| CONFIG_ARM=y |
| CONFIG_SKIP_LOWLEVEL_INIT=y |
| CONFIG_ARCH_CPU_INIT=y |
| CONFIG_ARCH_AT91=y |
| CONFIG_TEXT_BASE=0x26f00000 |
| CONFIG_TARGET_SAMA5D3_XPLAINED=y |
| CONFIG_SPL_GPIO=y |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_SIZE=0x4000 |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="at91-sama5d3_xplained" |
| CONFIG_SPL_TEXT_BASE=0x300000 |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL_DRIVERS_MISC=y |
| CONFIG_SPL=y |
| CONFIG_DEBUG_UART_BASE=0xffffee00 |
| CONFIG_DEBUG_UART_CLOCK=132000000 |
| CONFIG_DEBUG_UART_BOARD_INIT=y |
| CONFIG_SPL_FS_FAT=y |
| CONFIG_SPL_LIBDISK_SUPPORT=y |
| CONFIG_SYS_LOAD_ADDR=0x22000000 |
| CONFIG_DEBUG_UART=y |
| CONFIG_ENV_VARS_UBOOT_CONFIG=y |
| CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y |
| CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x20003ef0 |
| CONFIG_FIT=y |
| CONFIG_SD_BOOT=y |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" |
| CONFIG_USE_BOOTCOMMAND=y |
| CONFIG_BOOTCOMMAND="if test ! -n ${dtb_name}; then setenv dtb_name at91-${board_name}.dtb; fi; fatload mmc 0:1 0x21000000 ${dtb_name}; fatload mmc 0:1 0x22000000 zImage; bootz 0x22000000 - 0x21000000" |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_SPL_MAX_SIZE=0x18000 |
| CONFIG_SPL_HAS_BSS_LINKER_SECTION=y |
| CONFIG_SPL_BSS_START_ADDR=0x20000000 |
| CONFIG_SPL_BSS_MAX_SIZE=0x80000 |
| # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set |
| CONFIG_SPL_STACK=0x318000 |
| CONFIG_SYS_SPL_MALLOC=y |
| CONFIG_SYS_SPL_MALLOC_SIZE=0x80000 |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_CBSIZE=256 |
| CONFIG_SYS_PBSIZE=276 |
| CONFIG_CMD_BOOTZ=y |
| # CONFIG_CMD_FLASH is not set |
| # CONFIG_CMD_LOADS is not set |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND=y |
| CONFIG_CMD_NAND_TRIMFFS=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_DHCP=y |
| CONFIG_BOOTP_BOOTFILESIZE=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_HASH=y |
| CONFIG_HASH_VERIFY=y |
| CONFIG_CMD_EXT4=y |
| CONFIG_CMD_EXT4_WRITE=y |
| CONFIG_CMD_FAT=y |
| CONFIG_CMD_FS_GENERIC=y |
| CONFIG_CMD_MTDPARTS=y |
| CONFIG_CMD_UBI=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_SPL_OF_CONTROL=y |
| CONFIG_OF_SPL_REMOVE_PROPS="interrupts interrupt-parent dmas dma-names" |
| CONFIG_ENV_IS_IN_FAT=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_SPL_DM=y |
| CONFIG_SPL_DM_SEQ_ALIAS=y |
| CONFIG_CLK=y |
| CONFIG_SPL_CLK=y |
| CONFIG_CLK_AT91=y |
| CONFIG_AT91_UTMI=y |
| CONFIG_AT91_H32MX=y |
| CONFIG_AT91_GPIO=y |
| CONFIG_GENERIC_ATMEL_MCI=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_ATMEL=y |
| CONFIG_ATMEL_NAND_HW_PMECC=y |
| CONFIG_PMECC_CAP=4 |
| CONFIG_SYS_NAND_ONFI_DETECTION=y |
| CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y |
| CONFIG_SYS_NAND_U_BOOT_OFFS=0x40000 |
| CONFIG_MACB=y |
| CONFIG_PINCTRL=y |
| CONFIG_SPL_PINCTRL=y |
| CONFIG_PINCTRL_AT91=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_DEBUG_UART_ANNOUNCE=y |
| CONFIG_ATMEL_USART=y |
| CONFIG_SYSRESET=y |
| CONFIG_SPL_SYSRESET=y |
| CONFIG_SYSRESET_AT91=y |
| CONFIG_TIMER=y |
| CONFIG_SPL_TIMER=y |
| CONFIG_ATMEL_PIT_TIMER=y |
| CONFIG_SPL_ATMEL_PIT_TIMER=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS=2 |
| CONFIG_USB_ATMEL=y |
| CONFIG_USB_ATMEL_CLK_SEL_UPLL=y |
| CONFIG_USB_STORAGE=y |
| CONFIG_W1=y |
| CONFIG_W1_GPIO=y |
| CONFIG_W1_EEPROM=y |
| CONFIG_W1_EEPROM_DS24XXX=y |
| CONFIG_OF_LIBFDT_OVERLAY=y |