| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2019 NXP |
| */ |
| |
| #include <common.h> |
| #include <env.h> |
| #include <errno.h> |
| #include <init.h> |
| #include <miiphy.h> |
| #include <netdev.h> |
| #include <linux/delay.h> |
| #include <asm/global_data.h> |
| #include <asm/mach-imx/iomux-v3.h> |
| #include <asm-generic/gpio.h> |
| #include <asm/arch/imx8mp_pins.h> |
| #include <asm/arch/clock.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/mach-imx/gpio.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #define UART_PAD_CTRL (PAD_CTL_DSE6 | PAD_CTL_FSEL1) |
| #define WDOG_PAD_CTRL (PAD_CTL_DSE6 | PAD_CTL_ODE | PAD_CTL_PUE | PAD_CTL_PE) |
| |
| static iomux_v3_cfg_t const uart_pads[] = { |
| MX8MP_PAD_UART2_RXD__UART2_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL), |
| MX8MP_PAD_UART2_TXD__UART2_DCE_TX | MUX_PAD_CTRL(UART_PAD_CTRL), |
| }; |
| |
| static iomux_v3_cfg_t const wdog_pads[] = { |
| MX8MP_PAD_GPIO1_IO02__WDOG1_WDOG_B | MUX_PAD_CTRL(WDOG_PAD_CTRL), |
| }; |
| |
| int board_early_init_f(void) |
| { |
| struct wdog_regs *wdog = (struct wdog_regs *)WDOG1_BASE_ADDR; |
| |
| imx_iomux_v3_setup_multiple_pads(wdog_pads, ARRAY_SIZE(wdog_pads)); |
| |
| set_wdog_reset(wdog); |
| |
| imx_iomux_v3_setup_multiple_pads(uart_pads, ARRAY_SIZE(uart_pads)); |
| |
| return 0; |
| } |
| |
| static void setup_fec(void) |
| { |
| struct iomuxc_gpr_base_regs *gpr = |
| (struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR; |
| |
| /* Enable RGMII TX clk output */ |
| setbits_le32(&gpr->gpr[1], BIT(22)); |
| } |
| |
| #define EQOS_RST_PAD IMX_GPIO_NR(4, 22) |
| static iomux_v3_cfg_t const eqos_rst_pads[] = { |
| MX8MP_PAD_SAI2_RXC__GPIO4_IO22 | MUX_PAD_CTRL(NO_PAD_CTRL), |
| }; |
| |
| static void setup_iomux_eqos(void) |
| { |
| imx_iomux_v3_setup_multiple_pads(eqos_rst_pads, |
| ARRAY_SIZE(eqos_rst_pads)); |
| |
| gpio_request(EQOS_RST_PAD, "eqos_rst"); |
| gpio_direction_output(EQOS_RST_PAD, 0); |
| mdelay(15); |
| gpio_direction_output(EQOS_RST_PAD, 1); |
| mdelay(100); |
| } |
| |
| static int setup_eqos(void) |
| { |
| struct iomuxc_gpr_base_regs *gpr = |
| (struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR; |
| |
| setup_iomux_eqos(); |
| |
| /* set INTF as RGMII, enable RGMII TXC clock */ |
| clrsetbits_le32(&gpr->gpr[1], |
| IOMUXC_GPR_GPR1_GPR_ENET_QOS_INTF_SEL_MASK, BIT(16)); |
| setbits_le32(&gpr->gpr[1], BIT(19) | BIT(21)); |
| |
| return set_clk_eqos(ENET_125MHZ); |
| } |
| |
| #if CONFIG_IS_ENABLED(NET) |
| int board_phy_config(struct phy_device *phydev) |
| { |
| if (phydev->drv->config) |
| phydev->drv->config(phydev); |
| return 0; |
| } |
| #endif |
| |
| int board_init(void) |
| { |
| int ret = 0; |
| |
| if (CONFIG_IS_ENABLED(FEC_MXC)) { |
| setup_fec(); |
| |
| if (CONFIG_IS_ENABLED(DWC_ETH_QOS)) |
| ret = setup_eqos(); |
| } |
| |
| return ret; |
| } |
| |
| int board_late_init(void) |
| { |
| #ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG |
| env_set("board_name", "EVK"); |
| env_set("board_rev", "iMX8MP"); |
| #endif |
| |
| return 0; |
| } |