| /* |
| * Copyright (C) 2012-2015 Panasonic Corporation |
| * Copyright (C) 2015 Socionext Inc. |
| * Author: Masahiro Yamada <yamada.masahiro@socionext.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <mach/board.h> |
| |
| #if defined(CONFIG_PFC_MICRO_SUPPORT_CARD) |
| |
| #define PFC_MICRO_SUPPORT_CARD_RESET \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x000D0034) |
| #define PFC_MICRO_SUPPORT_CARD_REVISION \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x000D00E0) |
| /* |
| * 0: reset deassert, 1: reset |
| * |
| * bit[0]: LAN, I2C, LED |
| * bit[1]: UART |
| */ |
| void support_card_reset_deassert(void) |
| { |
| writel(0, PFC_MICRO_SUPPORT_CARD_RESET); |
| } |
| |
| void support_card_reset(void) |
| { |
| writel(3, PFC_MICRO_SUPPORT_CARD_RESET); |
| } |
| |
| static int support_card_show_revision(void) |
| { |
| u32 revision; |
| |
| revision = readl(PFC_MICRO_SUPPORT_CARD_REVISION); |
| printf("(PFC CPLD version %d.%d)\n", revision >> 4, revision & 0xf); |
| return 0; |
| } |
| #endif |
| |
| #if defined(CONFIG_DCC_MICRO_SUPPORT_CARD) |
| |
| #define DCC_MICRO_SUPPORT_CARD_RESET_LAN \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x00401300) |
| #define DCC_MICRO_SUPPORT_CARD_RESET_UART \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x00401304) |
| #define DCC_MICRO_SUPPORT_CARD_RESET_I2C \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x00401308) |
| #define DCC_MICRO_SUPPORT_CARD_REVISION \ |
| ((CONFIG_SUPPORT_CARD_BASE) + 0x005000E0) |
| |
| void support_card_reset_deassert(void) |
| { |
| writel(1, DCC_MICRO_SUPPORT_CARD_RESET_LAN); /* LAN and LED */ |
| writel(1, DCC_MICRO_SUPPORT_CARD_RESET_UART); /* UART */ |
| writel(1, DCC_MICRO_SUPPORT_CARD_RESET_I2C); /* I2C */ |
| } |
| |
| void support_card_reset(void) |
| { |
| writel(0, DCC_MICRO_SUPPORT_CARD_RESET_LAN); /* LAN and LED */ |
| writel(0, DCC_MICRO_SUPPORT_CARD_RESET_UART); /* UART */ |
| writel(0, DCC_MICRO_SUPPORT_CARD_RESET_I2C); /* I2C */ |
| } |
| |
| static int support_card_show_revision(void) |
| { |
| u32 revision; |
| |
| revision = readl(DCC_MICRO_SUPPORT_CARD_REVISION); |
| |
| if (revision >= 0x67) { |
| printf("(DCC CPLD version 3.%d.%d)\n", |
| revision >> 4, revision & 0xf); |
| return 0; |
| } else { |
| printf("(DCC CPLD unknown version)\n"); |
| return -1; |
| } |
| } |
| #endif |
| |
| int check_support_card(void) |
| { |
| printf("SC: Micro Support Card "); |
| return support_card_show_revision(); |
| } |
| |
| void support_card_init(void) |
| { |
| /* |
| * After power on, we need to keep the LAN controller in reset state |
| * for a while. (200 usec) |
| * Fortunately, enough wait time is already inserted in pll_init() |
| * function. So we do not have to wait here. |
| */ |
| support_card_reset_deassert(); |
| } |
| |
| #if defined(CONFIG_SMC911X) |
| #include <netdev.h> |
| |
| int board_eth_init(bd_t *bis) |
| { |
| return smc911x_initialize(0, CONFIG_SMC911X_BASE); |
