cmd: Add ncsi command
Adds an "ncsi" command to manually start NC-SI configuration.
Signed-off-by: Samuel Mendoza-Jonas <sam@mendozajonas.com>
Signed-off-by: Joel Stanley <joel@jms.id.au>
Reviewed-by: Cédric Le Goater <clg@kaod.org>
diff --git a/cmd/Kconfig b/cmd/Kconfig
index 16030e3..41cf1d4 100644
--- a/cmd/Kconfig
+++ b/cmd/Kconfig
@@ -1842,6 +1842,14 @@
help
Acquire a network IP address using the link-local protocol
+config CMD_NCSI
+ bool "ncsi"
+ depends on PHY_NCSI
+ help
+ Manually configure the attached NIC via NC-SI.
+ Normally this happens automatically before other network
+ operations.
+
endif
config CMD_ETHSW
diff --git a/cmd/net.c b/cmd/net.c
index 46f8c87..addcad3 100644
--- a/cmd/net.c
+++ b/cmd/net.c
@@ -16,6 +16,7 @@
#include <net.h>
#include <net/udp.h>
#include <net/sntp.h>
+#include <net/ncsi.h>
static int netboot_common(enum proto_t, struct cmd_tbl *, int, char * const []);
@@ -566,3 +567,24 @@
"list - list available devices\n"
);
#endif // CONFIG_DM_ETH
+
+#if defined(CONFIG_CMD_NCSI)
+static int do_ncsi(struct cmd_tbl *cmdtp, int flag, int argc, char * const argv[])
+{
+ if (!phy_interface_is_ncsi() || !ncsi_active()) {
+ printf("Device not configured for NC-SI\n");
+ return CMD_RET_FAILURE;
+ }
+
+ if (net_loop(NCSI) < 0)
+ return CMD_RET_FAILURE;
+
+ return CMD_RET_SUCCESS;
+}
+
+U_BOOT_CMD(
+ ncsi, 1, 1, do_ncsi,
+ "Configure attached NIC via NC-SI",
+ ""
+);
+#endif /* CONFIG_CMD_NCSI */