set2.direction), gpiobase + GP_IO_SEL2);
	if (gpio->set2.reset)
		outl(*((u32 *)gpio->set2.reset), gpiobase + GP_RST_SEL2);

	/* GPIO Set 3 */
	if (gpio->set3.level)
		outl(*((u32 *)gpio->set3.level), gpiobase + GP_LVL3);
	if (gpio->set3.mode)
		outl(*((u32 *)gpio->set3.mode), gpiobase + GPIO_USE_SEL3);
	if (gpio->set3.direction)
		outl(*((u32 *)gpio->set3.direction), gpiobase + GP_IO_SEL3);
	if (gpio->set3.reset)
		outl(*((u32 *)gpio->set3.reset), gpiobase + GP_RST_SEL3);
}

/* TODO: Move this to device tree, or platform data */
void ich_gpio_set_gpio_map(const struct pch_gpio_map *map)
{
	gd->arch.gpio_map = map;
}
#endif /* SUPPORT_GPIO_SETUP */

static int gpio_ich6_ofdata_to_platdata(struct udevice *dev)
{
	struct ich6_bank_platdata *plat = dev_get_platdata(dev);
	pci_dev_t pci_dev;			/* handle for 0:1f:0 */
	u8 tmpbyte;
	u16 tmpword;
	u32 tmplong;
	u32 gpiobase;
	int offset;

	/* Where should it be? */
	pci_dev = PCI_BDF(0, 0x1f, 0);

	/* Is the device present? */
	tmpword = pci_read_config16(pci_dev, PCI_VENDOR_ID);
	if (tmpword != PCI_VENDOR_ID_INTEL) {
		debug("%s: wrong VendorID\n", __func__);
		return -ENODEV;
	}

	tmpword = pci_read_config16(pci_dev, PCI_DEVICE_ID);
	debug("Found %04x:%04x\n", PCI_VENDOR_ID_INTEL, tmpword);
	/*
	 * We'd like to validate the Device ID too, but pretty much any
	 * value is either a) correct with slight differences, or b)
	 * correct but undocumented. We'll have to check a bunch of other
	 * things instead...
	 */

	/* I/O should already be enabled (it's a RO bit). */
	tmpword = pci_read_config16(pci_dev, PCI_COMMAND);
	if (!(tmpword & PCI_COMMAND_IO)) {
		debug("%s: device IO not enabled\n", __func__);
		return -ENODEV;
	}

	/* Header Type must be normal (bits 6-0 only; see spec.) */
	tmpbyte = pci_read_config8(pci_dev, PCI_HEADER_TYPE);
	if ((tmpbyte & 0x7f) != PCI_HEADER_TYPE_NORMAL) {
		debug("%s: invalid Header type\n", __func__);
		return -ENODEV;
	}

	/* Base Class must be a bridge device */
	tmpbyte = pci_read_config8(pci_dev, PCI_CLASS_CODE);
	if (tmpbyte != PCI_CLASS_CODE_BRIDGE) {
		debug("%s: invalid class\n", __func__);
		return -ENODEV;
	}
	/* Sub Class must be ISA */
	tmpbyte = pci_read_config8(pci_dev, PCI_CLASS_SUB_CODE);
	if (tmpbyte != PCI_CLASS_SUB_CODE_BRIDGE_ISA) {
		debug("%s: invalid subclass\n", __func__);
		return -ENODEV;
	}

	/* Programming Interface must be 0x00 (no others exist) */
	tmpbyte = pci_read_config8(pci_dev, PCI_CLASS_PROG);
	if (tmpbyte != 0x00) {
		debug("%s: invalid interface type\n", __func__);
		return -ENODEV;
	}

	/*
	 * GPIOBASE moved to its current offset with ICH6, but prior to
	 * that it was unused (or undocumented). Check that it looks
	 * okay: not all ones or zeros, and mapped to I/O space (bit 0).
	 */
	tmplong = pci_read_config32(pci_dev, PCI_CFG_GPIOBASE);
	if (tmplong == 0x00000000 || tmplong == 0xffffffff ||
	    !(tmplong & 0x00000001)) {
		debug("%s: unexpected GPIOBASE value\n", __func__);
		return -ENODEV;
	}

