/* SPDX-License-Identifier: GPL-2.0 */
/*
 * Author(s):
 * laj
 *
 * Distributed by:
 * Silicon Laboratories, Inc
 *
 * This file contains proprietary information.
 * No dissemination allowed without prior written permission from
 * Silicon Laboratories, Inc.
 *
 */

#ifndef SI3050REGS_H
#define SI3050REGS_H


enum REGISTERS
{
  CTRL1               =  1, /*  Control    */
  CTRL2               =  2, /*  Control  */
  INTE_MSK            =  3, /*  Interrupt Mask  */
  INTE_SRC            =  4, /*  Interrupt Source  */
  DAA_CTRL1           =  5, /*  DAA Control 1   */
  DAA_CTRL2           =  6, /*  DAA Control 2   */
  SMPL_CTRL           =  7, /*  Sample Rate Control  */
  RESVD8              =  8, /*  Reserved  */
  RESVD9              =  9, /*  Reserved  */
  DAA_CTRL3           =  10, /*  DAA Control 3  */
  SYS_LINE_DEV_REV    =  11, /*  System- and Line-Side Device Revision  */
  LSIDE_STAT          =  12, /*  Line-Side Device Status   */
  LSIDE_REV           =  13, /*  Line-Side Device Revision   */
  DAA_CTRL4           =  14, /*  DAA Control 4 RPOL  */
  TXRX_GN_CTRL        =  15, /*  TX/RX Gain Control 1  */
  INTL_CTRL1          =  16, /*  International Control 1   */
  INTL_CTRL2          =  17, /*  International Control 2   */
  INTL_CTRL3          =  18, /*  International Control 3   */
  INTL_CTRL4          =  19, /*  International Control 4   */
  RXCALL_PROG_ATTEN   =  20, /*  Call Progress RX Attenuation  */
  TXCALL_PROG_ATTEN   =  21, /*  Call Progress TX Attenuation   */
  RNG_VLD_CTRL1       =  22, /*  Ring Validation Control 1   */
  RNG_VLD_CTRL2       =  23, /*  Ring Validation Control 2   */
  RNG_VLD_CTRL3       =  24, /*  ing Validation Control 3   */
  RES_CALIB           =  25, /*  Resistor Calibration   */
  DC_TERM_CTRL        =  26, /*  DC Termination Control   */
  RESVD27             =  27, /*  Reserved  */
  LP_CRNT_STAT        =  28, /*  Loop Current Status  */
  LINE_VOLT_STAT      =  29, /*  Line Voltage Status   */
  AC_TERM_CTRL        =  30, /*  AC Termination Control   */
  DAA_CTRL5           =  31, /*  DAA Control 5   */
  GND_STRT_CTRL       =  32, /*  Ground Start Control  */
  PCM_SPI_CTRL        =  33, /*  PCM/SPI Mode Select   */
  PCMTX_CNT_LO        =  34, /*  PCM Transmit Start Count - Low Byte  */
  PCMTX_CNT_HI        =  35, /*  PCM Transmit Start Count - High Byte   */
  PCMRX_CNT_LO        =  36, /*  PCM Receive Start Count - Low Byte   */
  PCMRX_CNT_HI        =  37, /*  PCM Receive Start Count - High Byte   */
  TX_GN_CTRL2         =  38, /*  TX Gain Control 2   */
  RX_GN_CTRL2         =  39, /*  RX Gain Control 2   */
  TX_GN_CTRL3         =  40, /*  TX Gain Control 3   */
  RX_GN_CTRL3         =  41, /*  RX Gain Control 3   */
  GCI_CTRL            =  42, /*  GCI Control   */
  LN_VI_THRESH_INTE   =  43, /*  Line Current/Voltage Threshold Interrupt  */
  LN_VI_THRESH_INTE_CTRL=44, /*  Line Current/Voltage Threshold Interrupt Control  */
  HYB1                =  45, /*  Programmable Hybrid Register 1  */
  HYB2                =  46, /*  Programmable Hybrid Register 2  */
  HYB3                =  47, /*  Programmable Hybrid Register 3  */
  HYB4                =  48, /*  Programmable Hybrid Register 4  */
  HYB5                =  49, /*  Programmable Hybrid Register 5  */
  HYB6                =  50, /*  Programmable Hybrid Register 6  */
  HYB7                =  51, /*  Programmable Hybrid Register 7  */
  HYB8                =  52, /*  Programmable Hybrid Register 8  */
  RESVD53             =  53, /*  Reserved 53  */
  RESVD54             =  54, /*  Reserved 54  */
  RESVD55             =  55, /*  Reserved 55  */
  RESVD56             =  56, /*  Reserved 56  */
  RESVD57             =  57, /*  Reserved 57  */
  RESVD58             =  58, /*  Reserved 58  */
  SPRK_QNCH_CTRL      =  59    /*  Spark Quenching Control  */

};

#endif