| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2014-2016 |
| * Stefan Agner <stefan@agner.ch> |
| */ |
| |
| #include <common.h> |
| #include <env.h> |
| #include <init.h> |
| #include <asm/arch/gp_padctrl.h> |
| #include <asm/arch/pinmux.h> |
| #include <asm/arch-tegra/ap.h> |
| #include <asm/arch-tegra/tegra.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| #include <fdt_support.h> |
| #include <i2c.h> |
| #include <linux/delay.h> |
| #include "pinmux-config-colibri_t30.h" |
| #include "../common/tdx-common.h" |
| |
| int arch_misc_init(void) |
| { |
| if (readl(NV_PA_BASE_SRAM + NVBOOTINFOTABLE_BOOTTYPE) == |
| NVBOOTTYPE_RECOVERY) |
| printf("USB recovery mode\n"); |
| |
| return 0; |
| } |
| |
| int checkboard(void) |
| { |
| puts("Model: Toradex Colibri T30 1GB\n"); |
| |
| return 0; |
| } |
| |
| #if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) |
| int ft_board_setup(void *blob, struct bd_info *bd) |
| { |
| u8 enetaddr[6]; |
| |
| /* MAC addr */ |
| if (eth_env_get_enetaddr("ethaddr", enetaddr)) { |
| int err = fdt_find_and_setprop(blob, |
| "/usb@7d004000/ethernet@1", |
| "local-mac-address", enetaddr, 6, 0); |
| |
| /* Older device trees might have used a different node name */ |
| if (err < 0) |
| err = fdt_find_and_setprop(blob, |
| "/usb@7d004000/asix@1", |
| "local-mac-address", enetaddr, 6, 0); |
| |
| if (err >= 0) |
| puts(" MAC address updated...\n"); |
| } |
| |
| return ft_common_board_setup(blob, bd); |
| } |
| #endif |
| |
| /* |
| * Routine: pinmux_init |
| * Description: Do individual peripheral pinmux configs |
| */ |
| void pinmux_init(void) |
| { |
| pinmux_config_pingrp_table(tegra3_pinmux_common, |
| ARRAY_SIZE(tegra3_pinmux_common)); |
| |
| pinmux_config_pingrp_table(unused_pins_lowpower, |
| ARRAY_SIZE(unused_pins_lowpower)); |
| |
| /* Initialize any non-default pad configs (APB_MISC_GP regs) */ |
| pinmux_config_drvgrp_table(colibri_t30_padctrl, |
| ARRAY_SIZE(colibri_t30_padctrl)); |
| } |
| |
| /* |
| * Disable RS232 serial transceiver ForceOFF# pins on Iris |
| */ |
| void gpio_early_init_uart(void) |
| { |
| gpio_request(TEGRA_GPIO(X, 6), "Force OFF# X13"); |
| gpio_direction_output(TEGRA_GPIO(X, 6), 1); |
| gpio_request(TEGRA_GPIO(X, 7), "Force OFF# X14"); |
| gpio_direction_output(TEGRA_GPIO(X, 7), 1); |
| } |
| |
| /* |
| * Enable AX88772B USB to LAN controller |
| */ |
| void pin_mux_usb(void) |
| { |
| /* Reset ASIX using LAN_RESET */ |
| gpio_request(TEGRA_GPIO(DD, 0), "LAN_RESET"); |
| gpio_direction_output(TEGRA_GPIO(DD, 0), 0); |
| udelay(5); |
| gpio_set_value(TEGRA_GPIO(DD, 0), 1); |
| } |
| |
| /* |
| * Backlight off before OS handover |
| */ |
| void board_preboot_os(void) |
| { |
| gpio_request(TEGRA_GPIO(V, 2), "BL_ON"); |
| gpio_direction_output(TEGRA_GPIO(V, 2), 0); |
| } |