BUG/MEDIUM: mux-h1: do not refrain from signaling errors after end of input
In 2.6-dev4, a fix for truncated response was brought with commit 99bbdbcc2
("BUG/MEDIUM: mux-h1: only turn CO_FL_ERROR to CS_FL_ERROR with empty ibuf"),
trying to address the situation where an error is present at the connection
level but some data are still pending to be read by the stream. However,
this patch did not consider the case where the stream was no longer willing
to read the pending data, resulting in a situation where some aborted
transfers could lead to excessive CPU usage by causing constant stream
wakeups for which no error was reported. This perfectly matches what was
observed and reported in github issue #1842. It's not trivial to reproduce,
but aborting HTTP/1 pipelining in the middle of transfers seems to give
good results (using h2load and Ctrl-C in the middle).
The fix was incorrct as the error should be held only if there were data
that the stream was able to read. This is the approach taken by this patch,
which also checks via SE_FL_EOI | SE_FL_EOS that the stream will be able
to consume the pending data.
Note that the loop was provoked by the attempt by sc_conn_io_cb() itself
to call sc_conn_send() which resulted in a write subscription in
h1_subscribe() which immediately calls a tasklet_wakeup() since the
event is ready, and that it is now stopped by the presence of SE_FL_ERROR
that is checked in sc_conn_io_cb(). It seems that an extra check down the
send() path to refrain from subscribing when the connection is in error
could speed up error detection or at least avoid a risk of loops in this
case, but this is tricky. In addition, there's already SE_FL_ERR_PENDING
that seems more suitable for reporting when there are pending data, but
similarly, it probably isn't checked well enough to be suitable for
backports.
FWIW the issue may (unreliably) be reproduced by chaining haproxy to
httpterm and issuing:
(printf "GET /?s=10g HTTP/1.1\r\n\r\n"; sleep 0.1; printf "\r\n") | \
nc6 --half-close 0 8001 | head -c1000000000 >/dev/null
It's necessary to play with the size of the head command that's supposed
to trigger the error at some point. A variant involving h2load in h1 mode
and multiple pipelined streams, that is stopped with Ctrl-C also tends to
work.
As the fix above was backported as far as 2.0, it would be tempting to
backport this one as far. However tests have shown that the oldest
version that can trigger this issue is 2.5, maybe due to subtle
differences in older ones, so it's probably not worth going further
until an issue is reported. Note that in 2.5 and older, the SE_FL_*
flags are applied on the conn_stream instead, as CS_FL_*.
Special thanks go to Felipe W Damasio for providing lots of detailed data
allowing to quickly spot the root cause of the problem.
1 file changed