| } |
| #endif |
| |
| #if !defined(CONFIG_SYS_NO_FLASH) |
| |
| #include <mtd/cfi_flash.h> |
| #include <mach/sbc-regs.h> |
| |
| struct memory_bank { |
| phys_addr_t base; |
| unsigned long size; |
| }; |
| |
| static int mem_is_flash(const struct memory_bank *mem) |
| { |
| const int loop = 128; |
| u32 *scratch_addr; |
| u32 saved_value; |
| int ret = 1; |
| int i; |
| |
| /* just in case, use the tail of the memory bank */ |
| scratch_addr = map_physmem(mem->base + mem->size - sizeof(u32) * loop, |
| sizeof(u32) * loop, MAP_NOCACHE); |
| |
| for (i = 0; i < loop; i++, scratch_addr++) { |
| saved_value = readl(scratch_addr); |
| writel(~saved_value, scratch_addr); |
| if (readl(scratch_addr) != saved_value) { |
| /* We assume no memory or SRAM here. */ |
| writel(saved_value, scratch_addr); |
| ret = 0; |
| break; |
| } |
| } |
| |
| unmap_physmem(scratch_addr, MAP_NOCACHE); |
| |
| return ret; |
| } |
| |
| #if defined(CONFIG_PFC_MICRO_SUPPORT_CARD) |
| /* {address, size} */ |
| static const struct memory_bank memory_banks_boot_swap_off[] = { |
| {0x02000000, 0x01f00000}, |
| }; |
| |
| static const struct memory_bank memory_banks_boot_swap_on[] = { |
| {0x00000000, 0x01f00000}, |
| }; |
| #endif |
| |
| #if defined(CONFIG_DCC_MICRO_SUPPORT_CARD) |
| static const struct memory_bank memory_banks_boot_swap_off[] = { |
| {0x04000000, 0x02000000}, |
| }; |
| |
| static const struct memory_bank memory_banks_boot_swap_on[] = { |
| {0x00000000, 0x02000000}, |
| {0x04000000, 0x02000000}, |
| }; |
| #endif |
| |
| static const struct memory_bank |
| *flash_banks_list[CONFIG_SYS_MAX_FLASH_BANKS_DETECT]; |
| |
| phys_addr_t cfi_flash_bank_addr(int i) |
| { |
| return flash_banks_list[i]->base; |
| } |
| |
| unsigned long cfi_flash_bank_size(int i) |
| { |
| return flash_banks_list[i]->size; |
| } |
| |
| static void detect_num_flash_banks(void) |
| { |
| const struct memory_bank *memory_bank, *end; |
| |
| cfi_flash_num_flash_banks = 0; |
| |
| if (boot_is_swapped()) { |
| memory_bank = memory_banks_boot_swap_on; |
| end = memory_bank + ARRAY_SIZE(memory_banks_boot_swap_on); |
| } else { |
| memory_bank = memory_banks_boot_swap_off; |
| end = memory_bank + ARRAY_SIZE(memory_banks_boot_swap_off); |
| } |
| |
| for (; memory_bank < end; memory_bank++) { |
| if (cfi_flash_num_flash_banks >= |
| CONFIG_SYS_MAX_FLASH_BANKS_DETECT) |
| break; |
| |
| if (mem_is_flash(memory_bank)) { |
| flash_banks_list[cfi_flash_num_flash_banks] = |
| memory_bank; |
| |
| debug("flash bank found: base = 0x%lx, size = 0x%lx\n", |
| memory_bank->base, memory_bank->size); |
| cfi_flash_num_flash_banks++; |
| } |
| } |
| |
| debug("number of flash banks: %d\n", cfi_flash_num_flash_banks); |
| } |
| #else /* CONFIG_SYS_NO_FLASH */ |
| void detect_num_flash_banks(void) |
| { |
| }; |
| #endif /* CONFIG_SYS_NO_FLASH */ |
| |
| void support_card_late_init(void) |
| { |
| detect_num_flash_banks(); |
| } |