| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Primary-to-Sideband Bridge |
| * |
| * Copyright 2019 Google LLC |
| */ |
| |
| #define LOG_CATEGORY UCLASS_P2SB |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <dt-structs.h> |
| #include <p2sb.h> |
| #include <spl.h> |
| #include <asm/pci.h> |
| |
| struct p2sb_platdata { |
| #if CONFIG_IS_ENABLED(OF_PLATDATA) |
| struct dtd_intel_apl_p2sb dtplat; |
| #endif |
| ulong mmio_base; |
| pci_dev_t bdf; |
| }; |
| |
| /* PCI config space registers */ |
| #define HPTC_OFFSET 0x60 |
| #define HPTC_ADDR_ENABLE_BIT BIT(7) |
| |
| /* High Performance Event Timer Configuration */ |
| #define P2SB_HPTC 0x60 |
| #define P2SB_HPTC_ADDRESS_ENABLE BIT(7) |
| |
| /* |
| * ADDRESS_SELECT ENCODING_RANGE |
| * 0 0xfed0 0000 - 0xfed0 03ff |
| * 1 0xfed0 1000 - 0xfed0 13ff |
| * 2 0xfed0 2000 - 0xfed0 23ff |
| * 3 0xfed0 3000 - 0xfed0 33ff |
| */ |
| #define P2SB_HPTC_ADDRESS_SELECT_0 (0 << 0) |
| #define P2SB_HPTC_ADDRESS_SELECT_1 (1 << 0) |
| #define P2SB_HPTC_ADDRESS_SELECT_2 (2 << 0) |
| #define P2SB_HPTC_ADDRESS_SELECT_3 (3 << 0) |
| |
| /* |
| * apl_p2sb_early_init() - Enable decoding for HPET range |
| * |
| * This is needed by FSP-M which uses the High Precision Event Timer. |
| * |
| * @dev: P2SB device |
| * @return 0 if OK, -ve on error |
| */ |
| static int apl_p2sb_early_init(struct udevice *dev) |
| { |
| struct p2sb_platdata *plat = dev_get_platdata(dev); |
| pci_dev_t pdev = plat->bdf; |
| |
| /* |
| * Enable decoding for HPET memory address range. |
| * HPTC_OFFSET(0x60) bit 7, when set the P2SB will decode |
| * the High Performance Timer memory address range |
| * selected by bits 1:0 |
| */ |
| pci_x86_write_config(pdev, HPTC_OFFSET, HPTC_ADDR_ENABLE_BIT, |
| PCI_SIZE_8); |
| |
| /* Enable PCR Base address in PCH */ |
| pci_x86_write_config(pdev, PCI_BASE_ADDRESS_0, plat->mmio_base, |
| PCI_SIZE_32); |
| pci_x86_write_config(pdev, PCI_BASE_ADDRESS_1, 0, PCI_SIZE_32); |
| |
| /* Enable P2SB MSE */ |
| pci_x86_write_config(pdev, PCI_COMMAND, PCI_COMMAND_MASTER | |
| PCI_COMMAND_MEMORY, PCI_SIZE_8); |
| |
| return 0; |
| } |
| |
| static int apl_p2sb_spl_init(struct udevice *dev) |
| { |
| /* Enable decoding for HPET. Needed for FSP global pointer storage */ |
| dm_pci_write_config(dev, P2SB_HPTC, P2SB_HPTC_ADDRESS_SELECT_0 | |
| P2SB_HPTC_ADDRESS_ENABLE, PCI_SIZE_8); |
| |
| return 0; |
| } |
| |
| int apl_p2sb_ofdata_to_platdata(struct udevice *dev) |
| { |
| struct p2sb_uc_priv *upriv = dev_get_uclass_priv(dev); |
| struct p2sb_platdata *plat = dev_get_platdata(dev); |
| |
| #if !CONFIG_IS_ENABLED(OF_PLATDATA) |
| int ret; |
| |
| if (spl_phase() == PHASE_TPL) { |
| u32 base[2]; |
| |
| /* TPL sets up the initial BAR */ |
| ret = dev_read_u32_array(dev, "early-regs", base, |
| ARRAY_SIZE(base)); |
| if (ret) |
| return log_msg_ret("Missing/short early-regs", ret); |
| plat->mmio_base = base[0]; |
| plat->bdf = pci_get_devfn(dev); |
| if (plat->bdf < 0) |
| return log_msg_ret("Cannot get p2sb PCI address", |
| plat->bdf); |
| } else { |
| plat->mmio_base = dev_read_addr_pci(dev); |
| /* Don't set BDF since it should not be used */ |
| if (!plat->mmio_base || plat->mmio_base == FDT_ADDR_T_NONE) |
| return -EINVAL; |
| } |
| #else |
| plat->mmio_base = plat->dtplat.early_regs[0]; |
| plat->bdf = pci_ofplat_get_devfn(plat->dtplat.reg[0]); |
| #endif |
| upriv->mmio_base = plat->mmio_base; |
| debug("p2sb: mmio_base=%x\n", (uint)plat->mmio_base); |
| |
| return 0; |
| } |
| |
| static int apl_p2sb_probe(struct udevice *dev) |
| { |
| if (spl_phase() == PHASE_TPL) |
| return apl_p2sb_early_init(dev); |
| else if (spl_phase() == PHASE_SPL) |
| return apl_p2sb_spl_init(dev); |
| |
| return 0; |
| } |
| |
| static int p2sb_child_post_bind(struct udevice *dev) |
| { |
| #if !CONFIG_IS_ENABLED(OF_PLATDATA) |
| struct p2sb_child_platdata *pplat = dev_get_parent_platdata(dev); |
| int ret; |
| u32 pid; |
| |
| ret = dev_read_u32(dev, "intel,p2sb-port-id", &pid); |
| if (ret) |
| return ret; |
| pplat->pid = pid; |
| #endif |
| |
| return 0; |
| } |
| |
| static const struct udevice_id apl_p2sb_ids[] = { |
| { .compatible = "intel,apl-p2sb" }, |
| { } |
| }; |
| |
| U_BOOT_DRIVER(apl_p2sb_drv) = { |
| .name = "intel_apl_p2sb", |
| .id = UCLASS_P2SB, |
| .of_match = apl_p2sb_ids, |
| .probe = apl_p2sb_probe, |
| .ofdata_to_platdata = apl_p2sb_ofdata_to_platdata, |
| .platdata_auto_alloc_size = sizeof(struct p2sb_platdata), |
| .per_child_platdata_auto_alloc_size = |
| sizeof(struct p2sb_child_platdata), |
| .child_post_bind = p2sb_child_post_bind, |
| }; |