PHY nodes | |
If the device tree is used to describe networking interfaces, U-Boot expects a | |
node for each PHY. Parent node for such a PHY node is expected to correspond to | |
a MDIO bus and the bus is used to access the PHY. | |
Required properties: | |
- reg : The ID number for the phy, usually a small integer | |
Example: | |
ethernet-phy@0 { | |
compatible = "ethernet-phy-id0141.0e90", "ethernet-phy-ieee802.3-c22"; | |
interrupt-parent = <&PIC>; | |
interrupts = <35 IRQ_TYPE_EDGE_RISING>; | |
reg = <0>; | |
resets = <&rst 8>; | |
reset-names = "phy"; | |
reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; | |
reset-assert-us = <1000>; | |
reset-deassert-us = <2000>; | |
}; |