| CONFIG_PPC=y |
| CONFIG_SYS_TEXT_BASE=0x11000000 |
| CONFIG_SYS_MALLOC_LEN=0x100000 |
| CONFIG_ENV_SIZE=0x4000 |
| CONFIG_ENV_OFFSET=0x100000 |
| CONFIG_DEFAULT_DEVICE_TREE="p1010rdb-pb" |
| CONFIG_SPL_TEXT_BASE=0xFF800000 |
| CONFIG_SPL_SERIAL=y |
| CONFIG_TPL_TEXT_BASE=0xD0000000 |
| CONFIG_TPL_LIBCOMMON_SUPPORT=y |
| CONFIG_TPL_LIBGENERIC_SUPPORT=y |
| CONFIG_TPL_SERIAL=y |
| CONFIG_SPL_DRIVERS_MISC=y |
| CONFIG_SPL=y |
| CONFIG_TPL_MAX_SIZE=0x20000 |
| CONFIG_MPC85xx=y |
| CONFIG_TARGET_P1010RDB_PB=y |
| CONFIG_ENABLE_36BIT_PHYS=y |
| CONFIG_SYS_MPC85XX_NO_RESETVEC=y |
| CONFIG_TPL_SYS_MPC85XX_NO_RESETVEC=y |
| CONFIG_PCIE1=y |
| CONFIG_PCIE2=y |
| CONFIG_FIT=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_OF_STDOUT_VIA_ALIAS=y |
| CONFIG_TPL_SYS_MONITOR_BASE=0xD0000000 |
| CONFIG_BOOTDELAY=10 |
| CONFIG_USE_BOOTCOMMAND=y |
| CONFIG_BOOTCOMMAND="setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate $othbootargs ramdisk_size=$ramdisk_size;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr $ramdiskaddr $fdtaddr" |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_BOARD_EARLY_INIT_R=y |
| CONFIG_ID_EEPROM=y |
| # CONFIG_SPL_FRAMEWORK is not set |
| CONFIG_SPL_MAX_SIZE=0x2000 |
| CONFIG_SPL_NAND_BOOT=y |
| CONFIG_SPL_SYS_CCSR_DO_NOT_RELOCATE=y |
| CONFIG_SPL_INIT_MINIMAL=y |
| CONFIG_SPL_FLUSH_IMAGE=y |
| CONFIG_SPL_RELOC_TEXT_BASE=0xd003d000 |
| CONFIG_SPL_RELOC_STACK=0xd003fff0 |
| CONFIG_TPL_GD_ADDR=0xd002c000 |
| CONFIG_TPL_RELOC_TEXT_BASE=0xd0000000 |
| CONFIG_TPL_RELOC_STACK=0xd0030000 |
| CONFIG_TPL_RELOC_MALLOC=y |
| CONFIG_TPL_RELOC_MALLOC_ADDR=0xd0034000 |
| CONFIG_TPL_RELOC_MALLOC_SIZE=0xc000 |
| CONFIG_SPL_NAND_SUPPORT=y |
| CONFIG_SPL_TARGET="u-boot-with-spl.bin" |
| CONFIG_TPL=y |
| CONFIG_TPL_DRIVERS_MISC=y |
| CONFIG_TPL_ENV_SUPPORT=y |
| CONFIG_TPL_I2C=y |
| CONFIG_TPL_MPC8XXX_INIT_DDR=y |
| CONFIG_TPL_NAND_SUPPORT=y |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_PBSIZE=276 |
| CONFIG_CMD_IMLS=y |
| CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3 |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_EXT2=y |
| CONFIG_CMD_FAT=y |
| CONFIG_MTDIDS_DEFAULT="nand0=ff800000.flash" |
| CONFIG_MTDPARTS_DEFAULT="mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)" |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_NAND=y |
| CONFIG_ENV_RANGE=0x80000 |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_BOOTFILE=y |
| CONFIG_BOOTFILE="uImage" |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="eTSEC1" |
| CONFIG_DM=y |
| CONFIG_FSL_SATA_V2=y |
| CONFIG_SYS_SATA_MAX_DEVICE=2 |
| CONFIG_FSL_CAAM=y |
| CONFIG_DDR_CLK_FREQ=66666666 |
| CONFIG_SYS_SPD_BUS_NUM=1 |
| CONFIG_CHIP_SELECTS_PER_CTRL=1 |
| CONFIG_SYS_DDR_RAW_TIMING=y |
| CONFIG_TPL_COMMON_INIT_DDR=y |
| CONFIG_DM_I2C=y |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_TPL_SYS_I2C_LEGACY=y |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| CONFIG_SYS_I2C_FSL=y |
| CONFIG_SYS_FSL_I2C_OFFSET=0x3000 |
| CONFIG_SYS_FSL_HAS_I2C2_OFFSET=y |
| CONFIG_SYS_FSL_I2C2_OFFSET=0x3100 |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x57 |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_NOR_FLASH=y |
| CONFIG_FLASH_CFI_DRIVER=y |
| CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y |
| CONFIG_SYS_FLASH_CFI=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_FSL_IFC=y |
| CONFIG_SYS_NAND_ONFI_DETECTION=y |
| CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y |
| CONFIG_SYS_NAND_U_BOOT_OFFS=0x20000 |
| CONFIG_DM_SPI_FLASH=y |
| CONFIG_SF_DEFAULT_SPEED=10000000 |
| CONFIG_SPI_FLASH_SPANSION=y |
| CONFIG_PHY_ATHEROS=y |
| CONFIG_PHY_BROADCOM=y |
| CONFIG_PHY_DAVICOM=y |
| CONFIG_PHY_LXT=y |
| CONFIG_PHY_MARVELL=y |
| CONFIG_PHY_NATSEMI=y |
| CONFIG_PHY_REALTEK=y |
| CONFIG_PHY_SMSC=y |
| CONFIG_PHY_VITESSE=y |
| CONFIG_DM_ETH=y |
| CONFIG_DM_MDIO=y |
| CONFIG_PHY_GIGE=y |
| CONFIG_E1000=y |
| CONFIG_MII=y |
| CONFIG_TSEC_ENET=y |
| CONFIG_PCIE_FSL=y |
| CONFIG_DM_RTC=y |
| CONFIG_SYS_NS16550=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_FSL_ESPI=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_FSL=y |