	/*
	 * Okay, I guess we're looking at the right device. The actual
	 * GPIO registers are in the PCI device's I/O space, starting
	 * at the offset that we just read. Bit 0 indicates that it's
	 * an I/O address, not a memory address, so mask that off.
	 */
	gpiobase = tmplong & 0xfffffffe;
	offset = fdtdec_get_int(gd->fdt_blob, dev->of_offset, "reg", -1);
	if (offset == -1) {
		debug("%s: Invalid register offset %d\n", __func__, offset);
		return -EINVAL;
	}
	plat->base_addr = gpiobase + offset;
	plat->bank_name = fdt_getprop(gd->fdt_blob, dev->of_offset,
				      "bank-name", NULL);

	return 0;
}

static int ich6_gpio_probe(struct udevice *dev)
{
	struct ich6_bank_platdata *plat = dev_get_platdata(dev);
	struct gpio_dev_priv *uc_priv = dev->uclass_priv;
	struct ich6_bank_priv *bank = dev_get_priv(dev);

#ifdef SUPPORT_GPIO_SETUP
	if (gd->arch.gpio_map) {
		setup_pch_gpios(gd->arch.gpio_map);
		gd->arch.gpio_map = NULL;
	}
#endif
	uc_priv->gpio_count = GPIO_PER_BANK;
	uc_priv->bank_name = plat->bank_name;
	bank->use_sel = plat->base_addr;
	bank->io_sel = plat->base_addr + 4;
	bank->lvl = plat->base_addr + 8;

	return 0;
}

static int ich6_gpio_request(struct udevice *dev, unsigned offset,
			     const char *label)
{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 tmplong;

	/*
	 * Make sure that the GPIO pin we want isn't already in use for some
	 * built-in hardware function. We have to check this for every
	 * requested pin.
	 */
	tmplong = inl(bank->use_sel);
	if (!(tmplong & (1UL << offset))) {
		debug("%s: gpio %d is reserved for internal use\n", __func__,
		      offset);
		return -EPERM;
	}

	return 0;
}

static int ich6_gpio_direction_input(struct udevice *dev, unsigned offset)
{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 tmplong;

	tmplong = inl(bank->io_sel);
	tmplong |= (1UL << offset);
	outl(bank->io_sel, tmplong);
	return 0;
}

static int ich6_gpio_direction_output(struct udevice *dev, unsigned offset,
				       int value)
{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 tmplong;

	tmplong = inl(bank->io_sel);
	tmplong &= ~(1UL << offset);
	outl(bank->io_sel, tmplong);
	return 0;
}

static int ich6_gpio_get_value(struct udevice *dev, unsigned offset)

{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 tmplong;
	int r;

	tmplong = inl(bank->lvl);
	r = (tmplong & (1UL << offset)) ? 1 : 0;
	return r;
}

static int ich6_gpio_set_value(struct udevice *dev, unsigned offset,
			       int value)
{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 tmplong;

	tmplong = inl(bank->lvl);
	if (value)
		tmplong |= (1UL << offset);
	else
		tmplong &= ~(1UL << offset);
	outl(bank->lvl, tmplong);
	return 0;
}

static int ich6_gpio_get_function(struct udevice *dev, unsigned offset)
{
	struct ich6_bank_priv *bank = dev_get_priv(dev);
	u32 mask = 1UL << offset;

	if (!(inl(bank->use_sel) & mask))
		return GPIOF_FUNC;
	if (inl(bank->io_sel) & mask)
		return GPIOF_INPUT;
	else
		return GPIOF_OUTPUT;
}

static const struct dm_gpio_ops gpio_ich6_ops = {
	.request		= ich6_gpio_request,
	.direction_input	= ich6_gpio_direction_input,
	.direction_output	= ich6_gpio_direction_output,
	.get_value		= ich6_gpio_get_value,
	.set_value		= ich6_gpio_set_value,
	.get_function		= ich6_gpio_get_function,
};

static const struct udevice_id intel_ich6_gpio_ids[] = {
	{ .compatible = "intel,ich6-gpio" },
	{ }
};

U_BOOT_DRIVER(gpio_ich6) = {
	.name	= "gpio_ich6",
	.id	= UCLASS_GPIO,
	.of_match = intel_ich6_gpio_ids,
	.ops	= &gpio_ich6_ops,
	.ofdata_to_platdata	= gpio_ich6_ofdata_to_platdata,
	.probe	= ich6_gpio_probe,
	.priv_auto_alloc_size = sizeof(struct ich6_bank_priv),
	.platdata_auto_alloc_size = sizeof(struct ich6_bank_platdata),
};