| CONFIG_ARM=y |
| CONFIG_GIC_V3_ITS=y |
| CONFIG_TARGET_LS1088ARDB=y |
| CONFIG_TEXT_BASE=0x80400000 |
| CONFIG_SYS_MALLOC_LEN=0x202000 |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y |
| CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x1800fff0 |
| CONFIG_ENV_SIZE=0x2000 |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1088a-rdb" |
| CONFIG_SPL_TEXT_BASE=0x1800a000 |
| CONFIG_FSL_LS_PPA=y |
| CONFIG_SYS_MONITOR_LEN=1064960 |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL_DRIVERS_MISC=y |
| CONFIG_SPL_STACK=0x18009ff0 |
| CONFIG_SPL=y |
| CONFIG_PCI=y |
| CONFIG_NXP_ESBC=y |
| CONFIG_FSL_USE_PCA9547_MUX=y |
| CONFIG_VID=y |
| CONFIG_SPL_VID=y |
| CONFIG_VID_FLS_ENV="ls1088ardb_vdd_mv" |
| CONFIG_VOL_MONITOR_LTC3882_READ=y |
| CONFIG_VOL_MONITOR_LTC3882_SET=y |
| CONFIG_SYS_FSL_NUM_CC_PLLS=3 |
| CONFIG_FSL_QIXIS=y |
| CONFIG_SYS_MEMTEST_START=0x80000000 |
| CONFIG_SYS_MEMTEST_END=0x9fffffff |
| # CONFIG_SYS_MALLOC_F is not set |
| CONFIG_REMAKE_ELF=y |
| CONFIG_MP=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_SD_BOOT=y |
| CONFIG_SD_BOOT_QSPI=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x3000000 default_hugepagesz=2m hugepagesz=2m hugepages=256" |
| # CONFIG_USE_BOOTCOMMAND is not set |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_DISPLAY_BOARDINFO_LATE=y |
| CONFIG_MISC_INIT_R=y |
| CONFIG_RESET_PHY_R=y |
| CONFIG_SPL_MAX_SIZE=0x16000 |
| CONFIG_SPL_HAS_BSS_LINKER_SECTION=y |
| CONFIG_SPL_BSS_START_ADDR=0x80100000 |
| CONFIG_SPL_BSS_MAX_SIZE=0x100000 |
| # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set |
| CONFIG_SYS_SPL_MALLOC=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x8b0 |
| CONFIG_SPL_ENV_SUPPORT=y |
| CONFIG_SPL_I2C=y |
| CONFIG_SPL_MPC8XXX_INIT_DDR=y |
| CONFIG_SPL_TARGET="u-boot-with-spl.bin" |
| CONFIG_SYS_MAXARGS=64 |
| CONFIG_SYS_PBSIZE=532 |
| CONFIG_CMD_GREPENV=y |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| CONFIG_CMD_MEMINFO=y |
| CONFIG_CMD_MEMTEST=y |
| CONFIG_CMD_DM=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND=y |
| CONFIG_CMD_PCI=y |
| CONFIG_CMD_USB=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_CACHE=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_SPL_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="DPMAC1@xgmii" |
| CONFIG_NET_RANDOM_ETHADDR=y |
| CONFIG_SPL_DM=y |
| CONFIG_SCSI_AHCI=y |
| # CONFIG_SPL_BLK is not set |
| CONFIG_DDR_ECC=y |
| CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y |
| CONFIG_MPC8XXX_GPIO=y |
| CONFIG_SYS_I2C_LEGACY=y |
| CONFIG_SYS_MXC_I2C1_SPEED=40000000 |
| CONFIG_SYS_MXC_I2C2_SPEED=40000000 |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x57 |
| # CONFIG_SPL_DM_MMC is not set |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_FSL_IFC=y |
| CONFIG_SYS_NAND_ONFI_DETECTION=y |
| CONFIG_SYS_NAND_MAX_OOBFREE=2 |
| CONFIG_SYS_NAND_MAX_ECCPOS=256 |
| CONFIG_DM_SPI_FLASH=y |
| # CONFIG_SPI_FLASH_BAR is not set |
| CONFIG_SPI_FLASH_SPANSION=y |
| # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set |
| CONFIG_PHYLIB=y |
| CONFIG_PHY_VITESSE=y |
| CONFIG_FSL_MEMAC=y |
| CONFIG_SYS_MEMAC_LITTLE_ENDIAN=y |
| CONFIG_PHY_GIGE=y |
| CONFIG_E1000=y |
| CONFIG_MII=y |
| CONFIG_PCIE_LAYERSCAPE_RC=y |
| CONFIG_SCSI_AHCI_PLAT=y |
| CONFIG_SYS_NS16550_SERIAL=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_FSL_DSPI=y |
| CONFIG_FSL_QSPI=y |
| CONFIG_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |
| CONFIG_USB_DWC3=y |
| CONFIG_RSA=y |
| CONFIG_SPL_RSA=y |