| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2010-2013 |
| * NVIDIA Corporation <www.nvidia.com> |
| * |
| * (C) Copyright 2021 |
| * Svyatoslav Ryhel <clamor95@gmail.com> |
| */ |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <fdt_support.h> |
| #include <i2c.h> |
| #include <log.h> |
| #include <asm/arch/pinmux.h> |
| #include <asm/arch/gp_padctrl.h> |
| #include <asm/arch/gpio.h> |
| #include <asm/gpio.h> |
| #include <linux/delay.h> |
| #include "pinmux-config-endeavoru.h" |
| |
| #define TPS80032_CTL1_I2C_ADDR 0x48 |
| #define TPS80032_PHOENIX_DEV_ON 0x25 |
| #define DEVOFF BIT(0) |
| #define TPS80032_LDO1_CFG_STATE 0x9E |
| #define TPS80032_LDO1_CFG_VOLTAGE 0x9F |
| |
| #ifdef CONFIG_CMD_POWEROFF |
| int do_poweroff(struct cmd_tbl *cmdtp, int flag, |
| int argc, char *const argv[]) |
| { |
| struct udevice *dev; |
| int ret; |
| |
| ret = i2c_get_chip_for_busnum(0, TPS80032_CTL1_I2C_ADDR, 1, &dev); |
| if (ret) { |
| log_debug("cannot find PMIC I2C chip\n"); |
| return 0; |
| } |
| |
| ret = dm_i2c_reg_write(dev, TPS80032_PHOENIX_DEV_ON, DEVOFF); |
| if (ret) |
| return ret; |
| |
| // wait some time and then print error |
| mdelay(5000); |
| |
| printf("Failed to power off!!!\n"); |
| return 1; |
| } |
| #endif |
| |
| /* |
| * Routine: pinmux_init |
| * Description: Do individual peripheral pinmux configs |
| */ |
| void pinmux_init(void) |
| { |
| pinmux_config_pingrp_table(endeavoru_pinmux_common, |
| ARRAY_SIZE(endeavoru_pinmux_common)); |
| } |
| |
| #ifdef CONFIG_MMC_SDHCI_TEGRA |
| static void tps80032_voltage_init(void) |
| { |
| struct udevice *dev; |
| int ret; |
| |
| ret = i2c_get_chip_for_busnum(0, TPS80032_CTL1_I2C_ADDR, 1, &dev); |
| if (ret) |
| log_debug("cannot find PMIC I2C chip\n"); |
| |
| /* TPS80032: LDO1_REG = 1.2v to DSI */ |
| ret = dm_i2c_reg_write(dev, TPS80032_LDO1_CFG_VOLTAGE, 0x03); |
| if (ret) |
| log_debug("avdd_dsi_csi voltage set failed: %d\n", ret); |
| |
| /* TPS80032: LDO1_REG enable */ |
| ret = dm_i2c_reg_write(dev, TPS80032_LDO1_CFG_STATE, 0x01); |
| if (ret) |
| log_debug("avdd_dsi_csi enable failed: %d\n", ret); |
| } |
| |
| /* |
| * Routine: pin_mux_mmc |
| * Description: setup the MMC muxes, power rails, etc. |
| */ |
| void pin_mux_mmc(void) |
| { |
| /* Bring up DSI power */ |
| tps80032_voltage_init(); |
| } |
| #endif /* MMC */ |
| |
| #if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) |
| int ft_board_setup(void *blob, struct bd_info *bd) |
| { |
| /* Remove TrustZone nodes */ |
| fdt_del_node_and_alias(blob, "/firmware"); |
| fdt_del_node_and_alias(blob, "/reserved-memory/trustzone@bfe00000"); |
| |
| return 0; |
| } |
| #endif |