| CONFIG_ARM=y |
| CONFIG_SKIP_LOWLEVEL_INIT=y |
| CONFIG_SPL_SKIP_LOWLEVEL_INIT=y |
| CONFIG_COUNTER_FREQUENCY=12500000 |
| CONFIG_TARGET_LS1021ATWR=y |
| CONFIG_SYS_TEXT_BASE=0x82000000 |
| CONFIG_SYS_MALLOC_LEN=0x1020000 |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_SIZE=0x20000 |
| CONFIG_NXP_ESBC=y |
| CONFIG_SYS_I2C_MXC_I2C1=y |
| CONFIG_SYS_I2C_MXC_I2C2=y |
| CONFIG_SYS_I2C_MXC_I2C3=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart" |
| CONFIG_SPL_TEXT_BASE=0x10000000 |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL_DRIVERS_MISC=y |
| CONFIG_SPL=y |
| CONFIG_SYS_LOAD_ADDR=0x82000000 |
| CONFIG_SYS_MEMTEST_START=0x80000000 |
| CONFIG_SYS_MEMTEST_END=0x9fffffff |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_FIT=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_OF_STDOUT_VIA_ALIAS=y |
| CONFIG_RAMBOOT_PBL=y |
| CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021atwr/ls102xa_pbi.cfg" |
| CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021atwr/ls102xa_rcw_sd_ifc.cfg" |
| CONFIG_SD_BOOT=y |
| CONFIG_BOOTDELAY=0 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0" |
| CONFIG_BOOTCOMMAND="run distro_bootcmd; run sd_bootcmd; env exists secureboot && esbc_halt;" |
| CONFIG_SILENT_CONSOLE=y |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| CONFIG_MISC_INIT_R=y |
| CONFIG_ID_EEPROM=y |
| CONFIG_SPL_FSL_PBL=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8 |
| CONFIG_SPL_ENV_SUPPORT=y |
| CONFIG_SPL_I2C=y |
| CONFIG_SPL_MPC8XXX_INIT_DDR=y |
| CONFIG_SPL_WATCHDOG=y |
| CONFIG_CMD_IMLS=y |
| CONFIG_CMD_GREPENV=y |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| CONFIG_CMD_MEMINFO=y |
| CONFIG_CMD_MEMTEST=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPT=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_USB=y |
| # CONFIG_SPL_EFI_PARTITION is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_SPL_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="ethernet@2d10000" |
| CONFIG_DM=y |
| CONFIG_SPL_DM=y |
| # CONFIG_SPL_BLK is not set |
| CONFIG_MPC8XXX_GPIO=y |
| CONFIG_DM_I2C=y |
| # CONFIG_SPL_DM_I2C is not set |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x53 |
| # CONFIG_SPL_DM_MMC is not set |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_NOR_FLASH=y |
| CONFIG_FLASH_CFI_DRIVER=y |
| CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y |
| CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y |
| CONFIG_SYS_FLASH_CFI=y |
| CONFIG_PHY_ATHEROS=y |
| CONFIG_DM_ETH=y |
| CONFIG_DM_MDIO=y |
| CONFIG_PHY_GIGE=y |
| CONFIG_E1000=y |
| CONFIG_MII=y |
| CONFIG_TSEC_ENET=y |
| CONFIG_PCI=y |
| CONFIG_PCIE_LAYERSCAPE_RC=y |
| CONFIG_U_QE=y |
| CONFIG_SYS_QE_FW_ADDR=0x940000 |
| CONFIG_SCSI_AHCI_PLAT=y |
| CONFIG_SYS_NS16550=y |
| CONFIG_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |
| CONFIG_RSA=y |
| CONFIG_SPL_RSA=y |