| CONFIG_ARM=y |
| CONFIG_TARGET_LS1021AIOT=y |
| CONFIG_SYS_TEXT_BASE=0x82000000 |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_SIZE=0x2000 |
| CONFIG_ENV_OFFSET=0x100000 |
| CONFIG_SYS_I2C_MXC_I2C1=y |
| CONFIG_SYS_I2C_MXC_I2C2=y |
| CONFIG_SYS_I2C_MXC_I2C3=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="ls1021a-iot-duart" |
| CONFIG_SPL_TEXT_BASE=0x10000000 |
| CONFIG_SPL_SERIAL_SUPPORT=y |
| CONFIG_SPL=y |
| CONFIG_AHCI=y |
| CONFIG_SYS_LOAD_ADDR=0x82000000 |
| CONFIG_SYS_EXTRA_OPTIONS="SD_BOOT,SD_BOOT_QSPI" |
| CONFIG_RAMBOOT_PBL=y |
| CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021aiot/ls102xa_pbi.cfg" |
| CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021aiot/ls102xa_rcw_sd.cfg" |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_MISC_INIT_R=y |
| CONFIG_ID_EEPROM=y |
| CONFIG_SPL_FSL_PBL=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8 |
| CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y |
| CONFIG_CMD_BOOTZ=y |
| CONFIG_CMD_GREPENV=y |
| CONFIG_SYS_I2C_EEPROM_ADDR_LEN=2 |
| CONFIG_CMD_MEMINFO=y |
| CONFIG_CMD_GPT=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| # CONFIG_CMD_MDIO is not set |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_EXT2=y |
| CONFIG_CMD_FAT=y |
| # CONFIG_SPL_EFI_PARTITION is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_MMC=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_DM=y |
| CONFIG_SATA_CEVA=y |
| CONFIG_FSL_CAAM=y |
| CONFIG_DM_I2C=y |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x51 |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_SPI_FLASH_ATMEL=y |
| CONFIG_SPI_FLASH_STMICRO=y |
| CONFIG_PHY_ATHEROS=y |
| CONFIG_PHY_GIGE=y |
| CONFIG_E1000=y |
| CONFIG_MII=y |
| CONFIG_TSEC_ENET=y |
| CONFIG_NVME=y |
| CONFIG_PCI=y |
| CONFIG_DM_PCI_COMPAT=y |
| CONFIG_PCIE_LAYERSCAPE_RC=y |
| CONFIG_DM_SCSI=y |
| CONFIG_SYS_NS16550=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_FSL_DSPI=y |
| CONFIG_FSL_QSPI=y |
| CONFIG_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |