| /* |
| * Copyright (C) 2012-2017 Altera Corporation <www.altera.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <errno.h> |
| #include <fdtdec.h> |
| #include <linux/libfdt.h> |
| #include <altera.h> |
| #include <miiphy.h> |
| #include <netdev.h> |
| #include <watchdog.h> |
| #include <asm/arch/misc.h> |
| #include <asm/arch/reset_manager.h> |
| #include <asm/arch/scan_manager.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/nic301.h> |
| #include <asm/arch/scu.h> |
| #include <asm/pl310.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| static const struct pl310_regs *const pl310 = |
| (struct pl310_regs *)CONFIG_SYS_PL310_BASE; |
| |
| struct bsel bsel_str[] = { |
| { "rsvd", "Reserved", }, |
| { "fpga", "FPGA (HPS2FPGA Bridge)", }, |
| { "nand", "NAND Flash (1.8V)", }, |
| { "nand", "NAND Flash (3.0V)", }, |
| { "sd", "SD/MMC External Transceiver (1.8V)", }, |
| { "sd", "SD/MMC Internal Transceiver (3.0V)", }, |
| { "qspi", "QSPI Flash (1.8V)", }, |
| { "qspi", "QSPI Flash (3.0V)", }, |
| }; |
| |
| int dram_init(void) |
| { |
| gd->ram_size = get_ram_size((long *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE); |
| return 0; |
| } |
| |
| void enable_caches(void) |
| { |
| #ifndef CONFIG_SYS_ICACHE_OFF |
| icache_enable(); |
| #endif |
| #ifndef CONFIG_SYS_DCACHE_OFF |
| dcache_enable(); |
| #endif |
| } |
| |
| void v7_outer_cache_enable(void) |
| { |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| |
| /* enable BRESP, instruction and data prefetch, full line of zeroes */ |
| setbits_le32(&pl310->pl310_aux_ctrl, |
| L310_AUX_CTRL_DATA_PREFETCH_MASK | |
| L310_AUX_CTRL_INST_PREFETCH_MASK | |
| L310_SHARED_ATT_OVERRIDE_ENABLE); |
| |
| /* Enable the L2 cache */ |
| setbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| |
| void v7_outer_cache_disable(void) |
| { |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| |
| #if defined(CONFIG_SYS_CONSOLE_IS_IN_ENV) && \ |
| defined(CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE) |
| int overwrite_console(void) |
| { |
| return 0; |
| } |
| #endif |
| |
| #ifdef CONFIG_FPGA |
| /* |
| * FPGA programming support for SoC FPGA Cyclone V |
| */ |
| static Altera_desc altera_fpga[] = { |
| { |
| /* Family */ |
| Altera_SoCFPGA, |
| /* Interface type */ |
| fast_passive_parallel, |
| /* No limitation as additional data will be ignored */ |
| -1, |
| /* No device function table */ |
| NULL, |
| /* Base interface address specified in driver */ |
| NULL, |
| /* No cookie implementation */ |
| 0 |
| }, |
| }; |
| |
| /* add device descriptor to FPGA device table */ |
| void socfpga_fpga_add(void) |
| { |
| int i; |
| fpga_init(); |
| for (i = 0; i < ARRAY_SIZE(altera_fpga); i++) |
| fpga_add(fpga_altera, &altera_fpga[i]); |
| } |
| #endif |
| |
| int arch_cpu_init(void) |
| { |
| #ifdef CONFIG_HW_WATCHDOG |
| /* |
| * In case the watchdog is enabled, make sure to (re-)configure it |
| * so that the defined timeout is valid. Otherwise the SPL (Perloader) |
| * timeout value is still active which might too short for Linux |
| * booting. |
| */ |
| hw_watchdog_init(); |
| #else |
| /* |
| * If the HW watchdog is NOT enabled, make sure it is not running, |
| * for example because it was enabled in the preloader. This might |
| * trigger a watchdog-triggered reboot of Linux kernel later. |
| * Toggle watchdog reset, so watchdog in not running state. |
| */ |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 1); |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 0); |
| #endif |
| |
| return 0; |
| } |