| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2000-2003 |
| * Wolfgang Denk, DENX Software Engineering, wd@denx.de. |
| * |
| * Copyright (C) 2004-2007, 2012 Freescale Semiconductor, Inc. |
| * TsiChung Liew (Tsi-Chung.Liew@freescale.com) |
| */ |
| |
| #include <config.h> |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/immap.h> |
| |
| #if defined(CONFIG_CMD_NAND) |
| #include <nand.h> |
| #include <linux/mtd/mtd.h> |
| #include <linux/mtd/rawnand.h> |
| |
| #define SET_CLE 0x10 |
| #define SET_ALE 0x08 |
| |
| static void nand_hwcontrol(struct mtd_info *mtdinfo, int cmd, unsigned int ctrl) |
| { |
| struct nand_chip *this = mtd_to_nand(mtdinfo); |
| volatile u16 *nCE = (u16 *) CONFIG_SYS_LATCH_ADDR; |
| |
| if (ctrl & NAND_CTRL_CHANGE) { |
| ulong IO_ADDR_W = (ulong) this->IO_ADDR_W; |
| |
| IO_ADDR_W &= ~(SET_ALE | SET_CLE); |
| |
| if (ctrl & NAND_NCE) |
| *nCE &= 0xFFFB; |
| else |
| *nCE |= 0x0004; |
| |
| if (ctrl & NAND_CLE) |
| IO_ADDR_W |= SET_CLE; |
| if (ctrl & NAND_ALE) |
| IO_ADDR_W |= SET_ALE; |
| |
| this->IO_ADDR_W = (void *)IO_ADDR_W; |
| |
| } |
| |
| if (cmd != NAND_CMD_NONE) |
| writeb(cmd, this->IO_ADDR_W); |
| } |
| |
| int board_nand_init(struct nand_chip *nand) |
| { |
| gpio_t *gpio = (gpio_t *) MMAP_GPIO; |
| fbcs_t *fbcs = (fbcs_t *) MMAP_FBCS; |
| |
| clrbits_be32(&fbcs->csmr2, FBCS_CSMR_WP); |
| |
| /* |
| * set up pin configuration - enabled 2nd output buffer's signals |
| * (nand_ngpio - nCE USB1/2_PWR_EN, LATCH_GPIOs, LCD_VEEEN, etc) |
| * to use nCE signal |
| */ |
| clrbits_8(&gpio->par_timer, GPIO_PAR_TIN3_TIN3); |
| setbits_8(&gpio->pddr_timer, 0x08); |
| setbits_8(&gpio->ppd_timer, 0x08); |
| out_8(&gpio->pclrr_timer, 0); |
| out_8(&gpio->podr_timer, 0); |
| |
| nand->chip_delay = 60; |
| nand->ecc.mode = NAND_ECC_SOFT; |
| nand->cmd_ctrl = nand_hwcontrol; |
| |
| return 0; |
| } |
| #endif |