| CONFIG_ARM=y |
| CONFIG_SKIP_LOWLEVEL_INIT=y |
| CONFIG_TARGET_LS1021ATWR=y |
| CONFIG_SYS_TEXT_BASE=0x60100000 |
| CONFIG_SYS_MALLOC_LEN=0x1020000 |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_SYS_MEMTEST_START=0x80000000 |
| CONFIG_SYS_MEMTEST_END=0x9fffffff |
| CONFIG_ENV_SIZE=0x20000 |
| CONFIG_ENV_SECT_SIZE=0x20000 |
| CONFIG_SYS_I2C_MXC_I2C1=y |
| CONFIG_SYS_I2C_MXC_I2C2=y |
| CONFIG_SYS_I2C_MXC_I2C3=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-lpuart" |
| CONFIG_AHCI=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_SYS_LOAD_ADDR=0x82000000 |
| CONFIG_FIT=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_OF_STDOUT_VIA_ALIAS=y |
| CONFIG_SYS_EXTRA_OPTIONS="LPUART" |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0" |
| CONFIG_BOOTCOMMAND="run distro_bootcmd; run nor_bootcmd;env exists secureboot && esbc_halt;" |
| CONFIG_SILENT_CONSOLE=y |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| CONFIG_MISC_INIT_R=y |
| CONFIG_ID_EEPROM=y |
| CONFIG_CMD_IMLS=y |
| CONFIG_CMD_GREPENV=y |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| CONFIG_CMD_MEMINFO=y |
| CONFIG_CMD_MEMTEST=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPT=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_USB=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_FLASH=y |
| CONFIG_ENV_ADDR=0x60300000 |
| CONFIG_DM=y |
| CONFIG_SATA=y |
| CONFIG_SATA_CEVA=y |
| CONFIG_FSL_CAAM=y |
| CONFIG_MPC8XXX_GPIO=y |
| CONFIG_DM_I2C=y |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x53 |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_NOR_FLASH=y |
| CONFIG_FLASH_CFI_DRIVER=y |
| CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y |
| CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y |
| CONFIG_SYS_FLASH_CFI=y |
| CONFIG_PHY_ATHEROS=y |
| CONFIG_DM_ETH=y |
| CONFIG_DM_MDIO=y |
| CONFIG_PHY_GIGE=y |
| CONFIG_E1000=y |
| CONFIG_MII=y |
| CONFIG_TSEC_ENET=y |
| CONFIG_NVME_PCI=y |
| CONFIG_PCI=y |
| CONFIG_PCIE_LAYERSCAPE_RC=y |
| CONFIG_SYS_QE_FW_ADDR=0x60940000 |
| CONFIG_DM_SCSI=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_FSL_LPUART=y |
| CONFIG_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |