| /* SPDX-License-Identifier: GPL-2.0+ */ |
| /* |
| * (C) Copyright 2009 |
| * Vipin Kumar, ST Micoelectronics, vipin.kumar@st.com. |
| */ |
| |
| #ifndef __DW_I2C_H_ |
| #define __DW_I2C_H_ |
| |
| #include <reset.h> |
| |
| struct i2c_regs { |
| u32 ic_con; /* 0x00 */ |
| u32 ic_tar; /* 0x04 */ |
| u32 ic_sar; /* 0x08 */ |
| u32 ic_hs_maddr; /* 0x0c */ |
| u32 ic_cmd_data; /* 0x10 */ |
| u32 ic_ss_scl_hcnt; /* 0x14 */ |
| u32 ic_ss_scl_lcnt; /* 0x18 */ |
| u32 ic_fs_scl_hcnt; /* 0x1c */ |
| u32 ic_fs_scl_lcnt; /* 0x20 */ |
| u32 ic_hs_scl_hcnt; /* 0x24 */ |
| u32 ic_hs_scl_lcnt; /* 0x28 */ |
| u32 ic_intr_stat; /* 0x2c */ |
| u32 ic_intr_mask; /* 0x30 */ |
| u32 ic_raw_intr_stat; /* 0x34 */ |
| u32 ic_rx_tl; /* 0x38 */ |
| u32 ic_tx_tl; /* 0x3c */ |
| u32 ic_clr_intr; /* 0x40 */ |
| u32 ic_clr_rx_under; /* 0x44 */ |
| u32 ic_clr_rx_over; /* 0x48 */ |
| u32 ic_clr_tx_over; /* 0x4c */ |
| u32 ic_clr_rd_req; /* 0x50 */ |
| u32 ic_clr_tx_abrt; /* 0x54 */ |
| u32 ic_clr_rx_done; /* 0x58 */ |
| u32 ic_clr_activity; /* 0x5c */ |
| u32 ic_clr_stop_det; /* 0x60 */ |
| u32 ic_clr_start_det; /* 0x64 */ |
| u32 ic_clr_gen_call; /* 0x68 */ |
| u32 ic_enable; /* 0x6c */ |
| u32 ic_status; /* 0x70 */ |
| u32 ic_txflr; /* 0x74 */ |
| u32 ic_rxflr; /* 0x78 */ |
| u32 ic_sda_hold; /* 0x7c */ |
| u32 ic_tx_abrt_source; /* 0x80 */ |
| u32 slv_data_nak_only; |
| u32 dma_cr; |
| u32 dma_tdlr; |
| u32 dma_rdlr; |
| u32 sda_setup; |
| u32 ack_general_call; |
| u32 ic_enable_status; /* 0x9c */ |
| u32 fs_spklen; |
| u32 hs_spklen; |
| u32 clr_restart_det; |
| u8 reserved[0xf4 - 0xac]; |
| u32 comp_param1; /* 0xf4 */ |
| u32 comp_version; |
| u32 comp_type; |
| }; |
| |
| #define IC_CLK 166 |
| #define NANO_TO_MICRO 1000 |
| |
| /* High and low times in different speed modes (in ns) */ |
| #define MIN_SS_SCL_HIGHTIME 4000 |
| #define MIN_SS_SCL_LOWTIME 4700 |
| #define MIN_FS_SCL_HIGHTIME 600 |
| #define MIN_FS_SCL_LOWTIME 1300 |
| #define MIN_HS_SCL_HIGHTIME 60 |
| #define MIN_HS_SCL_LOWTIME 160 |
| |
| /* Worst case timeout for 1 byte is kept as 2ms */ |
| #define I2C_BYTE_TO (CONFIG_SYS_HZ/500) |
| #define I2C_STOPDET_TO (CONFIG_SYS_HZ/500) |
| #define I2C_BYTE_TO_BB (I2C_BYTE_TO * 16) |
| |
| /* i2c control register definitions */ |
| #define IC_CON_SD 0x0040 |
| #define IC_CON_RE 0x0020 |
| #define IC_CON_10BITADDRMASTER 0x0010 |
| #define IC_CON_10BITADDR_SLAVE 0x0008 |
| #define IC_CON_SPD_MSK 0x0006 |
| #define IC_CON_SPD_SS 0x0002 |
| #define IC_CON_SPD_FS 0x0004 |
| #define IC_CON_SPD_HS 0x0006 |
| #define IC_CON_MM 0x0001 |
| |
| /* i2c target address register definitions */ |
| #define TAR_ADDR 0x0050 |
| |
| /* i2c slave address register definitions */ |
| #define IC_SLAVE_ADDR 0x0002 |
| |
| /* i2c data buffer and command register definitions */ |
| #define IC_CMD 0x0100 |
| #define IC_STOP 0x0200 |
| |
| /* i2c interrupt status register definitions */ |
| #define IC_GEN_CALL 0x0800 |
| #define IC_START_DET 0x0400 |
| #define IC_STOP_DET 0x0200 |
| #define IC_ACTIVITY 0x0100 |
| #define IC_RX_DONE 0x0080 |
| #define IC_TX_ABRT 0x0040 |
| #define IC_RD_REQ 0x0020 |
| #define IC_TX_EMPTY 0x0010 |
| #define IC_TX_OVER 0x0008 |
| #define IC_RX_FULL 0x0004 |
| #define IC_RX_OVER 0x0002 |
| #define IC_RX_UNDER 0x0001 |
| |
| /* fifo threshold register definitions */ |
| #define IC_TL0 0x00 |
| #define IC_TL1 0x01 |
| #define IC_TL2 0x02 |
| #define IC_TL3 0x03 |
| #define IC_TL4 0x04 |
| #define IC_TL5 0x05 |
| #define IC_TL6 0x06 |
| #define IC_TL7 0x07 |
| #define IC_RX_TL IC_TL0 |
| #define IC_TX_TL IC_TL0 |
| |
| /* i2c enable register definitions */ |
| #define IC_ENABLE_0B 0x0001 |
| |
| /* i2c status register definitions */ |
| #define IC_STATUS_SA 0x0040 |
| #define IC_STATUS_MA 0x0020 |
| #define IC_STATUS_RFF 0x0010 |
| #define IC_STATUS_RFNE 0x0008 |
| #define IC_STATUS_TFE 0x0004 |
| #define IC_STATUS_TFNF 0x0002 |
| #define IC_STATUS_ACT 0x0001 |
| |
| /* Speed Selection */ |
| #define IC_SPEED_MODE_STANDARD 1 |
| #define IC_SPEED_MODE_FAST 2 |
| #define IC_SPEED_MODE_MAX 3 |
| |
| #define I2C_MAX_SPEED 3400000 |
| #define I2C_FAST_SPEED 400000 |
| #define I2C_STANDARD_SPEED 100000 |
| |
| /** |
| * struct dw_scl_sda_cfg - I2C timing configuration |
| * |
| * @has_max_speed: Support maximum speed (1Mbps) |
| * @ss_hcnt: Standard speed high time in ns |
| * @fs_hcnt: Fast speed high time in ns |
| * @ss_lcnt: Standard speed low time in ns |
| * @fs_lcnt: Fast speed low time in ns |
| * @sda_hold: SDA hold time |
| */ |
| struct dw_scl_sda_cfg { |
| bool has_max_speed; |
| u32 ss_hcnt; |
| u32 fs_hcnt; |
| u32 ss_lcnt; |
| u32 fs_lcnt; |
| u32 sda_hold; |
| }; |
| |
| struct dw_i2c { |
| struct i2c_regs *regs; |
| struct dw_scl_sda_cfg *scl_sda_cfg; |
| struct reset_ctl_bulk resets; |
| #if CONFIG_IS_ENABLED(CLK) |
| struct clk clk; |
| #endif |
| }; |
| |
| extern const struct dm_i2c_ops designware_i2c_ops; |
| |
| int designware_i2c_probe(struct udevice *bus); |
| int designware_i2c_remove(struct udevice *dev); |
| |
| #endif /* __DW_I2C_H_ */ |