misc: add Qualcomm GENI SE QUP device driver
This change adds a Qualcomm GENI SE QUP device driver as a wrapper for
actually enabled and used serial devices found on a board.
At the moment the driver is pretty simple, its intention is to populate
childred devices and provide I/O mem read interface to them as clients,
this is needed for GENI UART driver to set up a proper clock divider
and provide the actually asked baud rate.
Signed-off-by: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
diff --git a/drivers/misc/Makefile b/drivers/misc/Makefile
index 3b792f2..52aed09 100644
--- a/drivers/misc/Makefile
+++ b/drivers/misc/Makefile
@@ -60,6 +60,7 @@
obj-$(CONFIG_P2SB) += p2sb-uclass.o
obj-$(CONFIG_PCA9551_LED) += pca9551_led.o
obj-$(CONFIG_$(SPL_)PWRSEQ) += pwrseq-uclass.o
+obj-$(CONFIG_QCOM_GENI_SE) += qcom-geni-se.o
ifdef CONFIG_QFW
obj-y += qfw.o
obj-$(CONFIG_QFW_PIO) += qfw_pio.o