| .. SPDX-License-Identifier: GPL-2.0+: |
| |
| loady command |
| ============= |
| |
| Synopsis |
| -------- |
| |
| :: |
| |
| loady [addr [baud]] |
| |
| Description |
| ----------- |
| |
| The loady command is used to transfer a file to the device via the serial line |
| using the YMODEM protocol. |
| |
| The number of transferred bytes is saved in environment variable filesize. |
| |
| addr |
| load address, defaults to environment variable loadaddr or if loadaddr is |
| not set to configuration variable CONFIG_SYS_LOAD_ADDR |
| |
| baud |
| baud rate for the ymodem transmission. After the transmission the baud |
| rate is reset to the original value. |
| |
| Example |
| ------- |
| |
| In the example below the terminal emulation program picocom was used to |
| transfer a file to the device. |
| |
| After entering the loady command the key sequence <CTRL-A><CTRL-S> is used to |
| let picocom prompt for the file name. Picocom invokes the program sz for the |
| file transfer. |
| |
| :: |
| |
| => loady 80064000 115200 |
| ## Ready for binary (ymodem) download to 0x80064000 at 115200 bps... |
| C |
| *** file: BOOTRISCV64.EFI |
| $ sz -b -vv BOOTRISCV64.EFI |
| Sending: BOOTRISCV64.EFI |
| Bytes Sent: 398976 BPS:7883 |
| Sending: |
| Ymodem sectors/kbytes sent: 0/ 0k |
| Transfer complete |
| |
| *** exit status: 0 *** |
| /1(CAN) packets, 4 retries |
| ## Total Size = 0x0006165f = 398943 Bytes |
| => echo ${filesize} |
| 6165f |
| => |
| |
| Configuration |
| ------------- |
| |
| The command is only available if CONFIG_CMD_LOADB=y. |
| |
| Initial timeout in seconds while waiting for transfer is configured by |
| config option CMD_LOADXY_TIMEOUT or by env variable $loadxy_timeout. |
| Setting it to 0 means infinite timeout. |
| |
| Transfer can be cancelled by pressing 3 times <CTRL+C> after two seconds |
| of inactivity on terminal. |
| |
| Return value |
| ------------ |
| |
| The return value $? is always 0 (true). |