| Overview |
| -------- |
| P1_P2_RDB_PC represents a set of boards including |
| P1020MSBG-PC |
| P1020RDB-PC |
| P1020RDB-PD |
| P1020UTM-PC |
| P1021RDB-PC |
| P1024RDB |
| P1025RDB |
| P2020RDB-PC |
| |
| They have similar design of P1020RDB but have DDR3 instead of DDR2. P2020RDB-PC |
| has 64-bit DDR. All others have 32-bit DDR. |
| |
| Key features on these boards include: |
| * DDR3 |
| * NOR flash |
| * NAND flash (on RDB's only) |
| * SPI flash (on RDB's only) |
| * SDHC/MMC card slot |
| * VSC7385 Ethernet switch (on P1020MBG, P1020RDB, & P1021RDB) |
| * PCIE slot and mini-PCIE slots |
| |
| As these boards use soldered DDR chips not regular DIMMs, an on-board EEPROM |
| is used to store SPD data. In case of absent or corrupted SPD, falling back |
| to timing data embedded in the source code will be used. Raw timing data is |
| extracted from DDR chip datasheet. Different speeds of DDR are supported with |
| this approach. ODT option is forced to fit this set of boards, again because |
| they don't have regular DIMMs. |
| |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS is defined as 5ms to meet specification |
| for writing timing. |
| |
| VSC firmware Address is defined by default in config file for eTSEC1. |
| |
| SD width is based off DIP switch. DIP switch is detected on the |
| board by reading i2c bus and setting the appropriate mux values. |
| |
| Some boards have QE module in the silicon (P1021 and P1025). QE and eLBC have |
| pins multiplexing. QE function needs to be disabled to access Nor Flash and |
| CPLD. QE-UEC and QE-UART can be enabled for linux kernel by setting "qe" |
| in hwconfig. In addition, QE-UEC and QE-TDM also have pins multiplexing, to |
| enable QE-TDM for linux kernel, set "qe;tdm" in hwconfig. Syntax is as below |
| |
| 'setenv hwconfig qe' to enable QE UEC/UART and disable Nor-Flash/CPLD. |
| 'setenv hwconfig 'qe;tdm'' to enalbe QE TDM and disable Nor-Flash/CPLD. |
| |
| Device tree support and how to enable it for different configs |
| -------------------------------------------------------------- |
| Device tree support is available for p1020rdb and p2020rdb for below mentioned boot, |
| 1. NOR Boot |
| 2. NAND Boot |
| 3. SD Boot |
| 4. SPIFLASH Boot |
| |
| To enable device tree support for other boot, below configs need to be |
| enabled in relative defconfig file, |
| 1. CONFIG_DEFAULT_DEVICE_TREE="p1020rdb" (Change default device tree name if required) |
| 2. CONFIG_OF_CONTROL |
| 3. CONFIG_MPC85XX_HAVE_RESET_VECTOR if reset vector is located at |
| CONFIG_RESET_VECTOR_ADDRESS - 0xffc |
| |
| If device tree support is enabled in defconfig, |
| 1. use 'u-boot-with-dtb.bin' for NOR boot. |
| 2. use 'u-boot-with-spl.bin' for other boot. |