| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2019 NXP |
| */ |
| |
| #include "imx8mm-u-boot.dtsi" |
| |
| / { |
| binman: binman { |
| multiple-images; |
| }; |
| |
| wdt-reboot { |
| compatible = "wdt-reboot"; |
| wdt = <&wdog1>; |
| u-boot,dm-spl; |
| }; |
| |
| firmware { |
| optee { |
| compatible = "linaro,optee-tz"; |
| method = "smc"; |
| }; |
| }; |
| }; |
| |
| ®_usdhc2_vmmc { |
| u-boot,off-on-delay-us = <20000>; |
| }; |
| |
| &pinctrl_reg_usdhc2_vmmc { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_uart2 { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_usdhc2_gpio { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_usdhc2 { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_usdhc3 { |
| u-boot,dm-spl; |
| }; |
| |
| &gpio1 { |
| u-boot,dm-spl; |
| }; |
| |
| &gpio2 { |
| u-boot,dm-spl; |
| }; |
| |
| &gpio3 { |
| u-boot,dm-spl; |
| }; |
| |
| &gpio4 { |
| u-boot,dm-spl; |
| }; |
| |
| &gpio5 { |
| u-boot,dm-spl; |
| }; |
| |
| &uart2 { |
| u-boot,dm-spl; |
| }; |
| |
| &usdhc1 { |
| u-boot,dm-spl; |
| }; |
| |
| &usdhc2 { |
| u-boot,dm-spl; |
| sd-uhs-sdr104; |
| sd-uhs-ddr50; |
| fsl,signal-voltage-switch-extra-delay-ms = <8>; |
| }; |
| |
| &usdhc3 { |
| u-boot,dm-spl; |
| mmc-hs400-1_8v; |
| mmc-hs400-enhanced-strobe; |
| }; |
| |
| &i2c1 { |
| u-boot,dm-spl; |
| }; |
| |
| &{/soc@0/bus@30800000/i2c@30a20000/pca9450@25} { |
| u-boot,dm-spl; |
| }; |
| |
| &{/soc@0/bus@30800000/i2c@30a20000/pca9450@25/regulators} { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_i2c1 { |
| u-boot,dm-spl; |
| }; |
| |
| &pinctrl_pmic { |
| u-boot,dm-spl; |
| }; |
| |
| &fec1 { |
| phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>; |
| }; |
| |
| &wdog1 { |
| u-boot,dm-spl; |
| }; |
| |
| &binman { |
| u-boot-spl-ddr { |
| filename = "u-boot-spl-ddr.bin"; |
| pad-byte = <0xff>; |
| align-size = <4>; |
| align = <4>; |
| |
| u-boot-spl { |
| align-end = <4>; |
| }; |
| |
| blob_1: blob-ext@1 { |
| filename = "lpddr4_pmu_train_1d_imem.bin"; |
| size = <0x8000>; |
| }; |
| |
| blob_2: blob-ext@2 { |
| filename = "lpddr4_pmu_train_1d_dmem.bin"; |
| size = <0x4000>; |
| }; |
| |
| blob_3: blob-ext@3 { |
| filename = "lpddr4_pmu_train_2d_imem.bin"; |
| size = <0x8000>; |
| }; |
| |
| blob_4: blob-ext@4 { |
| filename = "lpddr4_pmu_train_2d_dmem.bin"; |
| size = <0x4000>; |
| }; |
| }; |
| |
| |
| spl { |
| filename = "spl.bin"; |
| |
| mkimage { |
| args = "-n spl/u-boot-spl.cfgout -T imx8mimage -e 0x7e1000"; |
| |
| blob { |
| filename = "u-boot-spl-ddr.bin"; |
| }; |
| }; |
| }; |
| |
| itb { |
| filename = "u-boot.itb"; |
| |
| fit { |
| description = "Configuration to load ATF before U-Boot"; |
| #address-cells = <1>; |
| fit,external-offset = <CONFIG_FIT_EXTERNAL_OFFSET>; |
| |
| images { |
| uboot { |
| description = "U-Boot (64-bit)"; |
| type = "standalone"; |
| arch = "arm64"; |
| compression = "none"; |
| load = <CONFIG_SYS_TEXT_BASE>; |
| |
| uboot_blob: blob-ext { |
| filename = "u-boot-nodtb.bin"; |
| }; |
| }; |
| |
| atf { |
| description = "ARM Trusted Firmware"; |
| type = "firmware"; |
| arch = "arm64"; |
| compression = "none"; |
| load = <0x920000>; |
| entry = <0x920000>; |
| |
| atf_blob: blob-ext { |
| filename = "bl31.bin"; |
| }; |
| }; |
| |
| fdt { |
| description = "NAME"; |
| type = "flat_dt"; |
| compression = "none"; |
| |
| uboot_fdt_blob: blob-ext { |
| filename = "u-boot.dtb"; |
| }; |
| }; |
| }; |
| |
| configurations { |
| default = "conf"; |
| |
| conf { |
| description = "NAME"; |
| firmware = "uboot"; |
| loadables = "atf"; |
| fdt = "fdt"; |
| }; |
| }; |
| }; |
| }; |
| |
| imx-boot { |
| filename = "flash.bin"; |
| pad-byte = <0x00>; |
| |
| spl: blob-ext@1 { |
| offset = <0x0>; |
| filename = "spl.bin"; |
| }; |
| |
| uboot: blob-ext@2 { |
| offset = <0x57c00>; |
| filename = "u-boot.itb"; |
| }; |
| }; |
| }; |