| /* |
| * Copyright 2016 Freescale Semiconductor |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef __LS1012A_COMMON_H |
| #define __LS1012A_COMMON_H |
| |
| #define CONFIG_FSL_LAYERSCAPE |
| #define CONFIG_GICV2 |
| |
| #include <asm/arch/config.h> |
| #include <asm/arch/stream_id_lsch2.h> |
| |
| #define CONFIG_SUPPORT_RAW_INITRD |
| |
| #define CONFIG_DISPLAY_BOARDINFO_LATE |
| |
| #define CONFIG_SYS_TEXT_BASE 0x40100000 |
| |
| #define CONFIG_SYS_CLK_FREQ 125000000 |
| |
| #define CONFIG_SKIP_LOWLEVEL_INIT |
| |
| #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0) |
| #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000) |
| |
| #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000 |
| #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 |
| #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE |
| #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL |
| |
| /* Generic Timer Definitions */ |
| #define COUNTER_FREQUENCY CONFIG_SYS_CLK_FREQ/4 /* 25MHz */ |
| |
| /* CSU */ |
| #define CONFIG_LAYERSCAPE_NS_ACCESS |
| |
| /* Size of malloc() pool */ |
| #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024) |
| |
| /*SPI device */ |
| #ifdef CONFIG_QSPI_BOOT |
| #define CONFIG_SYS_QE_FW_IN_SPIFLASH |
| #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000 |
| #define CONFIG_ENV_SPI_BUS 0 |
| #define CONFIG_ENV_SPI_CS 0 |
| #define CONFIG_ENV_SPI_MAX_HZ 1000000 |
| #define CONFIG_ENV_SPI_MODE 0x03 |
| #define CONFIG_SPI_FLASH_SPANSION |
| #define CONFIG_FSL_SPI_INTERFACE |
| #define CONFIG_SF_DATAFLASH |
| |
| #define CONFIG_FSL_QSPI |
| #define QSPI0_AMBA_BASE 0x40000000 |
| #define CONFIG_SPI_FLASH_SPANSION |
| |
| #define FSL_QSPI_FLASH_SIZE SZ_64M |
| #define FSL_QSPI_FLASH_NUM 2 |
| |
| /* |
| * Environment |
| */ |
| #define CONFIG_ENV_OVERWRITE |
| |
| #define CONFIG_ENV_SIZE 0x40000 /* 256KB */ |
| #define CONFIG_ENV_OFFSET 0x200000 /* 2MB */ |
| #define CONFIG_ENV_SECT_SIZE 0x40000 |
| #endif |
| |
| /* I2C */ |
| #define CONFIG_SYS_I2C |
| #define CONFIG_SYS_I2C_MXC |
| #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */ |
| #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */ |
| |
| #define CONFIG_CONS_INDEX 1 |
| #define CONFIG_SYS_NS16550_SERIAL |
| #define CONFIG_SYS_NS16550_REG_SIZE 1 |
| #define CONFIG_SYS_NS16550_CLK (get_serial_clock()) |
| |
| #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } |
| |
| #define CONFIG_SYS_HZ 1000 |
| |
| #define CONFIG_HWCONFIG |
| #define HWCONFIG_BUFFER_SIZE 128 |
| |
| /* Initial environment variables */ |
| #define CONFIG_EXTRA_ENV_SETTINGS \ |
| "verify=no\0" \ |
| "loadaddr=0x80100000\0" \ |
| "kernel_addr=0x100000\0" \ |
| "fdt_high=0xffffffffffffffff\0" \ |
| "initrd_high=0xffffffffffffffff\0" \ |
| "kernel_start=0xa00000\0" \ |
| "kernel_load=0xa0000000\0" \ |
| "kernel_size=0x2800000\0" \ |
| |
| #define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\ |
| "$kernel_start $kernel_size && "\ |
| "bootm $kernel_load" |
| |
| /* Monitor Command Prompt */ |
| #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */ |
| #define CONFIG_SYS_LONGHELP |
| #define CONFIG_CMDLINE_EDITING 1 |
| #define CONFIG_AUTO_COMPLETE |
| #define CONFIG_SYS_MAXARGS 64 /* max command args */ |
| |
| #define CONFIG_PANIC_HANG |
| #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */ |
| |
| #include <asm/arch/soc.h> |
| |
| #endif /* __LS1012A_COMMON_H */ |