rockchip: rk3399: Include uart related pinctrl nodes in TPL/SPL
The initial serial console UART iomux is typically configured in
board_debug_uart_init() at TPL stage on Rockchip platform.
Later stages typically use pinctrl driver to configure iomux UART once
again based on the control FDT.
Include uart related pinctrl nodes in TPL/SPL control FDT to make it
possible for pinctrl driver to configure UART iomux at TPL/SPL stage.
Following debug log message may also be seen at U-Boot pre-reloc stage:
ns16550_serial serial@ff1a0000: pinctrl_select_state_full: uclass_get_device_by_phandle_id: err=-19
This can be resolved by including bootph prop for U-Bood pre-reloc
phase (bootph-some-ram or bootph-all). However, this has intentionally
been excluded due to including it unnecessarily slows down boot around
200-400 ms.
Also add the clock-frequency prop similar to what has been done for
other Rockchip SoCs.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/arch/arm/dts/rk3399-u-boot.dtsi b/arch/arm/dts/rk3399-u-boot.dtsi
index 9815dc5..b39fe39 100644
--- a/arch/arm/dts/rk3399-u-boot.dtsi
+++ b/arch/arm/dts/rk3399-u-boot.dtsi
@@ -136,6 +136,12 @@
&uart2 {
bootph-all;
+ clock-frequency = <24000000>;
+};
+
+&uart2c_xfer {
+ bootph-pre-sram;
+ bootph-pre-ram;
};
&vopb {