| /* SPDX-License-Identifier: GPL-2.0+ */ |
| /* |
| * Copyright 2019-2020 NXP |
| */ |
| |
| #ifndef __L1028A_COMMON_H |
| #define __L1028A_COMMON_H |
| |
| #define CONFIG_REMAKE_ELF |
| #define CONFIG_MP |
| |
| #include <asm/arch/stream_id_lsch3.h> |
| #include <asm/arch/config.h> |
| #include <asm/arch/soc.h> |
| |
| /* Link Definitions */ |
| #define CONFIG_SYS_INIT_SP_ADDR CONFIG_SYS_TEXT_BASE |
| |
| #define CONFIG_SKIP_LOWLEVEL_INIT |
| |
| #define CONFIG_VERY_BIG_RAM |
| #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000UL |
| #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 |
| #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE |
| #define CONFIG_SYS_DDR_BLOCK2_BASE 0x2080000000ULL |
| #define CONFIG_SYS_FSL_DDR_MAIN_NUM_CTRLS 1 |
| |
| /* |
| * SMP Definitinos |
| */ |
| #define CPU_RELEASE_ADDR secondary_boot_addr |
| |
| /* Generic Timer Definitions */ |
| #define COUNTER_FREQUENCY 25000000 /* 25MHz */ |
| |
| /* Size of malloc() pool */ |
| #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 2048 * 1024) |
| |
| /* I2C */ |
| #ifndef CONFIG_DM_I2C |
| #define CONFIG_SYS_I2C |
| #endif |
| |
| /* Serial Port */ |
| #define CONFIG_SYS_NS16550_SERIAL |
| #define CONFIG_SYS_NS16550_REG_SIZE 1 |
| #define CONFIG_SYS_NS16550_CLK (get_bus_freq(0) / 2) |
| |
| #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } |
| |
| /* Miscellaneous configurable options */ |
| #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000) |
| |
| /* Physical Memory Map */ |
| #define CONFIG_CHIP_SELECTS_PER_CTRL 4 |
| |
| #define CONFIG_HWCONFIG |
| #define HWCONFIG_BUFFER_SIZE 128 |
| |
| /* Allow to overwrite serial and ethaddr */ |
| #define CONFIG_ENV_OVERWRITE |
| |
| #define BOOT_TARGET_DEVICES(func) \ |
| func(MMC, mmc, 0) \ |
| func(MMC, mmc, 1) \ |
| func(USB, usb, 0) \ |
| func(DHCP, dhcp, na) |
| #include <config_distro_bootcmd.h> |
| |
| #undef CONFIG_BOOTCOMMAND |
| |
| #define XSPI_NOR_BOOTCOMMAND \ |
| "run xspi_hdploadcmd; run distro_bootcmd; run xspi_bootcmd; " \ |
| "env exists secureboot && esbc_halt;;" |
| #define SD_BOOTCOMMAND \ |
| "run sd_hdploadcmd; run distro_bootcmd;run sd_bootcmd; " \ |
| "env exists secureboot && esbc_halt;" |
| #define SD2_BOOTCOMMAND \ |
| "run emmc_hdploadcmd; run distro_bootcmd;run emmc_bootcmd; " \ |
| "env exists secureboot && esbc_halt;" |
| |
| /* Monitor Command Prompt */ |
| #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */ |
| #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \ |
| sizeof(CONFIG_SYS_PROMPT) + 16) |
| #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot args buffer */ |
| |
| #define CONFIG_SYS_MAXARGS 64 /* max command args */ |
| |
| #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */ |
| |
| /* MMC */ |
| #ifdef CONFIG_MMC |
| #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33 |
| #endif |
| |
| #define CONFIG_SYS_MMC_ENV_DEV 0 |
| #define OCRAM_NONSECURE_SIZE 0x00010000 |
| #define CONFIG_SYS_FSL_QSPI_BASE 0x20000000 |
| |
| #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE |
| |
| /* I2C bus multiplexer */ |
| #define I2C_MUX_PCA_ADDR_PRI 0x77 /* Primary Mux*/ |
| #define I2C_MUX_CH_DEFAULT 0x8 |
| |
| /* EEPROM */ |
| #define CONFIG_ID_EEPROM |
| #define CONFIG_SYS_I2C_EEPROM_NXID |
| #define CONFIG_SYS_EEPROM_BUS_NUM 0 |
| #define CONFIG_SYS_I2C_EEPROM_ADDR 0x57 |
| #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 |
| #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 |
| #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 |
| |
| /* DisplayPort */ |
| #define DP_PWD_EN_DEFAULT_MASK 0x8 |
| |
| #ifdef CONFIG_NXP_ESBC |
| #include <asm/fsl_secure_boot.h> |
| #endif |
| |
| /* Ethernet */ |
| /* smallest ENETC BD ring has 8 entries */ |
| #define CONFIG_SYS_RX_ETH_BUFFER 8 |
| |
| #endif /* __L1028A_COMMON_H */ |