SPEAr: Add interface information in initialization
Few Designware peripheral registers need to be modified based on the
ethernet interface selected by the board. This patch supports interface
information in ethernet driver
Signed-off-by: Vipin Kumar <vipin.kumar@st.com>
Signed-off-by: Amit Virdi <amit.virdi@st.com>
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/spear/spear600/spear600.c b/board/spear/spear600/spear600.c
index d18d313..814f9cc 100644
--- a/board/spear/spear600/spear600.c
+++ b/board/spear/spear600/spear600.c
@@ -22,6 +22,7 @@
*/
#include <common.h>
+#include <miiphy.h>
#include <netdev.h>
#include <nand.h>
#include <asm/io.h>
@@ -59,9 +60,16 @@
int board_eth_init(bd_t *bis)
{
+ int ret = 0;
+
#if defined(CONFIG_DESIGNWARE_ETH)
- return designware_initialize(0, CONFIG_SPEAR_ETHBASE, CONFIG_DW0_PHY);
-#else
- return -1;
+ u32 interface = PHY_INTERFACE_MODE_MII;
+#if defined(CONFIG_DW_AUTONEG)
+ interface = PHY_INTERFACE_MODE_GMII;
+#endif
+ if (designware_initialize(0, CONFIG_SPEAR_ETHBASE, CONFIG_DW0_PHY,
+ interface) >= 0)
+ ret++;
#endif
+ return ret;
}