| /* |
| * RFC3927 ZeroConf IPv4 Link-Local addressing |
| * (see <http://www.zeroconf.org/>) |
| * |
| * Copied from BusyBox - networking/zcip.c |
| * |
| * Copyright (C) 2003 by Arthur van Hoff (avh@strangeberry.com) |
| * Copyright (C) 2004 by David Brownell |
| * Copyright (C) 2010 by Joe Hershberger |
| * |
| * Licensed under the GPL v2 or later |
| */ |
| |
| #include <common.h> |
| #include <net.h> |
| #include "arp.h" |
| #include "net_rand.h" |
| |
| /* We don't need more than 32 bits of the counter */ |
| #define MONOTONIC_MS() ((unsigned)get_timer(0) * (1000 / CONFIG_SYS_HZ)) |
| |
| enum { |
| /* 169.254.0.0 */ |
| LINKLOCAL_ADDR = 0xa9fe0000, |
| |
| IN_CLASSB_NET = 0xffff0000, |
| IN_CLASSB_HOST = 0x0000ffff, |
| |
| /* protocol timeout parameters, specified in seconds */ |
| PROBE_WAIT = 1, |
| PROBE_MIN = 1, |
| PROBE_MAX = 2, |
| PROBE_NUM = 3, |
| MAX_CONFLICTS = 10, |
| RATE_LIMIT_INTERVAL = 60, |
| ANNOUNCE_WAIT = 2, |
| ANNOUNCE_NUM = 2, |
| ANNOUNCE_INTERVAL = 2, |
| DEFEND_INTERVAL = 10 |
| }; |
| |
| /* States during the configuration process. */ |
| static enum ll_state_t { |
| PROBE = 0, |
| RATE_LIMIT_PROBE, |
| ANNOUNCE, |
| MONITOR, |
| DEFEND, |
| DISABLED |
| } state = DISABLED; |
| |
| static struct in_addr ip; |
| static int timeout_ms = -1; |
| static unsigned deadline_ms; |
| static unsigned conflicts; |
| static unsigned nprobes; |
| static unsigned nclaims; |
| static int ready; |
| static unsigned int seed; |
| |
| static void link_local_timeout(void); |
| |
| /** |
| * Pick a random link local IP address on 169.254/16, except that |
| * the first and last 256 addresses are reserved. |
| */ |
| static struct in_addr pick(void) |
| { |
| unsigned tmp; |
| struct in_addr ip; |
| |
| do { |
| tmp = rand_r(&seed) & IN_CLASSB_HOST; |
| } while (tmp > (IN_CLASSB_HOST - 0x0200)); |
| ip.s_addr = htonl((LINKLOCAL_ADDR + 0x0100) + tmp); |
| return ip; |
| } |
| |
| /** |
| * Return milliseconds of random delay, up to "secs" seconds. |
| */ |
| static inline unsigned random_delay_ms(unsigned secs) |
| { |
| return rand_r(&seed) % (secs * 1000); |
| } |
| |
| static void configure_wait(void) |
| { |
| if (timeout_ms == -1) |
| return; |
| |
| /* poll, being ready to adjust current timeout */ |
| if (!timeout_ms) |
| timeout_ms = random_delay_ms(PROBE_WAIT); |
| |
| /* set deadline_ms to the point in time when we timeout */ |
| deadline_ms = MONOTONIC_MS() + timeout_ms; |
| |
| debug_cond(DEBUG_DEV_PKT, "...wait %d %s nprobes=%u, nclaims=%u\n", |
| timeout_ms, eth_get_name(), nprobes, nclaims); |
| |
| NetSetTimeout(timeout_ms, link_local_timeout); |
| } |
| |
| void link_local_start(void) |
| { |
| ip = getenv_ip("llipaddr"); |
| if (ip.s_addr != 0 && |
| (ntohl(ip.s_addr) & IN_CLASSB_NET) != LINKLOCAL_ADDR) { |
| puts("invalid link address"); |
| net_set_state(NETLOOP_FAIL); |
| return; |
| } |
| net_netmask.s_addr = IN_CLASSB_NET; |
| |
| seed = seed_mac(); |
| if (ip.s_addr == 0) |
| ip = pick(); |
| |
| state = PROBE; |
| timeout_ms = 0; |
| conflicts = 0; |
| nprobes = 0; |
| nclaims = 0; |
| ready = 0; |
| |
| configure_wait(); |
| } |
| |
| static void link_local_timeout(void) |
| { |
| switch (state) { |
| case PROBE: |
| /* timeouts in the PROBE state mean no conflicting ARP packets |
| have been received, so we can progress through the states */ |
| if (nprobes < PROBE_NUM) { |
| struct in_addr zero_ip = {.s_addr = 0}; |
| |
| nprobes++; |
| debug_cond(DEBUG_LL_STATE, "probe/%u %s@%pI4\n", |
| nprobes, eth_get_name(), &ip); |
| arp_raw_request(zero_ip, net_null_ethaddr, ip); |
| timeout_ms = PROBE_MIN * 1000; |
| timeout_ms += random_delay_ms(PROBE_MAX - PROBE_MIN); |
| } else { |
| /* Switch to announce state */ |
| state = ANNOUNCE; |
| nclaims = 0; |
| debug_cond(DEBUG_LL_STATE, "announce/%u %s@%pI4\n", |
| nclaims, eth_get_name(), &ip); |
| arp_raw_request(ip, net_ethaddr, ip); |
| timeout_ms = ANNOUNCE_INTERVAL * 1000; |
| } |
| break; |
| case RATE_LIMIT_PROBE: |
| /* timeouts in the RATE_LIMIT_PROBE state mean no conflicting |
| ARP packets have been received, so we can move immediately |
| to the announce state */ |
| state = ANNOUNCE; |
| nclaims = 0; |
| debug_cond(DEBUG_LL_STATE, "announce/%u %s@%pI4\n", |
| nclaims, eth_get_name(), &ip); |
| arp_raw_request(ip, net_ethaddr, ip); |
| timeout_ms = ANNOUNCE_INTERVAL * 1000; |
| break; |
| case ANNOUNCE: |
| /* timeouts in the ANNOUNCE state mean no conflicting ARP |
| packets have been received, so we can progress through |
| the states */ |
| if (nclaims < ANNOUNCE_NUM) { |
| nclaims++; |
| debug_cond(DEBUG_LL_STATE, "announce/%u %s@%pI4\n", |
| nclaims, eth_get_name(), &ip); |
| arp_raw_request(ip, net_ethaddr, ip); |
| timeout_ms = ANNOUNCE_INTERVAL * 1000; |
| } else { |
| /* Switch to monitor state */ |
| state = MONITOR; |
| printf("Successfully assigned %pI4\n", &ip); |
| net_copy_ip(&net_ip, &ip); |
| ready = 1; |
| conflicts = 0; |
| timeout_ms = -1; |
| /* Never timeout in the monitor state */ |
| NetSetTimeout(0, NULL); |
| |
| /* NOTE: all other exit paths should deconfig ... */ |
| net_set_state(NETLOOP_SUCCESS); |
| return; |
| } |
| break; |
| case DEFEND: |
| /* We won! No ARP replies, so just go back to monitor */ |
| state = MONITOR; |
| timeout_ms = -1; |
| conflicts = 0; |
| break; |
| default: |
| /* Invalid, should never happen. Restart the whole protocol */ |
| state = PROBE; |
| ip = pick(); |
| timeout_ms = 0; |
| nprobes = 0; |
| nclaims = 0; |
| break; |
| } |
| configure_wait(); |
| } |
| |
| void link_local_receive_arp(struct arp_hdr *arp, int len) |
| { |
| int source_ip_conflict; |
| int target_ip_conflict; |
| struct in_addr null_ip = {.s_addr = 0}; |
| |
| if (state == DISABLED) |
| return; |
| |
| /* We need to adjust the timeout in case we didn't receive a |
| conflicting packet. */ |
| if (timeout_ms > 0) { |
| unsigned diff = deadline_ms - MONOTONIC_MS(); |
| if ((int)(diff) < 0) { |
| /* Current time is greater than the expected timeout |
| time. This should never happen */ |
| debug_cond(DEBUG_LL_STATE, |
| "missed an expected timeout\n"); |
| timeout_ms = 0; |
| } else { |
| debug_cond(DEBUG_INT_STATE, "adjusting timeout\n"); |
| timeout_ms = diff | 1; /* never 0 */ |
| } |
| } |
| #if 0 |
