| CONFIG_ARM=y |
| # CONFIG_SPL_USE_ARCH_MEMCPY is not set |
| # CONFIG_SPL_USE_ARCH_MEMSET is not set |
| CONFIG_ARCH_AT91=y |
| CONFIG_TARGET_CORVUS=y |
| CONFIG_SPL_GPIO_SUPPORT=y |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_SYS_MALLOC_F_LEN=0x800 |
| CONFIG_SPL_SERIAL_SUPPORT=y |
| CONFIG_SPL_NAND_SUPPORT=y |
| CONFIG_DEFAULT_DEVICE_TREE="at91sam9g45-corvus" |
| CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9M10G45,MACH_TYPE=2066,SYS_USE_NANDFLASH" |
| CONFIG_BOOTDELAY=3 |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_SPL=y |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_PROMPT="U-Boot> " |
| # CONFIG_CMD_BDI is not set |
| CONFIG_CMD_BOOTZ=y |
| # CONFIG_CMD_IMI is not set |
| # CONFIG_CMD_IMLS is not set |
| # CONFIG_CMD_LOADS is not set |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_DFU=y |
| # CONFIG_CMD_FPGA is not set |
| CONFIG_CMD_GPIO=y |
| # CONFIG_CMD_SOURCE is not set |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_PING=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_OF_EMBED=y |
| CONFIG_CLK=y |
| CONFIG_CLK_AT91=y |
| CONFIG_AT91_UTMI=y |
| CONFIG_DFU_NAND=y |
| # CONFIG_MMC is not set |
| # CONFIG_SPL_DM_SERIAL is not set |
| CONFIG_ATMEL_USART=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_USB_STORAGE=y |
| CONFIG_USB_GADGET=y |
| CONFIG_USB_GADGET_ATMEL_USBA=y |
| CONFIG_USB_GADGET_DOWNLOAD=y |
| CONFIG_G_DNL_MANUFACTURER="Siemens AG" |
| CONFIG_G_DNL_VENDOR_NUM=0x0908 |
| CONFIG_G_DNL_PRODUCT_NUM=0x02d2 |
| # CONFIG_EFI_LOADER is not set |