| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2013-2017 Altera Corporation <www.altera.com> |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/fpga_manager.h> |
| |
| /* |
| * Populate the value for SYSMGR.FPGAINTF.MODULE based on pinmux setting. |
| * The value is not wrote to SYSMGR.FPGAINTF.MODULE but |
| * CONFIG_SYSMGR_ISWGRP_HANDOFF. |
| */ |
| static void populate_sysmgr_fpgaintf_module(void) |
| { |
| u32 handoff_val = 0; |
| |
| /* ISWGRP_HANDOFF_FPGAINTF */ |
| writel(0, socfpga_get_sysmgr_addr() + SYSMGR_ISWGRP_HANDOFF_OFFSET(2)); |
| |
| /* Enable the signal for those HPS peripherals that use FPGA. */ |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_NAND_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_NAND; |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_RGMII1_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_EMAC1; |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_SDMMC_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SDMMC; |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_RGMII0_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_EMAC0; |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_SPIM0_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SPIM0; |
| if (readl(socfpga_get_sysmgr_addr() + SYSMGR_GEN5_SPIM1_USEFPGA) == |
| SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SPIM1; |
| |
| /* populate (not writing) the value for SYSMGR.FPGAINTF.MODULE |
| based on pinmux setting */ |
| setbits_le32(socfpga_get_sysmgr_addr() + |
| SYSMGR_ISWGRP_HANDOFF_OFFSET(2), |
| handoff_val); |
| |
| handoff_val = readl(socfpga_get_sysmgr_addr() + |
| SYSMGR_ISWGRP_HANDOFF_OFFSET(2)); |
| if (fpgamgr_test_fpga_ready()) { |
| /* Enable the required signals only */ |
| writel(handoff_val, |
| socfpga_get_sysmgr_addr() + |
| SYSMGR_GEN5_FPGAINFGRP_MODULE); |
| } |
| } |
| |
| /* |
| * Configure all the pin muxes |
| */ |
| void sysmgr_pinmux_init(void) |
| { |
| u32 regs = (u32)socfpga_get_sysmgr_addr() + SYSMGR_GEN5_EMACIO; |
| const u8 *sys_mgr_init_table; |
| unsigned int len; |
| int i; |
| |
| sysmgr_get_pinmux_table(&sys_mgr_init_table, &len); |
| |
| for (i = 0; i < len; i++) { |
| writel(sys_mgr_init_table[i], regs); |
| regs += sizeof(regs); |
| } |
| |
| populate_sysmgr_fpgaintf_module(); |
| } |
| |
| /* |
| * This bit allows the bootrom to configure the IOs after a warm reset. |
| */ |
| void sysmgr_config_warmrstcfgio(int enable) |
| { |
| if (enable) |
| setbits_le32(socfpga_get_sysmgr_addr() + |
| SYSMGR_GEN5_ROMCODEGRP_CTRL, |
| SYSMGR_ROMCODEGRP_CTRL_WARMRSTCFGIO); |
| else |
| clrbits_le32(socfpga_get_sysmgr_addr() + |
| SYSMGR_GEN5_ROMCODEGRP_CTRL, |
| SYSMGR_ROMCODEGRP_CTRL_WARMRSTCFGIO); |
| } |