| /* XXX Don't bother with ethernet link just yet */ |
| if ((fds[0].revents & POLLIN) == 0) { |
| if (fds[0].revents & POLLERR) { |
| /* |
| * FIXME: links routinely go down; |
| */ |
| bb_error_msg("iface %s is down", eth_get_name()); |
| if (ready) { |
| run(argv, "deconfig", &ip); |
| } |
| return EXIT_FAILURE; |
| } |
| continue; |
| } |
| #endif |
| |
| debug_cond(DEBUG_INT_STATE, "%s recv arp type=%d, op=%d,\n", |
| eth_get_name(), ntohs(arp->ar_pro), |
| ntohs(arp->ar_op)); |
| debug_cond(DEBUG_INT_STATE, "\tsource=%pM %pI4\n", |
| &arp->ar_sha, |
| &arp->ar_spa); |
| debug_cond(DEBUG_INT_STATE, "\ttarget=%pM %pI4\n", |
| &arp->ar_tha, |
| &arp->ar_tpa); |
| |
| if (arp->ar_op != htons(ARPOP_REQUEST) |
| && arp->ar_op != htons(ARPOP_REPLY) |
| ) { |
| configure_wait(); |
| return; |
| } |
| |
| source_ip_conflict = 0; |
| target_ip_conflict = 0; |
| |
| if (memcmp(&arp->ar_spa, &ip, ARP_PLEN) == 0 && |
| memcmp(&arp->ar_sha, net_ethaddr, ARP_HLEN) != 0) |
| source_ip_conflict = 1; |
| |
| /* |
| * According to RFC 3927, section 2.2.1: |
| * Check if packet is an ARP probe by checking for a null source IP |
| * then check that target IP is equal to ours and source hw addr |
| * is not equal to ours. This condition should cause a conflict only |
| * during probe. |
| */ |
| if (arp->ar_op == htons(ARPOP_REQUEST) && |
| memcmp(&arp->ar_spa, &null_ip, ARP_PLEN) == 0 && |
| memcmp(&arp->ar_tpa, &ip, ARP_PLEN) == 0 && |
| memcmp(&arp->ar_sha, net_ethaddr, ARP_HLEN) != 0) { |
| target_ip_conflict = 1; |
| } |
| |
| debug_cond(DEBUG_NET_PKT, |
| "state = %d, source ip conflict = %d, target ip conflict = " |
| "%d\n", state, source_ip_conflict, target_ip_conflict); |
| switch (state) { |
| case PROBE: |
| case ANNOUNCE: |
| /* When probing or announcing, check for source IP conflicts |
| and other hosts doing ARP probes (target IP conflicts). */ |
| if (source_ip_conflict || target_ip_conflict) { |
| conflicts++; |
| state = PROBE; |
| if (conflicts >= MAX_CONFLICTS) { |
| debug("%s ratelimit\n", eth_get_name()); |
| timeout_ms = RATE_LIMIT_INTERVAL * 1000; |
| state = RATE_LIMIT_PROBE; |
| } |
| |
| /* restart the whole protocol */ |
| ip = pick(); |
| timeout_ms = 0; |
| nprobes = 0; |
| nclaims = 0; |
| } |
| break; |
| case MONITOR: |
| /* If a conflict, we try to defend with a single ARP probe */ |
| if (source_ip_conflict) { |
| debug("monitor conflict -- defending\n"); |
| state = DEFEND; |
| timeout_ms = DEFEND_INTERVAL * 1000; |
| arp_raw_request(ip, net_ethaddr, ip); |
| } |
| break; |
| case DEFEND: |
| /* Well, we tried. Start over (on conflict) */ |
| if (source_ip_conflict) { |
| state = PROBE; |
| debug("defend conflict -- starting over\n"); |
| ready = 0; |
| net_ip.s_addr = 0; |
| |
| /* restart the whole protocol */ |
| ip = pick(); |
| timeout_ms = 0; |
| nprobes = 0; |
| nclaims = 0; |
| } |
| break; |
| default: |
| /* Invalid, should never happen. Restart the whole protocol */ |
| debug("invalid state -- starting over\n"); |
| state = PROBE; |
| ip = pick(); |
| timeout_ms = 0; |
| nprobes = 0; |
| nclaims = 0; |
| break; |
| } |
| configure_wait(); |
| } |