blob: 8c2f287b1ac4c8ddde16122fe39bf51d7d574a07 [file] [log] [blame]
From 57bb66bcdcbf591f14627988603e52cae8465633 Mon Sep 17 00:00:00 2001
From: StanleyYP Wang <StanleyYP.Wang@mediatek.com>
Date: Wed, 17 May 2023 17:34:55 +0800
Subject: [PATCH 4/8] wifi: mt76: mt7915: fix DFS CAC tx emission issue after
interface down up
FW's channel state is set during the first wifi interface setup. If the switch reason for
setting the tx/rx path during second-time wifi interface setup is CH_SWITCH_NORMAL,
then the FW would perform runtime dpd channel calibration during DFS CAC, which leads to
tx emission. Therefore, in order to bypass tx calibration during DFS CAC, set the switch reason
to CH_SWITCH_DFS whenever chandef is set to DFS channel.
Signed-off-by: StanleyYP Wang <StanleyYP.Wang@mediatek.com>
---
mt7915/mcu.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/mt7915/mcu.c b/mt7915/mcu.c
index e53d83b..bed4bdc 100644
--- a/mt7915/mcu.c
+++ b/mt7915/mcu.c
@@ -2735,12 +2735,12 @@ int mt7915_mcu_set_chan_info(struct mt7915_phy *phy, int cmd)
if (mt76_connac_spe_idx(phy->mt76->antenna_mask))
req.tx_path_num = fls(phy->mt76->antenna_mask);
- if (cmd == MCU_EXT_CMD(SET_RX_PATH) ||
- dev->mt76.hw->conf.flags & IEEE80211_CONF_MONITOR)
+ if (dev->mt76.hw->conf.flags & IEEE80211_CONF_MONITOR)
req.switch_reason = CH_SWITCH_NORMAL;
else if (phy->mt76->hw->conf.flags & IEEE80211_CONF_OFFCHANNEL)
req.switch_reason = CH_SWITCH_SCAN_BYPASS_DPD;
- else if (!cfg80211_reg_can_beacon(phy->mt76->hw->wiphy, chandef,
+ else if (cfg80211_chandef_valid(chandef) &&
+ !cfg80211_reg_can_beacon(phy->mt76->hw->wiphy, chandef,
NL80211_IFTYPE_AP))
req.switch_reason = CH_SWITCH_DFS;
else
--
2.18.0