| This target config option used for below listed px30 boards. |
| * EVB_PX30 is an evaluation board for Rockchip PX30. |
| * PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam. |
| * EDIMM2.2 is a Form Factor Capacitive Evaluation Board from Engicam. |
| * PX30.Core needs to mount on top of EDIMM2.2 for creating complete |
| PX30.Core EDIMM2.2 Starter Kit. |
| * PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam. |
| * CTOUCH2.0 is a general purpose Carrier board with capacitive |
| * PX30.Core needs to mount on top of CTOUCH2.0 for creating complete |
| PX30.Core C.TOUCH Carrier board. |
| config ROCKCHIP_BOOT_MODE_REG |
| config SPL_SERIAL_SUPPORT |
| default "arch/arm/mach-rockchip/u-boot-tpl-v8.lds" |
| config DEBUG_UART_CHANNEL |
| int "Mux channel to use for debug UART2/UART3" |
| depends on DEBUG_UART_BOARD_INIT |
| UART2 and UART3 can use two different set of pins to route the output. |
| For using the UART for early debugging the route to use needs |
| source "board/engicam/px30_core/Kconfig" |
| source "board/hardkernel/odroid_go2/Kconfig" |
| source "board/rockchip/evb_px30/Kconfig" |