| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2016 Nexell |
| * Hyunseok, Jung <hsjung@nexell.co.kr> |
| */ |
| |
| #include <common.h> |
| #include <command.h> |
| #include <asm/system.h> |
| #include <asm/cache.h> |
| #include <asm/global_data.h> |
| #include <asm/sections.h> |
| #include <asm/io.h> |
| #include <asm/arch/nexell.h> |
| #include <asm/arch/clk.h> |
| #include <asm/arch/reset.h> |
| #include <asm/arch/tieoff.h> |
| #include <cpu_func.h> |
| #include <linux/delay.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #ifndef CONFIG_ARCH_CPU_INIT |
| #error must be define the macro "CONFIG_ARCH_CPU_INIT" |
| #endif |
| |
| void s_init(void) |
| { |
| } |
| |
| static void cpu_soc_init(void) |
| { |
| /* |
| * NOTE> ALIVE Power Gate must enable for Alive register access. |
| * must be clear wfi jump address |
| */ |
| writel(1, ALIVEPWRGATEREG); |
| writel(0xFFFFFFFF, SCR_ARM_SECOND_BOOT); |
| |
| /* write 0xf0 on alive scratchpad reg for boot success check */ |
| writel(readl(SCR_SIGNAGURE_READ) | 0xF0, (SCR_SIGNAGURE_SET)); |
| |
| /* set l2 cache tieoff */ |
| nx_tieoff_set(NX_TIEOFF_CORTEXA9MP_TOP_QUADL2C_L2RET1N_0, 1); |
| nx_tieoff_set(NX_TIEOFF_CORTEXA9MP_TOP_QUADL2C_L2RET1N_1, 1); |
| } |
| |
| #ifdef CONFIG_PL011_SERIAL |
| static void serial_device_init(void) |
| { |
| char dev[10]; |
| int id; |
| |
| sprintf(dev, "nx-uart.%d", CONFIG_CONS_INDEX); |
| id = RESET_ID_UART0 + CONFIG_CONS_INDEX; |
| |
| struct clk *clk = clk_get((const char *)dev); |
| |
| /* reset control: Low active ___|--- */ |
| nx_rstcon_setrst(id, RSTCON_ASSERT); |
| udelay(10); |
| nx_rstcon_setrst(id, RSTCON_NEGATE); |
| udelay(10); |
| |
| /* set clock */ |
| clk_disable(clk); |
| clk_set_rate(clk, CONFIG_PL011_CLOCK); |
| clk_enable(clk); |
| } |
| #endif |
| |
| int arch_cpu_init(void) |
| { |
| flush_dcache_all(); |
| cpu_soc_init(); |
| clk_init(); |
| |
| if (IS_ENABLED(CONFIG_PL011_SERIAL)) |
| serial_device_init(); |
| |
| return 0; |
| } |
| |
| #if defined(CONFIG_DISPLAY_CPUINFO) |
| int print_cpuinfo(void) |
| { |
| return 0; |
| } |
| #endif |
| |
| void reset_cpu(ulong ignored) |
| { |
| void *clkpwr_reg = (void *)PHY_BASEADDR_CLKPWR; |
| const u32 sw_rst_enb_bitpos = 3; |
| const u32 sw_rst_enb_mask = 1 << sw_rst_enb_bitpos; |
| const u32 sw_rst_bitpos = 12; |
| const u32 sw_rst_mask = 1 << sw_rst_bitpos; |
| int pwrcont = 0x224; |
| int pwrmode = 0x228; |
| u32 read_value; |
| |
| read_value = readl((void *)(clkpwr_reg + pwrcont)); |
| |
| read_value &= ~sw_rst_enb_mask; |
| read_value |= 1 << sw_rst_enb_bitpos; |
| |
| writel(read_value, (void *)(clkpwr_reg + pwrcont)); |
| writel(sw_rst_mask, (void *)(clkpwr_reg + pwrmode)); |
| } |
| |
| void enable_caches(void) |
| { |
| /* Enable D-cache. I-cache is already enabled in start.S */ |
| dcache_enable(); |
| } |
| |
| #if defined(CONFIG_ARCH_MISC_INIT) |
| int arch_misc_init(void) |
| { |
| return 0; |
| } |
| #endif /* CONFIG_ARCH_MISC_INIT */ |